Announcement

Collapse
No announcement yet.

Imhotep's Radiant Oscillator Video

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • nat1971a
    replied
    oh about the solitons.....my opinion is that they are longitudal waves.....have a look at meyl book scalar waves....i dont have it handy so i cant post the page number....it quite clearly shows it in one of his drawing

    Leave a comment:


  • nat1971a
    replied
    i too feel like we are being guided......i was compelled to do braindumps on to this forum...otherwise i couldnt get any sleep...

    i agree i think the main focus is to master aether. We master that we master antigravity.....but in doing so we need to release the info on this forum so that it can never be buried or lost again....its almost 2009 and i dont see free energy anywhere...and i dont think anyone will be alllowed to make money from it....theres too many powerful interest groups that will block it at every corner.....release it to the public....then it cant be stopped or blocked

    Leave a comment:


  • Vortex
    replied
    All observable effects are important without a detector available.

    Oh Bodkins 41.AVI reveals sound has gone away when a cap is collecting?
    Does this mean the sound is due to pressure or something like that ..
    if given a place to hide out it stops making sound?
    Was it just a fluke or does disconnecting the cap make the sound return?
    Or does connecting a cap change the sound or does NOT change the sound
    Both are another puzzle piece / clue and both could occur.

    In Bodkins 42.AVI you Tuned it but the sound came back?
    Does the whine sound indicate unused / untapped energy?

    In Bodkins 43.AVI you say "I took the meter off .. proper bang!"
    Yes, I saw a video, don't remember which one and I don't think it was on
    this thread, showing that the volt meter WILL drain the cap, a LOT,
    down to a level but not down to zero... it levels out.
    At least that is what the video showed.

    Leave a comment:


  • boguslaw
    replied
    Originally posted by Aromaz View Post
    Damn! I wish I had this 'Secrets of the Cold war' manuscript earlier!
    If you have it, refer to Page 30 last paragraph and upper half of Page 40.

    "......Thomson made for the door and was abruptly stopped. Touching the brass knob on the otherwise insulated oak door, Thompson received an unexpected sizzling shock....... the two gentlemen ran throughout the huge stone, oak and iron building with insulated metal objects.......however distant from the coil or insulated from the floor, produced long continues white sparks...."

    Page 40....."This is the departure point in which Tesla abandons research and devellopment of HF AC. Divorcing himself of that field entirely......could be so continuesly produced from a single wire......Tesla began to relize the true nature of the fine issuing "gas" which projected from wire ends immersed in oil...

    He now prepared..... copper plates.....

    Strange that it seems I have unknowlingly gone through the same set of sequence and experiences. Funny thing is yesterday I bought a number of additional copper and aluminium sheets for 'possible future experiments' though not yet decided what to do exactly. I was also trying in vain to get transformer oil.....

    I wonder........ Who? What? is leading us?
    Aromaz,

    that's all true but if you look at tesla lectures radiant effects are there also with AC current, and your experiments may prove it.If you have stationary longitudinal waves on output of your coil then there should be nodes there.It's so easy to check it.Like in gotoluc video - sliding a neon on bare wire connected to coil output (and placed not on table but in air on supportive wood or other insulator support) would show a bright and dark spots of light.
    Last edited by boguslaw; 12-11-2008, 09:01 PM.

    Leave a comment:


  • broli
    replied
    No you're absolutely right stringguy. The main focus should stay trying to extract energy from the Aether. The sooner that gets the done the sooner everybody's wildest dreams gets fulfilled here. Something as trivial as hho production would be obsolete then. So I should apologize instead.

    Leave a comment:


  • broli
    replied
    Has anyone tried water at the high voltage terminal. You guys might have already found a hho producing system without realizing it .

    Leave a comment:


  • Aaron
    replied
    357116hz

    Originally posted by gotoluc View Post
    the frequency is 357Khz
    Hi Luc,

    Nice job! Are you able to adjust the frequency super specific?
    If you can do it at 357116hz then you will have a multiple a universal healing frequency.

    Leave a comment:


  • Bodkins
    replied
    sorry everone here they are ENJOY

    YouTube - Bodkins 40.AVI

    YouTube - Bodkins 41.AVI

    YouTube - Bodkins 42.AVI

    YouTube - Bodkins 43.AVI

    Leave a comment:


  • Bodkins
    replied
    Originally posted by Vortex View Post
    Ok LOOKING-GOOD ..!!CAPS!!
    I was able to view video 40 and 43 but not 41 and 42
    41 and 42 seem to be missing or is it just me?
    Uploading again

    Leave a comment:


  • Aromaz
    replied
    YouTube - Aromaz 024 - Test on Farm and Ground Earth.MP4

    .
    Last edited by Aromaz; 12-12-2008, 10:13 AM.

