Symmetric versus Asymmetric Electromagnetic Systems

[thugugly]

Well, UFO is ok, i guess i should calm down now.

Larry, I wish i could afford that *****.

I have been going to a motor/electrical shop and buying run caps, most are 400 - 600 v, 50 -2100 uf.

I have been paying (1 dollar apice, shhhh!)

I have about 80 so far. I was going to stop at 500.

It's also a real good place to buy wire. I bought a 15,000 ft roll, old supply, for $100.00.

Really good deals.

[larryross]

The war can never end, ever!

So, how do we make the coils "independent of induction of nearby coils" even if they are not connected in series and/or parallel.

I'm going to try to wind 10 identical 33 ga coils same as ufo's radiant tool he built maybe 2000 turns/8000 turns, and try to isolate them within, larger and larger stationary coils, until I get my opto circuit going, and then I'm going to build a stationary coil with 500 volts and build the biggest mother****in coil I can build, and fill that mother****in stationary coil, with as many goddamned 33 ga coils as i can.

Each coil filling the biggest goddamn capacitor I can fill, 100 x faster then the signal.

GODDAMN THEM

Here I found this for you:

HIGH CAPACITY ELECTROLYTIC CAPACITOR BANK
960 pcs 1500 mfd, 450 V electrolytic capacitors in good condition. Manufactured by Mallory - LES 21823-A - 235-7503K. The cans are 3" diameter x 5.5" high. Connections are on the top (female screw threads, separated by ~ 1.5 ") Each capacitor is 770 g (1.7 lbs) total weight of capacitors only, ~ 1500 lbs. Mounted in bank, ~ 2,500 lbs/bank. $24,000 takes it! TG912



Regards
Larry

[thugugly]

independent coils

The war can never end, ever!

So, how do we make the coils "independent of induction of nearby coils" even if they are not connected in series and/or parallel.

I'm going to try to wind 10 identical 33 ga coils same as ufo's radiant tool he built maybe 2000 turns/8000 turns, and try to isolate them within, larger and larger stationary coils, until I get my opto circuit going, and then I'm going to build a stationary coil with 500 volts and build the biggest mother****in coil I can build, and fill that mother****in stationary coil, with as many goddamned 33 ga coils as i can.

Each coil filling the biggest goddamn capacitor I can fill, 100 x faster then the signal.

GODDAMN THEM

[wonza]

I will give you a riddle in the meantime....

You are trying to get your drink in obscure dark canteen however there are two tipsy soldiers the kind you want not to know closer and they both are occupying the bar. You know that they will not allow you to get your drink, they want to beat you rather the fight is " in the air" .
You know that there is only one solution to this situation....they are two you are one what to do ? The fight is called Lenz law btw...

Tell them there's a bar nearby that's offering free drinks?

[boguslaw]

I will give you a riddle in the meantime....

You are trying to get your drink in obscure dark canteen however there are two tipsy soldiers the kind you want not to know closer and they both are occupying the bar. You know that they will not allow you to get your drink, they want to beat you rather the fight is " in the air" .
You know that there is only one solution to this situation....they are two you are one what to do ? The fight is called Lenz law btw...

[wonza]

I will launch a "Technical Info" video on the 4th of July...

And yes, I have built several different types of Asymmetrical Motors configurations, the list is long, You guys will have your hands full very soon...I can only see you...

They are ALL Successful by now Wonza...They all are COP over 1...and then some...it will be "Up to You guys" how much above the "impossible" COP>1 You want to go...
Trust me...no BS

Happy Independence Day!!

I will see U then


Regards


Ufopolitics

Eagily awaiting the details

[ewizard]

I rounded up all the parts to build the RomeroUK motor but barely got started on it before I got busy with other things and then the nonsense got so thick I wasn't sure it would be a good use of time (as busy as I was with other things) to try finishing the build. Hopefully these parts can go to good use with what UFOpolitics has here as I totally trust his expertise and knowledge.

