Imhotep's Radiant Oscillator Video

[Aromaz]

Answers to Aaron

Hi Aromaz,

Have you charged a cap by putting it in place of the cfl?
I did, see my posting # 1296. And tried later again few options, can not understand why, but soonest a cap or diode goes in, system terminates.

Is there a difference in brightness if you have the cfl on the + side of the coil? There are applications where switching on the positive on these kinds of circuits will actually give you better results than switching on the negative.
None I could see. Once ren made a remark about circuit being wrong way around - then I tried turning and swopping - no difference in same light setup or amp draw..

You mention HV on the battery terminals. You are definitely getting radiant. I posted some youtube vids before of me charging caps with 1 wire from a circuit...that circuit is a very simple Imhotep oscillator with the relay....I never showed the circuit but that is what it was!

The 1 wire transmission was a SINGLE WIRE from EITHER terminal of the input or output battery...through some diodes (plug style) to a cap and it charge the cap. Anyway, I can always repost that and a schematic if anyone is interested but that is probably old news by now.
I did see that and dupicated it, >> Somewhere around page 20 I will estimate. However this circuit behaves seriously different.


As a note, I could only get this effect enough to feel with my fingers with batteries that have been heavily "modified" though many experiments and it just goes to show that impedance / basically - balancing gas pressures on the circuit from the input/output is crucial or these things cannot be found by most.

You say you felt hv at the terminals of the battery but when the ground was removed. When the ground is there, I bet it is STILL there (at the battery), just most if being sucked away. Your batteries are receiving a radiant kickback from the ignition coil through the entire circuit.
Lidmotor find with ground connected there are no HV. His system in that video was quite modified. Unfortunately he does not have a scope. On my original and somewhat modified version later there is HV everywhere. When just starting up, not so serious, but it seems the longer the system runs, the stonger the HV becomes. I want to go back to that setup and redo properly to see.

With the voltage increasing, the first thing I would check is the condition of the battery in the volt meter. In some smaller meters, if the voltage drops too much in the battery, it will show higher and higher voltages when the opposite is true.

I am mostly using one MMeter, but before I post or accept a fact I do verify with at least two others. My believe is that any new idea/truth has to be verified by at least tow independant other sources. In life and mechanical. One of the meters is always digital. Once I fell into an excitement trap due to meter error. Now I have 7 digital meters; all different brands and 4 analog meter in my lab.

I do not doubt you have higher voltages. I have had this even off of some Bedini circuits and other projects, but it is something to rule out.

The battery charge is still not completely verified, except for the HV at terminals. I am playing aorund and chinging the circuit too much to see what cen do. I did not yet set a system to run for battery monitor. At present the battery idea is far on the back burner. I am more curious to follow this circuit through with earth/aether charge and get continues flow from Tom Bearden's "Sea of Energy"

I am now getting through to YouTube and is busy to edit and cvompile my video's in a more presentable format. Trust to start posting them tomorrow. Late PM in Thailand has very slow internet connection - even with our high speed. There are two things I noticed from my video's and Lidmotos/Bokins - my lights birn quite stronger and much less flikker.

When I am up to date with videos, I will also look more into the actual components I have r.e. manufacturer. etc. There are still a heck of a lot observations which I want to follow through. Much more than I would logically think possible from such simple circuit - and not yet noticed by the other participants.

[Aaron]

negative transistors

Aaron, I have MJL's in stock will swop them just now.

Hi Aromaz,

I looked through the last several pages of posts and watched a bunch of vids from everyone. Very exciting!

I think I remember Bedini posting that the MJL's went negative at 1amp at least. BUT, these circuits are a bit different so it is worth a shot. That shows that they DO have the capability to go negative like the 2N2222's. If I can find my notes, I'll post what the 3rd for sure and possibly 4th transistor was that also could go negative.

[Aaron]

wiki submission

They call me crazy, pseudo, moron, psychopatic .......
Wikipedia:Articles for deletion/Dynamic Resonance Theory - Wikipedia, the free encyclopedia

That is what happens when you participate in an encyclopedia based on majority vote...it overrules facts or reality.

Tell me exactly how to contribute to give my KEEP opinion versus their DELETE? I looked at it:
Wikipedia:Articles for deletion/Dynamic Resonance Theory - Wikipedia, the free encyclopedia
but didn't see where I could give my vote.