    Leave a comment:


  • Inquorate
    replied
    Sound on my video.

    Dammit. Well, to begin, the ignition coil and salt water capacitor and electromagnet and glass eyedropper spark gap tube and cfl are all 'glued' with one of those arts and graft hot glue guns, to a piece of (maybe treated?) pine wood. That wood is sitting on the table you see, which is thin veneer of probably pine, and chip-wood.

    The system would be on but not jumping the spark gap, and I could put my hand 5 cm from setup and hertz measured from (unconnected, due to spark not jumping) ground would lower, but spark started jumping and cfl would light up... When I held hand 30cm away just above wood of workbench, no change. When touched wood of bench, sparks started jumping. I noticed this yesterday but didn't really twig that wood was amplifying / channeling my aetheric disturbance ? further from me?

    More study must be done... Try holding long metal pipe -insulated - and touching far end to various places, versus wooden pole versus plastic pipe.

    After that, I connected Alfoil side of saltwater capacitor to 3rd ground over spark gap. While sparking, the ground from cfl frequency is what you saw. On good connection, coil hummed but cfl and first spark gap died. what I said that you couldn't hear issue that I will set up a proper magnetically quenched spark gap from there to 2nd cfl to ground and see what happens.

    @Aromaz, don't know who or what or how we're being 'guided' to do stuff, but I say if it probably won't kill you, follow the urge, no matter how nonsensical it seems. We all should. For example, I want to put a coil before my spark and after my saltwater cap. Dunno why. But now I will.

    :-)

    Leave a comment:


  • Aromaz
    replied
    Sparks everywhere~!

    Damn! I wish I had this 'Secrets of the Cold war' manuscript earlier!
    If you have it, refer to Page 30 last paragraph and upper half of Page 40.

    "......Thomson made for the door and was abruptly stopped. Touching the brass knob on the otherwise insulated oak door, Thompson received an unexpected sizzling shock....... the two gentlemen ran throughout the huge stone, oak and iron building with insulated metal objects.......however distant from the coil or insulated from the floor, produced long continues white sparks...."

    Page 40....."This is the departure point in which Tesla abandons research and devellopment of HF AC. Divorcing himself of that field entirely......could be so continuesly produced from a single wire......Tesla began to relize the true nature of the fine issuing "gas" which projected from wire ends immersed in oil...

    He now prepared..... copper plates.....

    Strange that it seems I have unknowlingly gone through the same set of sequence and experiences. Funny thing is yesterday I bought a number of additional copper and aluminium sheets for 'possible future experiments' though not yet decided what to do exactly. I was also trying in vain to get transformer oil.....

    I wonder........ Who? What? is leading us?

    Leave a comment:


  • Vortex
    replied
    What's Happening

    Originally posted by Inquorate View Post
    Wood seems to amplify the 'not capacitance effect'...

    YouTube - Inquorate 16 salt water cap
    Right after about 5:14 into your video the sound goes dead.
    Is that Just ME again having personal problems or is the sound
    missing for that part of the video?
    The camera goes jerky all over and the meter is racing up and down
    and I'm thinking Dang what's going on, talk to me tell me what's happening.

    How's your X-Ray detection badge holding up there Inquorate?

    The WOOD? please explain ..
    I saw you touch the table and the light lit up. Did it not light up with your
    hand as close but not touching the table? And your circuit is wood based and
    the table is wood also?
    That's the greatest distance "effect" seen so far which was not part of
    the circuit I think or am I mistaken?
    Last edited by Vortex; 12-11-2008, 10:45 AM.

    Leave a comment:


  • Inquorate
    replied
    Bodkins vids

    At moment they say 'not available' to me. still processing?

    Leave a comment:


  • Aromaz
    replied
    Vacuum Valves

    @Braden; Indeed I did. I have two postings here. One very...long time ago and the other on Page 52 Posting #1532. time goes so fast, feels like yesterday. Took me a while of searching to find that!

    I have now 8 different types but can not seems to get similar results.

    Leave a comment:

Working...
X