[ZeropointEnergy]

Cool my friend

Hello again ZPE!


Not talking about the Light Show now...

It is not that I do, or do not agree with your theory of unbalance between pairs of Coils...but that I really do not understand what you mean by unbalancing them... ...They are equally built at rotors-armatures (therefore, MUST BE) of equal values, winds and wire type...Maybe you are referring to "Electromagnetically" unbalance them?...or is it Electrically?

I will tell you that making them "INDEPENDENT" and in SETS of PAIRS, or GROUPS of SETS OF PAIRS...makes a good 80-90% of the whole secret and success...This fact allows you to "SHARE" (Interconnect) Coils between Generators and Motors simultaneously within just ONE EMBODIMENT, by using their "respectively determined and designed "idle time" of either one...
Now the way to structure them, the ways to turn them On or Off...could vary as our great Electronics advanced tech will allows Us to employ...or by means of old mechanical switches (Commutators or/and Continuous-and Non Continuous Slip Rings Contacts) like Tesla did back in the 1800's...

Be patient...We will break the Spell from the Witch soon...

Regards


Ufopolitics

Hey Ufo,

Great news that the clip is coming out and I will try add the changes to the Kromrey if possible or make a new motor for the cause. I do tell many people about your circuit and will alway support a good thing when I see it.

Not talking about the Light Show now...

Please ask me some questions about the effects/colours as you know I'm happy to talk about them and have a year worth of Radiant anomalies recorded. This may open up a greater understanding of the Radiant effects associated with given frequencies.

It is not that I do, or do not agree with your theory of unbalance between pairs of Coils...but that I really do not understand what you mean by unbalancing them... ...They are equally built at rotors-armatures (therefore, MUST BE) of equal values, winds and wire type...Maybe you are referring to "Electromagnetically" unbalance them?...or is it Electrically?

Think of 2 sets of coil pairs of equal turns with ferrite cores for example. First coil pair will have a 50mm spool/core and sit flush inside the coil. The second coil pair will have the 50mm spool, however, the ferrite coil will be increased to 75mm to create a magnetic phase difference as tesla describes in the patent and thus Asymmetry via the electromagnetic inbalance.
, It would of been easier to find the Tesla quotes from the Patent.

Now the way to structure them, the ways to turn them On or Off...could vary as our great Electronics advanced tech will allows Us to employ...or by means of old mechanical switches (Commutators or/and Continuous-and Non Continuous Slip Rings Contacts) like Tesla did back in the 1800's...

Thankyou for sharing more of your wisdom

Regards
Zero

[Ufopolitics]

Hey ZPE...

Hey Ufo,

I wish to 100% understand Tesla's legacy of Asymmetrical Motors other than independant circuits for the coil pairs.

IMHO I honestly see the inbalance between the pairs of coils is what Tesla alludes to in Patent # 524,426.
I know you do not agree with my analogy but maybe is the same thing in a different terminology.

Still looking forward to your YouTube clip to confirm or squash my theories

Regards
Zero

Hello again ZPE!


Not talking about the Light Show now...

It is not that I do, or do not agree with your theory of unbalance between pairs of Coils...but that I really do not understand what you mean by unbalancing them... ...They are equally built at rotors-armatures (therefore, MUST BE) of equal values, winds and wire type...Maybe you are referring to "Electromagnetically" unbalance them?...or is it Electrically?

I will tell you that making them "INDEPENDENT" and in SETS of PAIRS, or GROUPS of SETS OF PAIRS...makes a good 80-90% of the whole secret and success...This fact allows you to "SHARE" (Interconnect) Coils between Generators and Motors simultaneously within just ONE EMBODIMENT, by using their "respectively determined and designed "idle time" of either one...
Now the way to structure them, the ways to turn them On or Off...could vary as our great Electronics advanced tech will allows Us to employ...or by means of old mechanical switches (Commutators or/and Continuous-and Non Continuous Slip Rings Contacts) like Tesla did back in the 1800's...

Be patient...We will break the Spell from the Witch soon...