[Aaron]

supercharged area

There are more weird things here and definitely it supercharged all the environment in my lab. her pole connects to earth. Last connection is also from ground to emitter of 2222. This system is COMPLETELY OPEN. The only connection from battery negative is to coil negative. No other negative connections at all anywhere from that line/terminal to any part of the whole system.

Hi Aromaz,

Can you see if anything in the vicinity of that ignition coil has become magnetized? Paperclips, staples, etc... any small things like that? And if so, from how far away?

[Aaron]

self switching transistor

Aromaz I am interested to see where your circuit goes, there are multiple ways one can trigger an oscillation for peanuts.

In this post,

http://www.energeticforum.com/36009-post108.html

That picture is a self oscillating 2n3055 I think. Nothing connected to input...no battery, cap or antenna, ground rod...and nothing on output. Also the base of the transistor isn't even connected. Collector and emitter are connected to one of the windings on a 2000 turn trifilar. The trigger wires and recovery wires are just hanging open in mid air connected to nothing.

It isn't just o-scope goofy stuff, that transistor is actually doing that.

I found this after doing massive tests with that coil setup with caps, earthrods, etc... I had it running on caps and earth rod alone...running on cap and earthrod while charging another cap. I don't mean small caps...33,000 uf caps, so there was real output, not phantom effects.

Anyway, the conclusion from all of this is that you can get a transistor to switch anything you want for literally no paid for input.

Also, I think Bedini has mentioned about old germanium transistors...could practically switch by just looking at them. I don't know what words he used but I think they could easily switch just by having an antenna and ground to them and nothing else.

I'll see if I can find some vids relating to this and put them on youtube.

[Inquorate]

@ aaron

Reporting would be lovely. Really short on time and would love to hear more from you. You seem to always be spot on with what you say.

[Inquorate]

Re ground and faraday cage

About ground; I could do a pole in the ground where I live, but I'm lazy. Just connected a wire to my kitchen tap. All pipes lead to the throne, etc.

About faraday cage; instead of seeing if this is an 'electric' field between two capacitors by using f cage, a friend of mine suggested setting up a coil (withered low capacitance) between the two spheres, and if it's radiant energy it might not register as current off the coil.

[Aaron]

gas pressures

Something very strange is going on with this circuit. I was getting mild shocks at places in the circuit way up stream where there shouldn't be any HV. This was happening before when I was using the Bedini fan circuit.

Hi Lidmotor,

When the intake and exhaust of these circuits are matched just right for the most pressure, you will get this. I'm excited about all of your and everyone else's discoveries here in this thread. I haven't kept up on it super close but I glance it often. A convergence is afoot

[gnino]

in different setup of Aroma circuit i found this scope shot

[Aaron]

questions for Aromaz

When ground is removed, there is even high voltage that you can feel on both positive and negative terminlas of battery!
Mystical, What is this? Dare I say the dream words - Radiant/Vacuum??

Just after writing above about battery I thought to go and check the voltage. My battery charge went UP !!!! From 12.09 volt this morning to 12.48 this afternoon!!!! The other two systems were fully charged at 12.48v; still the same and 12.51v this morning now 12.53v. I might have made a mistake, this can not be? Could be athmospheric or temperatue? There is definately no radiant spike (closure) and definately no back EMF (terminate). Also with the whole circuit been broken by the gas tubes there is not current possible? I will have to look more closely into this.

Hi Aromaz,

Have you charged a cap by putting it in place of the cfl?

Is there a difference in brightness if you have the cfl on the + side of the coil? There are applications where switching on the positive on these kinds of circuits will actually give you better results than switching on the negative.

You mention HV on the battery terminals. You are definitely getting radiant. I posted some youtube vids before of me charging caps with 1 wire from a circuit...that circuit is a very simple Imhotep oscillator with the relay....I never showed the circuit but that is what it was!

The 1 wire transmission was a SINGLE WIRE from EITHER terminal of the input or output battery...through some diodes (plug style) to a cap and it charge the cap. Anyway, I can always repost that and a schematic if anyone is interested but that is probably old news by now.

As a note, I could only get this effect enough to feel with my fingers with batteries that have been heavily "modified" though many experiments and it just goes to show that impedance / basically - balancing gas pressures on the circuit from the input/output is crucial or these things cannot be found by most.

