Captret - Perpetual Light with Dead Batteries

[mrbr00k5]

Need Circuit help.

This is a Fast Self Charger, Tried, Proven!. Free Energy.

Materials Needed.

4 electrolytic capacitors 250v 2200 uf
1 dead 9 volt battery. Deplete to 5v or less as ibpointless2 had said.

Strip off film covers on capacitors, bundle together and secure tightly. Wire in series.

Attach Positive of battery to positive terminal of capacitor bank.

Attach Negative of battery to right in the center of the four caps, ensure good connection.

Connect negative terminal of capacitors to anywhere on the casing, bare aluminum exterior, clamp tight.

Thats it.

This circuit shows single captret.

Hi electricity, thanks for the schematic of your charging circuit, but how do I connect everything if I'm using more than one capacitor? Like you recommended four caps to charge the battery quicker, how do I connect them? A diagram would be much appreciated. Thanks.

[electricity]

electricity, can you do a more rigorous test on your 9V battery. Charge it conventionally, discharge it through a known load. Charge it with the captret and discharge it to a known load. It might take a while but if possible you can write down voltage every hour or so. I like to do this test myself but currently lack 9 volt rechargeable batteries.

Using Alkaline throw aways.

may be rave or someone else can do control test.

I got tons of work waiting, I better get off.

I'll try and video /document the next charge.

Thanks all. Had tons of fun, even with PTB, too bad aren't around. Guess I'll try my luck next time.

[broli]

electricity, can you do a more rigorous test on your 9V battery. Charge it conventionally, discharge it through a known load. Charge it with the captret and discharge it to a known load. It might take a while but if possible you can write down voltage every hour or so. I like to do this test myself but currently lack 9 volt rechargeable batteries.

[electricity]

Hi,

i got a variety of caps ranging from 470uF to 1,000uF, all rated to 200V from old PC power supplys from the recycling yard

i also have twelve 15,000uF caps @ 35V...wondering what i can do with those

@ electricity, can you tell us what your starting voltage on your battery was...and what its at now?

Thanks

Have already started draining the captret battery. I will drain it down to 5v and let rest for 24 hr before recharging.

I started at 5.8 last charge, took less than 4 hours with 4 x 250v 2200 uf.

I speculate it's the capacity, so hook up a bank and try. We're all still learning.

[electricity]

Aether is what it is

All is not static, disruption manifest so called electron.

Aether is balanced, when you rub cotton, you disrupt the Aether field and manifest electrons as they say.

Aether is the origin of our energy.

Too vast and complicated for me to dissect into layman's term @ this time.

[Jbignes5]

Not what is taught...

@ Jbignes5,
That's what you're taught.

But capacitor also taps dielectric. It's pretty much a single wire coil.

Wound one up and tap both conductor and dielectric. Immerse in fluid.

Let me know of your finding. I learn only from old Journals prior to 1900, so my terms will be considered mambo jumbo, however I understand perfectly well what is happening. I did get a start on Basic Electronic learning the Basics, but as Eric had said, keep your thoughts pure and avoid the Mind Virus.

I have learned a lot from him, his writings is every where, some of the better ones are hard to find, I wonder why they are buried so deep.

I have nothing against your installed authorities but what they say do not make sense to me. I find their Energy from the Vacuum series giberrish.

Heck, Tesla only learned from those same materials, yet no one has yet exceeded or even come close to his abilities. That is why I care not for the speculations.

Ever heard of static laws? I think this is dealing with those laws for which we have very limited knowledge of. We never took the time to investigate this part of nature. It is this part that can move mountains with just a charge of potential and not current. It is what I suspect actually governs all bodies in our space and hence why we can never figure out anything because we look at books about electricity.

Electricity is an invention it is not what governs all of nature yet we think we may apply all the rules of electricity to all of nature and expect it to turn out right... Most of which does not even come close.

By the way your version does not produce a charge higher then what my weak batteries started with. It is not even charging.