Regards


Ufopolitics

[ZeropointEnergy]

Hello ZPE,

It is indeed sad...however, Tesla's legacy to our world will re create the Asymmetrical School of Engineering back again, and this time stronger than before, applying all the state of the art tech available now days.
Of this statement above I love the final paragraph, which is the one we belong now to take into effect and make it a reality.

After all this black and gray clouds are over and gone..it will come the "Judgement Days"...passing for all the required ridiculization, condemned and combated to exhaustion on our side.


Regards


Ufopolitics

Hey Ufo,

I wish to 100% understand Tesla's legacy of Asymmetrical Motors other than independant circuits for the coil pairs.

IMHO I honestly see the inbalance between the pairs of coils is what Tesla alludes to in Patent # 524,426.
I know you do not agree with my analogy but maybe is the same thing in a different terminology.

Still looking forward to your YouTube clip to confirm or squash my theories

Regards
Zero

[Ufopolitics]

Hi Wonza

Hi Ufo,

Any idea when your next video will be completed? Have you made any progress in building an asymmetrical motor?

I will launch a "Technical Info" video on the 4th of July...

And yes, I have built several different types of Asymmetrical Motors configurations, the list is long, You guys will have your hands full very soon...I can only see you...

They are ALL Successful by now Wonza...They all are COP over 1...and then some...it will be "Up to You guys" how much above the "impossible" COP>1 You want to go...
Trust me...no BS

Happy Independence Day!!

I will see U then


Regards


Ufopolitics

[wonza]

Hi Ufo,

Any idea when your next video will be completed? Have you made any progress in building an asymmetrical motor?

[Ufopolitics]

Dear Boguslaw...

Indeed. Very good Ufopolitics. We have to realize true nature of Lenz law, then everything is easy... even magnetic motors are possible but there always has to be small "kicking" process to sustain ... Wesley Gary neutral line...
Just a few thoughts....

Thanks Boguslaw,

Yes indeed, We all need to realize the true nature of Lenz law...However, mainly we have to learn between "False Lenz Laws Manifestations" when they are basically and merely originated by an specific model natural behavior...locked up in time...

Regards friend

Ufopolitics

[boguslaw]

Indeed. Very good Ufopolitics. We have to realize true nature of Lenz law, then everything is easy... even magnetic motors are possible but there always has to be small "kicking" process to sustain ... Wesley Gary neutral line...
Just a few thoughts....

[Ufopolitics]

No, You do NOT have it totally off...

Hey UFO

Great posts UFO. Without the mechanical background, I knew but never really understood why (never thought about it much I guess), why the counter-force against our input developed in an alternator. So its because the coils that are not getting a voltage drop across them are still conducting the induced current (opposing)because they are in connected in series or parallel.
It hard to believe it is that simple. Keep them isolated.
So we have to use pairs of seperate coils. How many pairs are you using?, are the opposite coils same length?, do they feed into a common capacitor bank?

Maybe I'm totally off here?

Thanks so much UFO

Thug

Hello Thug,

You are ok...and yes it was so simple...that many are just going to laugh out loud... when this is over and done...

Coils in Pairs are all same length, that keeps a magnetic field "balance"...
I am using different embodiments...from three to sixty...poles, so as many you could fit there...degrees are very important, where "not necessarily" have to be 90-180...
If you feed coils to any component that will create a closed loop...without any "one way" blockage, they will get through feed back the counter effect...by self magnetization...
An Alternator, or a Vehicle Alternator (as I know it)...maintains a constant linear current applied to its rotary stator (spider types, Upper and Lower poles N-S through their teeth)...So this type of Generator is a completely Symmetrical "Full Time" Counter Effect...at all times it is offering resistance to rotation...

It is not only to keep them isolated (that is a major part though)...but also Asymmetrically disposed and performing...

You will see it all very clear my friend, very soon...in beautiful 3D transparencies...State of the Art beauty and disclosure...of the real truth.

Regards


Ufopolitics