Imhotep's Radiant Oscillator Video

[Rectified]

[sucahyo]

@Rectified, I also agree that we should learn more before eperimenting. And Learn it from anything even if it was considered fake. By learning all of that we should know the truth sooner or later. Some book I want to avoid though, Tom Bearden one, it has too many theory and history that make me unable to find out how to actually achieve it. On other side, Peter Lindemann and Konstantin Meyl work is a must read.


For solid state experiment, I failed to make two TIP2955 vibrate. replacing 2N2222A with TIP3055 do not work too. 2N2222A pairing with ST 2N3055 certainly work, even for a second. I will have to wait until I can buy another ST 2N3055, maybe re trying Toshiba 2N3055 too.


About circuit, one thing that I seen as an obstacle for obtaining over unity, using current way of dumping BEMF current trough source positive, is the way the device draw more current when there is more load. It seems more BEMF load force the power source to power it too.

If we seen the circuit is two separate loop, normal current loop and BEMF current loop. Both seems to be dependent to each other. My experiment show that when there is BEMF load, the current drawn from source increase.

The alternative way that I try use less current, brighter light, but unfortunately much less BEMF current. Maybe the opposite facing diode act more like limiting valve. Maybe need a diode with lower rating to allow higher source voltage to go trough but limiting the one bellow.

I am thinking that if I can make the proces faster or continuous with dual pumping BEMF using two output multivibrator we can make the BEMF part rotate more. Just a non proven theory.

Edit:
Sorry, after rethinking it again, the alternative circuit still won't allow us to go over unity because it still force the power source to power the BEMF load. But I can't explain why this alternative circuit require lower power and yet have brighter lamp.

[Vortex]

Pieces of the puzzle, anyone?

Konstantin Meyl explains how Faraday and Maxwell do not jive with each other and could be misleading you.
Meyl
Demos of Tesla's scalar wave transmission, with OU (not really it's an open circuit)
Explains how there are 3 WAVES going on at the same time and that's important for free energy researchers to know this.
Explains a human is like an antenna giving off scalar waves (transmitter) ..
later shows how a human can be a receiver
Uses a 2 volt power supply to produce his scalar waves!!!!!!!!!!!!!!!!!

Resonance Coupling explains how the "Touching of WOOD" causes an effect.

Stop touching, We are transmitting. Watch the videos.


Randy

[Lidmotor]

Rectified's words of advice

@ Rectified---Excellent words of advice. There was a saying posted on the wall near the blackboard of my 7th grade drafting class that read: "Learn from other's mistakes because you will not live long enough to make them all yourself."
Reinventing the wheel takes too long. I would rather build the car and not have to make all the mistakes. Later on in life though I found out something else that my teachers should have told me. If you lose interest in a topic you are learning and quit studying it, perhaps it might have been wiser to play around with those square and round objects that were fun and learn along the way. Building the car might take longer but you will have had a little more fun and stayed envolved. I quit electrical engineering after my second year in college----it was way too boring.

Lidmotor

[broli]

Yeah for basic physics I would recommend Walter lewin's MIT lectures found on youtube for one.

YouTube - Broadcast Yourself.

[Aromaz]

@Rectified; I can not put it better or disagree with you at all.

@All - What Rectified said is 'overunity' true. As you all know, between my visitors - I have gone back to basics, so I am doing full detail study of each and every component I am using; therefore my understanding of transistors, coils, EMF, BEMF has greatly increased.

Even I am just a student myself; I can unconditionally say: YES, get down studying these components, then go back to the experiments. Not only will you find things easier, but you will also realize when you see a truly strange behavior.

I know it is boring and sounds like work - but I assure you it is absolutely worth it. Though - you do not need to go to books, there are now a number of excellent websites like AllCircuits.com - with detailed documents, and a LARGE number of high education videos form various technicons and universities offering absolute free education.

[Rectified]

RCL a.c. series circuit

God bless and good luck

[sucahyo]

@Lidmotor,
Has ball shaped metal as antenna ever been tested for Joe TATE Ambient Power Module?

The capacitor value need to be changed?

LETTER FROM GREG HODOWANEC
RESONANT FREQUENCY OF THE AETHER
The following is from an overlooked letter from Greg Hodowanec, dated September 8, 1996.
Dear colleague: The following may be of interest to you.
POSSIBLE RESONANCES IN THE UNIVERSE.
The fundamental frequency in the Universe is the Ryhsmonic (aetheric) frequency f* which is equal to
1/T* or 1/5.391 x 10-44 sec. which is about 1.855 x 1043 Hz.
Interaction with this fundamental frequency under resonance conditions should result in an exchange of
energy, i.e., energy extraction. Some possible resonances are now considered, with remarks on possible
confirmation: without reference to powers (fundamental to operating frequency ratios) the basic
frequencies are now listed:
Frequency Remarks
1. 1.855 Hz This is a Schuman resonance and is also seen in Rysmonic
GW resonance (ч 2 Hz).
2. 3.710 Hz This is also seen in Schuman.
3. 7.42 Hz This is also seen in Schuman as a more pronounced
resonance.
4. 3.710 KHz These frequencies were seen in the coil tests (Cosmology
9.275 KHz Note 3/16/96)
18.550 KHz Also, man of these frequencies were see in
24.115 KHz MRA tests, especially in Mini-MRA tests.
33.390 KHz
46.375 KHz Note: All the frequencies listed here cannot be just
68.635 KHz mere coincidence!
77.910 KHz
89.040 KHz Note: The ratios of these nos. to 3.71 are 2.5, 5, 6.5,
9, 12.5, 18.5, 21, 24, 35
124.850 KHz
Conclusions: These tests appear to indicate that sub-harmonic resonances with the fundamental
rhysmonic frequency of 1.855 x 10 43 Hz do result in the extraction of some energy from the intrinsic
energy of this Universe!
[Editor's note: There appears to be something fundamentally important about these frequencies. I tried to
find more information about Schuman resonance but haven't found a definition as yet.]
Return to the INE Main Page
Resonant Frequency Of The Aether
June 2, 1999.