[rave154]

Hi,

i got a variety of caps ranging from 470uF to 1,000uF, all rated to 200V from old PC power supplys from the recycling yard

i also have twelve 15,000uF caps @ 35V...wondering what i can do with those

@ electricity, can you tell us what your starting voltage on your battery was...and what its at now?

Thanks

[electricity]

Large Caps

good job so far.

Where do you get those 250v 2200 uf caps at? the cheapest ones i can find at mouser.com are $17 just for one.

Find a free old flat screen projection tv, 60" ones has 3000 microfarad caps.

Why not order a case from Alibaba China and resell cheap to others?.

You probably could land them for under $5.

Or better make them, that's what I do most time. Tinkering is making real electrical components, not buying close looped electronic junks. It's fun too. Glass blowing is fun, make all kinds of Tesla tubes and lights.

Everyone is over specialized and needs to learn the nature of tinkering. That's what Moray, Bedini and everone else did right?. Make their own stuff.

[electricity]

Classical Myth

@ Jbignes5,
That's what you're taught.

But capacitor also taps dielectric. It's pretty much a single wire coil.

Wound one up and tap both conductor and dielectric. Immerse in fluid.

Let me know of your finding. I learn only from old Journals prior to 1900, so my terms will be considered mambo jumbo, however I understand perfectly well what is happening. I did get a start on Basic Electronic learning the Basics, but as Eric had said, keep your thoughts pure and avoid the Mind Virus.

I have learned a lot from him, his writings is every where, some of the better ones are hard to find, I wonder why they are buried so deep.

I have nothing against your installed authorities but what they say do not make sense to me. I find their Energy from the Vacuum series giberrish.

Heck, Tesla only learned from those same materials, yet no one has yet exceeded or even come close to his abilities. That is why I care not for the speculations.

[Jbignes5]

Lets think this out.

Capacitors do not pass current if they did it would be considered leakage. What they do store is pure voltage. The potential from one side when compared to the other is what determines it's charge. This is a surface charge on the plates and when it gathers in density the "charge" goes up on the plates. This is the effect we are seeing here. pure potential and the ability to shift the potential from plate to plate through this effect. One plate loosing some potential affects the other. The hull of the cap allows us to keep the potential at one constant. When compared to either plate this constant will never change so the hull = a certain amount of potential based on voltage(variable) of the circuit and mass, surface area of the hull being a constant when compared to the two plates inside of the hull.

This is induction and induction only. With the condition of these batteries they would discharge very very easily if there was a real current being used.

I have measured voltage only between the plate + which is at battery positive and held by the virtual diode effect between hull and positive plate. I have measured the plate - which is induced from the positive and held in another virtual diode from the neg plate to the hull. Since the caps that we are using are polarized this is partly where we get the virtual diodes from.

If we now hook a led between the two plates we have a potential difference like we have seen in the Tesla switch. As with the Tesla switch we know we can use a device with two like polarities but having a difference in potential.

When we hook the led up it causes a real flow between the diode halves. This is where we are getting the light from for free. If indeed the battery was putting out a current flow it would never recover as this flow is moving, for which the battery would go down in voltage. So have we used anything from the battery I would say not. The only thing we did use was the potential difference between the real plates of the cap. This is evident by the led putting out more light when you add more caps in parallel strengthening the potential difference of the plates.

I have not figured out how to get this thing to back wash into the battery yet. I doubt I will be able to do that at all but we could always add a cheap-o solar cell so that the battery can maintain it's potential better during the day. I also have not figured out how to add the voltage from the difference back to the battery which would be in fact a charging effect when added to the batteries potential (a+b=c). a being the starting voltage from the battery positive, b being the 3-6v of the induced voltage onto plate -, with c being the total of a+b... Somehow I don't think we will be able to do that.

I have tried to replicate the second circuit that IBpointless has presented but I can not get it to work. The original circuit works fine and to boot it does not affect the voltage of the battery in a long term effect. Long term being 2-3 days, which should have drained the batteries that are in such poor charge state.

Deny it all you want but the original circuit works as stated and you get free light out of it.

I like how all the nay sayers have not even tried to replicate this effect yet they say this is what is happening..

