Harvesting Energy From the Sun Using Crystals

[Dave45]

This is what I've been doing for the past few days.

I've noticed thast the bubble tips form like tornadoes -- from the 'top down' so to speak. From the widest-to narrow point. All of the bubble configurations have been created by the dissolved gasses, in various concentrations (M-state water, or 'oxygenated'/vortexed water). (You can still get bubbles without M state, or spun water)

I used two wine bottles, and magnets in a vortex bottle configuration to spin the water. I'm not sure if it produces M state water, or oxygenated water, nor am I sure it matters. Oxygen is influenced by magnetism, isnt it? If it is, the idea I have on how the bubbles form in their vortex configurations still works.

When we are freezing the water, the dissolved gasses orient themselves, with the apex pointing towards the blotch wall, or towards the 'neutral center' -- where by virtue of winding a special coil, have aritifically cancelled the fields.

Think of how there is a big plastic island in the middle of two ocean currents. The little floating bits (plastic/dissolved oxygen) are rammed against each other, where we would observe no 'net movement', but are quite 'forced into place' and held in thier respective positions by the balanced current.

Thank you for being brave, dave.

I think it is the structured gasses which you can strike with the voltage spike -- and similar to how the shape of trees behaves like a Tuned LC circuit -- I think the shape in which we force those dissolved gases (oxygen, being the dissolved gas with the most importance for superconduction -- essentially the crystaline lattice structures the oxygen to 'receive' the high frequency)#

Inside the air spirals, I think that the oxygen is very close to being 'conductive'. (Say, isnt ORMUS a gas? More conductive dissolved gasses that would orient themselves in the 'cancelled region' towards the blotch wall) I have not struck them with a High voltage power supply yet -- I need to buy more MOSFETS for my flyback transformer.

Anyone know of any cheap HVDC power supplies?

Man, I need to build a tesla coil.....

I am Still experimenting.

==Romo

Yes it is the disolved oxygen that is making the structure, if you put an aluminum plate and ground it to a grounding rod the structured water will go to it and actually stick to the plate, then when the coil is pulsed you will get voltage in the plate, I had 1/4 inch spark jumping from the plate lead to ground, this voltage had bite.
I also noticed the A vector field could be moved up or down with a screen, if you built a vortex coil with the V pointing towards the aluminum plate and used the screen to move the A vector field to where it flows over the vortex coil, you will have taped into the either field that feeds the magnetic field, it is also the field that causes bemf in a coil.

Bemf--- when the A vector field is established it flows past the coil windings and into the magnetic field but when the coil is turned off the A vector field is still flowing and collapses into the coils windings.

If you can move this A vector field into the top of the vortex coil when the field is pulsed it will follow the structured ice into the alumimum plate instead of collapsing into the coil windings, you will have created an electron pump.

[MonsieurM]

side note:

from: http://www.energeticforum.com/renewa...tml#post156237



Variation of the Ankh Set up: The Phi Set up (like the symbol see above link )



The Physics/Cosmogeny of
Walter Russell and Lao Russell

The golden ratio spotted in a magnetic compound.

I have been reading a lot of Tesla's work and early on he experimented with cone shaped secondary coils. This is an interesting configuration and has come into particular interest regarding the generation of powerful electric arcs, as opposed to the generation of long electric arcs. Since Tesla's goal was to transmit power through the atmosphere he was primarily interested in generating intense electromagnetic radiation. The larger windings at the bottom of the secondary are able to absorb the most current from the primary, while the tapered format linearly increases the voltage in a proportional amount according to the electromagnetic falloff according to the distance from the primary. These conical coils often had no top load capacitor, and relied on the internal capacitance of the coil itself. This experiment clearly shows the distributed parameters in the components. I have built a Bi cone coil and have just started testing it. So far the results are impressive and will warrant further study.

It's all about spiral be it solid (like a coil) or emf (principle of mentalism )

a collection of Walter Russell's drawings:

Walter Russell Vortex Video - The Cosmology of Twin Opposing Electro - Magnetic Vortices - YouTube

[MonsieurM]

It is also called a Fermat's Spiral -- from Wolfram MathWorld

Fermat's spiral (also known as a parabolic spiral) follows the equation


in polar coordinates (the more general Fermat's spiral follows r 2 = a 2θ.) It is a type of Archimedean spiral.[1]

In disc phyllotaxis (sunflower, daisy), the mesh of spirals occurs in Fibonacci numbers because divergence (angle of succession in a single spiral arrangement) approaches the golden ratio.[3]

[MonsieurM]

If the vortex coil was made using the Fibonacci scale, and you used the copper screen to shield the sides of the coil and move the lenz field up and into the top of the coil it would be like water down a drain
This is the answer, I can feel it.
Dave

here is an easy coil to build, and once made it can be turned into a vortex shape: (used by orgone builders ) How to make an SBB coil





The Winding of the Cosmic Clock Spring Walter Russell



ps: good to read you petar113507

[petar113507]

If the vortex coil was made using the Fibonacci scale, and you used the copper screen to shield the sides of the coil and move the lenz field up and into the top of the coil it would be like water down a drain
This is the answer, I can feel it.
Dave

I have recently had a very similar idea, wrapping the coil in a cone according to phi, as the receiving, 'Step down' coil. It reminds me very much of russell's cone coils, which he said produced OU based on a 'power multiplication principal'.