[Inquorate]

Cap charge with radiant

A cap in vicinity of square wave circuit with long wires (which leak more, when I soldered it all close together it didn't leak so much) a cap with antenna wire (ie alligator clip wire) on pos, and neon from neg of cap then to ground will light up the neon but show no charge on cap when measured with meter.

Unless you move the meter closer to square wave source of leak, and it will show higher voltage.

BUT disconnect meter, voltage still shows up as long as wires are straight. Bend the meter wires to 90 degrees halfway and voltage halves. Whole of meter's wires perpendicular to source, and voltage almost zero.

This is same principle as 'detector'

:-)

[Lidmotor]

Replication

Okay i have replicated Lidmotor`s latest circuit.
It works well, i have managed to charge the capacitors to 39 Volts even.
I had to use 1N60s instead of 1N34s, maybe they allow for a higher voltage.
Here a little video of the circuit:
YouTube - IMGP8770

I was not able to charge non-rechargable batteries (4 x 1.5V Mignon) at all however when connecting them to the circuit. 1 hour passed and i still have 5.87 V battery charge like before. Maybe i did something wrong.

Good job Xenomorph! That is a higher voltage on that charge cap than I have gotten. I hooked up one AA rechargeable to the circuit like Joe Tate said to do and it seems to be accepting the energy ok. There is so little amperage here that you can't shove the juice into much. Maybe somebody else has an idea??

@ Aromaz -- Thanks for the info on the transistors. I'm thinking about making two parallel circuits for the light. One for low light/ low draw with the little 2222s and another circuit along side it with the big boy transistors for high amp/ bright light. Some kind of switch would let you choose which one to use. The two circuits may need to be completely different.

Lidmotor

[sucahyo]

@Aromaz,

Thank you ! . That info save me from a lot of trial and error .

I fried a couple of 2N2222 today thinking that maybe I can avoid the problem by different method back EMF dumping. My latest video teach me that HHO cells absorb this back EMF much better than computer fan I use for solid state version. Maybe not as good as rechargable battery but with HHO cell I know that my relay still running, it's very silence now since I weaken the spring. But I still fried the 2N2222 even when I use HHO cell.

I bought TIP3055 yesterday but I can't make it work yet. I hope I can work it out.

BTW, I already found the store that sell ST 2N3055. The toshiba one is failed already. Thanks for the suggestion.


@everyone,
Is there other circuit available that have feature:
- square wave
- controllable frequency and duty cycle
- minimum back EMF path
- can withstand back EMF

I choose single load two transistor multivibrator because it has all of them. It has squarewave output, if we replace R1 and R2 with variable transistor we can control both frequency and duty cycle. the back EMF path is coil, capacitor, back EMF dumper and the transistor it self.

I assume that the capacitor should be able to stop the back EMF flow so it will revert to other path. The transistor may leak some of back EMF, the coil will force the back EMF to other path, I think majority would go to the back EMF dumper.


BTW, is there a safe way to measure the amp of back EMF or any radiant energy that used to charge battery or powering something? I damaged the amp meter part of my multimeter. Currently I have to use my HHO cell as amp meter.


Would Lidmotor secondary charging circuit can be enhance with some resonance tuning like Konstantin Meyl do?

[broli]

YouTube - Wireless Transmission of Electrical Energy, Tesla 1900 part9

He has been mentioned a couple of times already but why isn't he on this forum . He seems to have a really big bag of experience with tesla research.

[Aromaz]

@Lidmotor: Nice experiment again!
Do you think that batteries charged with the captured energy will also last longer than normal batteries? I am trying to figure out if it is radiant spikes charging the capacitor in the secondary circuit or just amplified RF converted into current.

The current from the coil around the CFL is normal AC power. It is the same effect as I have with the fluorecent tube with the coil wire around it.

@Lidmotor: Nicely done. I used this circuit and tested it even charging my mobile phone, though the charge does not last long. Connect the other end of the circuit to earth with a very small diode, should find an increase in charging the caps. Adding this to charge back to batteries should extend your run time. Nice!

[Aromaz]

@sucahyo;

The 2222 is low current transistors - in particular big difference between input and output. They can not handle much heat or extreme frequency. Typically in power applications they are used for switching other transistors because they need less power (30mA, 3V) to switch.

There are more than 22 different packages for the same or similar transistor values. The general rule of the thumb for the three main ones we are working: (This is not law !)

TO-92 - Kind of plastic encapsulated, higher frequency, lower power (current), low heat

TO-10 - Metallic (Al) can is similar to TO-92 but reduced external interferences on signal, often with additional earth pin. Can handle little more power (amp)

TO-3 - As example 3055 - Low interference from outside, higher current handling (115W), withstand more heat (200 deg C).

TO-218 (TiP package) Lower heat than TO-3 (150 deg C), lower current (90W) more affected by environment disturbances.

[Xenomorph]

Lidmotor`s replication

Okay i have replicated Lidmotor`s latest circuit.
It works well, i have managed to charge the capacitors to 39 Volts even.
I had to use 1N60s instead of 1N34s, maybe they allow for a higher voltage.
Here a little video of the circuit:
YouTube - IMGP8770

I was not able to charge non-rechargable batteries (4 x 1.5V Mignon) at all however when connecting them to the circuit. 1 hour passed and i still have 5.87 V battery charge like before. Maybe i did something wrong.