[ibpointless2]

This is a Fast Self Charger, Tried, Proven!. Free Energy.

Materials Needed.

4 electrolytic capacitors 250v 2200 uf
1 dead 9 volt battery. Deplete to 5v or less as ibpointless2 had said.

Strip off film covers on capacitors, bundle together and secure tightly. Wire in series.

Attach Positive of battery to positive terminal of capacitor bank.

Attach Negative of battery to right in the center of the four caps, ensure good connection.

Connect negative terminal of capacitors to anywhere on the casing, bare aluminum exterior, clamp tight.

Thats it.

This circuit shows single captret.

good job so far.

Where do you get those 250v 2200 uf caps at? the cheapest ones i can find at mouser.com are $17 just for one.

[electricity]

The double cap captret is now up to 17.23 volts, LED is as bright as yesterday's.

Find it weird that it does what it does.

Electricity i will try to replicate it, but i don't have any caps like that. I have super caps at 10 farad at 2.3 volts. Maybe i could rob pieces off of a power supply or something.

People can believe what they want to believe, i'm seeing what i'm seeing and it is as simple as the batteries are charging them selves. I'm not making this stuff up, i have no gain to get from this. If i was making this stuff up then i would have never given the circuits out to everyone. You can build what i'm seeing and when you do then you'll understand. if not then believe what you want to and leave me alone.

as for everyone else, thank you for your time.

I get most of my stuff from Taobao, China mega auction house. Price is 10% of US, shipping is $25 US per 2 kilo gram.

Look for those old large flat projection TV, they use these. Call the Electronic Recycling center a call, Rent A Center were throwing them away last year. I stripped of the board of 6 TVs, but I also bought some from bigger caps from China dirt cheap. You must try Copper Foil Captret. Buy foil from Cheap, Huge Toroid etc.

[electricity]

FREE ENERGY Self Charging Captret

This is a Fast Self Charger, Tried, Proven!. Free Energy.

Materials Needed.

4 electrolytic capacitors 250v 2200 uf
1 dead 9 volt battery. Deplete to 5v or less as ibpointless2 had said.

Strip off film covers on capacitors, bundle together and secure tightly. Wire in series.

Attach Positive of battery to positive terminal of capacitor bank.

Attach Negative of battery to right in the center of the four caps, ensure good connection.

Connect negative terminal of capacitors to anywhere on the casing, bare aluminum exterior, clamp tight.

Thats it.

This circuit shows single captret.

[ibpointless2]

The double cap captret is now up to 17.23 volts, LED is as bright as yesterday's.

Find it weird that it does what it does.

Electricity i will try to replicate it, but i don't have any caps like that. I have super caps at 10 farad at 2.3 volts. Maybe i could rob pieces off of a power supply or something.

People can believe what they want to believe, i'm seeing what i'm seeing and it is as simple as the batteries are charging them selves. I'm not making this stuff up, i have no gain to get from this. If i was making this stuff up then i would have never given the circuits out to everyone. You can build what i'm seeing and when you do then you'll understand. if not then believe what you want to and leave me alone.

as for everyone else, thank you for your time.

[jibbguy]

Congrats on a very interesting Thread & subject.

Most folks here do like the thread and discussion i believe... and that's about as good as you can ask for at a public place like this, lol

It would seem clear to me that one obvious possibility for this Effect is that the exposed conductive shell of the electrolytic cap is acting as an "antenna"... and this is somehow causing an inductive effect within the cap. One sure way to test if the 50/60 Hz Mains radiated EMI is what's acting on it; is to simply pull the breakers on the house's mains... And see if the effect persists. Unless you happen to be living under High Voltage transmissions lines, that should tell you one way or the other.

Even should this "antenna" thingie prove to be the case, it is still highly interesting and could have some great possibilities in the future.

And Moray's work, that was NEVER debunked (and the US government even tacitly agreed it was valid by sending him an assistant).... showed beyond doubt that there are useful energy sources in the Cosmos that can be tapped with an "antenna" besides AC mains.