Imhotep's Radiant Oscillator Video

[ren]

Hi all

I tried this circuit and did see a considerable reduction in current when touching the CFL lamp from about 40mA to 20mA. However, the lamp was dim either way but did not reduce when touched. I tried to get the lamp to a practical brightness but the current always shot up. I eventually blew the transistors.

Hoppy

Hi Hoppy and Lid.

Interesting that you could get it working Lid with the CFL looped back into the ignition coil. I only got it to work when the globes were off 1 wire. And removing the second coil ceased the oscillations. Hoppy, I saw the same thing. Low amp draw is all good and well but if there is little illumination what is the point. I could get it really low, but the light was dim too.

@ Mutten. If you look inside the h11d1's package you will note there is a small npn transistor there. This is hooked up in a darlington configuration to my 2n3055. The base is triggered by the opto switch, which is on the other side. This is connected to my PWM. The PWM wasnt used in my above schematic, hence there is no triggering of the h11d1 conventionally.

[Inquorate]

Forgot link

Tesla's Lost Inventions - FUEL EFFICIEINT VEHICLES Journal

[Inquorate]

I got ribbed about doing too much talking...

@Aromaz, sorry it was a link from a page nat posted a link to on gray tube thread.

It's down the page a bit, the guy was a quaker.

See you's all when I've done some experiments

[Aromaz]

@gmeat - I will just add a line to it for you.
It is some sort of related, but not quite!

@Inquorate - Well, we might see the results of the 'White one' but we never actually saw the 'White One' I started developing a different theory and about 25 minutes ago found that there are actually other people that also reached this theoretical conclusion.

Part of the fun is for your tongue be bitten on

Nat 1920 ?? Another posting maybe?

[Inquorate]

Although...

I might have to call a point of order re humans not seeing the white one.. Nat posted something written in 1920 that...

Bite my tongue bite my tongue bite my tongue

[Inquorate]

Riddle

Ha, I like that riddle. I'll keep my lips closed till someone gets it... Had me stumped for a good 15 mins aromaz.

[gmeat]

I have a riddle:

Everything goes into the Black one from where nothing came out.
Everything comes out from the White one where nothing went in.
The Black and the White are not the same because
The Black humans can See,
The White humans Theorize.

What is the Black and what is the White.

@Inquorate: You'll know already, please do not not post yet

Hi Aromaz,


Not sure about what is black and what is white,But sounds like quantum tunneling .


-Gary

[Aromaz]

Riddle

I have a riddle:

Everything goes into the Black one from where nothing came out.
Everything comes out from the White one where nothing went in.
The Black and the White are not the same because
The Black humans can See,
The White humans Theorize.

What is the Black and what is the White.

@Inquorate: You'll know already, please do not not post yet

[Aromaz]

Back in operation, had too much bed time - thinking and scheming might be dangerous ........

Now back up to date and off to my lab for a nice full Sunny Sunday of playing with serious coils and circuits.

It is time for us to change - get away from the transistors and relays.
Why? Because they limit our ability, they are limited in power and they
are most likely the obstacle we have to reach our goals. How to do? Maybe get them isolated from the circuit..........?

[QUOTE=Bodkins; Aromaz@All
Can you get two tubes/sphere in your origanal setup in the way i posted in the video?, the thing is anypoint you connect to ground the tube can be used....[/QUOTE]

I am not sure I understand this clearly? On my circuit once it is running and pulling the power form earth, I can connect the tube (1 to 5 units) one pole anywhere on the circuit with the other to gorund and it will lit up. Even connecting to positive or negative of battery and off to earth. .......

[Mutten]

question about the h11d1

this is a 6 pin package, and you are only using pin 4 (e) and 5 (c) ?

http://www.datasheetcatalog.org/datasheet/vishay/83611.pdf

[Hoppy]

Ren---I made the circuit that you posted and was able to get the loop closed by using an earth ground on the base of the small transistor. I discovered a strange thing at the end of the day when I was charging up the battery while running the system. The amp draw went to zero!! I got all excited until I realized that it must have just been the wall wart but when I unplugged and disconnected the charger the thing went to zero again if I touched the CFL!! . I made a quick video of it and showed a scope shot of the wave form. It may have just been "stray current" going through my body but it sure was weird.

YouTube - Ren's two transistor CFL circuit

Lidmotor

Hi all

I tried this circuit and did see a considerable reduction in current when touching the CFL lamp from about 40mA to 20mA. However, the lamp was dim either way but did not reduce when touched. I tried to get the lamp to a practical brightness but the current always shot up. I eventually blew the transistors.

Hoppy

[Xenomorph]

@Inquorate : It was my post, it was a glass of himalaya-salt-water and a crystal. I am doing more experiments with that right now and will post some more movies about it.

[Inquorate]

Ren's cfl circuit

@ Lidmotor - I can't remember who posted this, but see what a crystal in a glass of salt water does. Also, what does touching wood do to amp draw? I've just realised I never checked.. I was too overwhelmed by the obvious voltage increase that made the spark jump the gap...

If both happen, that would mean we're definitely getting something from outside the system going on...

I'm getting more transistors soon :-) and winding a version of spark prolonger coil tonight that aaron? posted.

[Inquorate]

@Sucahyo that might be what's happening, cfl's being negative resistors in some way... But a standard negative resistor is supposed to use voltage. The frequency on my systems has gotten lower with each cfl though. As for cotton in relay... Just one little spark... You could try a solid state relay to reduce noise, I thought of it but they're really expensive..

Try using step down transformer and diode bridge from the wall. Put it in a box for safety.

[Lidmotor]

Ren's two transistor self oscillating CFL circuit

Ren---I made the circuit that you posted and was able to get the loop closed by using an earth ground on the base of the small transistor. I discovered a strange thing at the end of the day when I was charging up the battery while running the system. The amp draw went to zero!! I got all excited until I realized that it must have just been the wall wart but when I unplugged and disconnected the charger the thing went to zero again if I touched the CFL!! . I made a quick video of it and showed a scope shot of the wave form. It may have just been "stray current" going through my body but it sure was weird.

YouTube - Ren's two transistor CFL circuit

Lidmotor