You say you felt hv at the terminals of the battery but when the ground was removed. When the ground is there, I bet it is STILL there (at the battery), just most if being sucked away. Your batteries are receiving a radiant kickback from the ignition coil through the entire circuit.

With the voltage increasing, the first thing I would check is the condition of the battery in the volt meter. In some smaller meters, if the voltage drops too much in the battery, it will show higher and higher voltages when the opposite is true.

I do not doubt you have higher voltages. I have had this even off of some Bedini circuits and other projects, but it is something to rule out.

[Aaron]

converting graphics

I will post that complete curcuit with which I had most success later today (once I became able to convert the file from Rhino to jpg).

If anyone doesn't have special software, if you can pull up the word doc and see it in the whole window, just hit the control button and prtsc (print screen) button, which is next to the F12 button. That copies what you see on your screen. Then open up microsoft paint program if you have windows and simply hit control V for paste or right click then paste or hit the edit option at the top and select paste. It will paste it right there. Then just save it as a graphic.

I think paint program defaults at bmp, which is a LARGE file but you can do a SAVE AS and select gif or jpg.

Doing it this way, you can graphically convert anything you see on the screen to a simple graphic that anyone can open.

[Aromaz]

Earth Ground

Aaron, I have MJL's in stock will swop them just now.

I suggest you have a look through the thread and watch some videos of Lidmotor and Bodkins.

As for the earth: It does not matter too much. Bodkins find it extremely powerfull with GROUND connection through his spheres. Lidmotor is also using a ground peg. I am on the first floor and connect to the building, not deep into ground.

Lidmotor has relocated the ground - and I did many tests with ground on number of different places.

Message to John Bedini - From me a very personal gratitude and appreciation for his work and education I got from studying his work.

I posted somewhere on Energetic Forum about what John Bedini said.

There are a few transistors that he found would go negative.

mjl21194
2n2222

One or two others that I don't recall the #'s off the top of my head. But you guys are onto it I think if you found these effects with 2N2222.

You may find something else if you replace the 2n3055's with MJL21194's.
I wouldn't buy those to try that...just if you happen to have them on hand. Otherwise, what you have is working it seems

[Aaron]

negative transistors

I posted somewhere on Energetic Forum about what John Bedini said.

There are a few transistors that he found would go negative.

mjl21194
2n2222

One or two others that I don't recall the #'s off the top of my head. But you guys are onto it I think if you found these effects with 2N2222.

You may find something else if you replace the 2n3055's with MJL21194's.
I wouldn't buy those to try that...just if you happen to have them on hand. Otherwise, what you have is working it seems

[Aromaz]

Thanks for references

I dont know if anyone bothered to check out the link I posted before so here it is. I found it interesting.
"Negative resistance ..........."

@ren
@ashtweth - my appologies for not thanking you yet. Guess it was duo to the HV around yesterday. I did see and follow up on these references form Ren and ashtweth. This was what actually put me onto the well know behaviour of the 2222. In fact I see many designers prefer not using this chip bacuse of 'instability'. I just love it, that 'instability' is exactly what I am looking for.

For those interested, here is another report on the 2222
A HeuristicC Approach to Teaching Negative Resistance Phenomenon

I have posted an article on Wikipedia - which will probably be deleted tomorrow, so better read it quickly. Dynamic Resonance Theory - Wikipedia, the free encyclopedia

They call me crazy, pseudo, moron, psychopatic .......
Wikipedia:Articles for deletion/Dynamic Resonance Theory - Wikipedia, the free encyclopedia

Maybe some of you can try to edit a contribution in to make it more than a 'one silly moronic show'

[ren]

I dont know if anyone bothered to check out the link I posted before so here it is. I found it interesting.

"Negative resistance

When biased backwards, and with no connection to the base, certain batches 2N2222A may exhibit negative resistance avalanche properties[citation needed]. This can potentially be useful as an ersatz replacement for tunnel or lambda diode (which can be hard for an experimenter to acquire) in non-critical experimental circuits such as oscillators. This behavior may not be exhibited by any given 2N2222A since it is a side effect of certain transistor physical architectures. The specifications call for certain measured behaviors and parameters; any architecture that results in a sufficient yield of compliant parts may be used whether or not its unspecified behaviors match other spec-equivalent parts. Other parts that exhibit this behavior are thyristors and neon lamps. Despite misunderstanding among some hobbyists, such behavior does not imply energy production or any violation of known physics."