Are you talking about moving lenz (the counterbalancing force to our EMF) to the apex of the coil spiral? Do you have the second receiving coil wound in a 'cancelling' way (bifilar and the other cancelling fields)?

I do not have a cancelling coil to 'receive' the impulse. I think it would be better to capture the HV

I think the receiving coil would work very similarly, if you were to use a tesla coil as a receiving antennae. (By the way MM, the idea about using spray on glass, to induce dielectric breakdown around the tesla coil HV out -- very clever )

Specifically, the relation between the secondary, and the primary -- using a primary wound around the high voltage center (trapped, or conducted through the secondary).

Ice seems to freeze in an egg shape. From the outside in.



==Romo

[petar113507]

thats the coil Im using , I want to use a normal coil and see the difference just havent had time, to much going on with theory

This is what I've been doing for the past few days.

I've noticed thast the bubble tips form like tornadoes -- from the 'top down' so to speak. From the widest-to narrow point. All of the bubble configurations have been created by the dissolved gasses, in various concentrations (M-state water, or 'oxygenated'/vortexed water). (You can still get bubbles without M state, or spun water)

I used two wine bottles, and magnets in a vortex bottle configuration to spin the water. I'm not sure if it produces M state water, or oxygenated water, nor am I sure it matters. Oxygen is influenced by magnetism, isnt it? If it is, the idea I have on how the bubbles form in their vortex configurations still works.

When we are freezing the water, the dissolved gasses orient themselves, with the apex pointing towards the blotch wall, or towards the 'neutral center' -- where by virtue of winding a special coil, have aritifically cancelled the fields.

Think of how there is a big plastic island in the middle of two ocean currents. The little floating bits (plastic/dissolved oxygen) are rammed against each other, where we would observe no 'net movement', but are quite 'forced into place' and held in thier respective positions by the balanced current.

Thank you for being brave, dave.

I think it is the structured gasses which you can strike with the voltage spike -- and similar to how the shape of trees behaves like a Tuned LC circuit -- I think the shape in which we force those dissolved gases (oxygen, being the dissolved gas with the most importance for superconduction -- essentially the crystaline lattice structures the oxygen to 'receive' the high frequency)#

Inside the air spirals, I think that the oxygen is very close to being 'conductive'. (Say, isnt ORMUS a gas? More conductive dissolved gasses that would orient themselves in the 'cancelled region' towards the blotch wall) I have not struck them with a High voltage power supply yet -- I need to buy more MOSFETS for my flyback transformer.

Anyone know of any cheap HVDC power supplies?

Man, I need to build a tesla coil.....

I am Still experimenting.

==Romo

[MonsieurM]

God always stands with the brave at heart

[Dave45]

Folks I have to admit Im more than a little nervous, if this works the implications are astronomical,
There are several people who know who I am and if harm comes to me or my family they have been asked to spam the net with that information.
Please keep us in your prayers.
May God bless you and draw you close to Him
In Jesus Name
Thank You
Dave

[Dave45]

make the same in a funnel the opposite of the bashar antenna or like the video you posted

Self Assisted Oscillation in a Shorted Coil - Bucking Magnetic Field Oscillation - YouTube

Yes in this vid they speak of the A vector, the A vector is the energy moving into the coil that feeds the magnetic field, this is the field we need to move into the top of the vortex coil.
Use pure water the dielectric properties of the water is what we want.
Dave

[Dave45]

If the vortex coil was made using the Fibonacci scale, and you used the copper screen to shield the sides of the coil and move the lenz field up and into the top of the coil it would be like water down a drain
This is the answer, I can feel it.
Dave

[MonsieurM]

I also found this:

Hendershot Used Phi (or so I speculate!!) - YouTube

[MonsieurM]

thats the coil Im using , I want to use a normal coil and see the difference just havent had time, to much going on with theory

make the same in a funnel the opposite of the bashar antenna or like the video you posted

Self Assisted Oscillation in a Shorted Coil - Bucking Magnetic Field Oscillation - YouTube

[MonsieurM]

Leedskalnin said the south field pulls more and the north field push's more,
the north field needs to point down toward the aluminum plate

good thinking

the kybalion:

principle of polarity

-the positive corpuscles seeming to exert a certain influence upon the negative corpuscles, causing the latter to assume certain combinations and thus "create" or an atom. This is in line with the most ancient Hermetic Teachings which have always identified Masculine principle of Gender and Feminine Poles Electricity

[Dave45]

Its 12:30 and I cant sleep for thinking of the project,
I got it, we need a coil shaped like a funnel
Good night folks
I hope
Dave

[Dave45]

If we could pull the either field(lenz field) into the center of the core from above we would have more energy than we could use

It would create the funnel vortex like you posted