This forum is preserved as a permanent archive. The community continues at eMedia Press.

Announcement

Collapse
No announcement yet.

Tiger's Device 0.150-1Kwt replicant

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Duncan
    replied
    Dreams

    Originally posted by daemonbart View Post
    Hi Duncan and thanks!

    After watching the film so many things make sense and fall in place!

    I really need some time to digest this

    You will have my comment soon, hope I will have some nice dreams tonight

    Kind rgds D
    glad you enjoyed have just pm'd you with more info

    Leave a comment:


  • daemonbart
    replied
    Wow!

    Hi Duncan and thanks!

    After watching the film so many things make sense and fall in place!

    I really need some time to digest this

    You will have my comment soon, hope I will have some nice dreams tonight

    Kind rgds D


    Leave a comment:


  • boguslaw
    replied
    I think there is no need to go above 3kV and 1kV should work just fine, it depends on thickenss of ferrite toroid.

    Leave a comment:


  • Duncan
    replied

    Leave a comment:


  • Michael John Nunnerley
    replied
    Well it's all interesting. I have put the coil that I have shown on a HV supply to see what the frequency is to vibrate the ferrite "make it sing" before I rap the other coils over the top at 90 degrees, of course those will change the frequency as will driving those coils, but I just wanted to prove the theory that this linear coil made as a capacitor and not a coil, would do the job. Well with just 12v into the ign: transformer coil, SHE SANG LIKE A BIRD at just one frequency input but radiated harmonics that were of equal power, I just may do a video of it if I have time.

    Normally you would expect the harmonics to be of lower power, steps, but these weren't, very encouraging. Also by putting a small piece of transformer lamina plate at right angles to the coil I could draw sparks off it, but direct to the coil NO, also very encouraging, can't wait to wind the other coils. Electrons are radiating into this 2.5" X 1/2" plate and putting a charge on it.

    Also noticed that the ferrite warms up from the vibration after a couple of minutes, but at this low power level 6KV+- there is not a problem, but at 20-30KV might be another thing, I think I will start at around 15kv which is where the electron beam is visible

    Mike

    Leave a comment:


  • MonsieurM
    replied
    We seem to be on the same page...simplicity ans safety is key...for rapid duplicability...

    Leave a comment:


  • Duncan
    replied
    which isn't mine by the way, TARIEL KAPANADZE EVERYTHING .. WE KNOW FOR NOW..swf - YouTube and re-work the machine from there. Its simple Its very high power and its on display! raped if you will...
    Because my real aim was to KISS ! So it could be easily replicated, understood. And made none lethal. I had in mind a simple flip/flop circuit The Flip Flop

    Leave a comment:


  • MonsieurM
    replied
    Originally posted by Duncan View Post
    I was in tears but I saw the truth.
    .
    When it hit me, the same happened to me....

    In that knowledge are you prepared to run harder?.
    I have been running and catching up...we are part of the circuit this i know...also all roads lead to Rome...

    pure engineering is useless without the user polarized and in tune with his circuit...ie complete knowledge of the events and elements present...your are part of the symphony that you are seeking...not the conductor...if you understand this...you'll know how to tune your crystal

    Leave a comment:


  • RAMSET
    replied
    Not for Profit!!!

    Duncan,
    Grandma used to say
    "Whats for Yah ne're go by Yah"!!
    Been coming down the road a long time!!

    Hold on Boys and Girls !! ,This is for all of us!!


    Chet!!
    PS
    In my Humble opinion ,This would be a good time to Pray!! {please]
    Last edited by RAMSET; 11-18-2011, 04:37 PM.

    Leave a comment:


  • Duncan
    replied
    cold electricity Brrrrrr

    Originally posted by zilano
    THE REAL REPLICATION is by sr193 and there u can see real power with light and heat the normal power with no blue ray. blue ray phenomena happens with cold electricity and it does not produce heat.bulbs r colder yet more bright with bluish white light

    rgds
    zzzz

    Leave a comment:


  • cikljamas
    replied
    I agree with you! But do we have finished schematic or we should make it for ourselves, each of us?

    I am patient(adjective), and i just hope i am not patient(noun)...

    Leave a comment:


  • Duncan
    replied
    So very sorry

    Originally posted by MonsieurM View Post
    In other words, you are part of the circuit....

    Leave a comment:


  • MonsieurM
    replied
    In other words, you are part of the circuit....

    Leave a comment:


  • Duncan
    replied
    Tektron & Dragon

    I have uploaded this video onto another server I hope it works for you. even if you have to download it all firsthttp://dnp.s3.amazonaws.com/a/a9/[Vi...kola Tesla.mp4
    Pity you can't read the comments Tom Brown is a cutting edge researcher.

    Leave a comment:


  • Duncan
    replied
    Take 100 lines!

    Originally posted by Haan
    There does appear to be a vertical (violet coloured) line, with short horizontal impulses, shown on some videos of Kapanadze replications. (I'll call these Kapagens to differentiate from genuine Tariel Kapanadze devices). (see attachment kapagen)

    These impulses are similar to those shown in the background of your "The Ray of Discovery - Nikola Tesla" video on Vimeo.

    However, there are some Kapagen device videos showing a vertical violet light without the horizontal impulses. (see attachment kapagen2)

    More interestingly, genuine Kapanadze device videos do not appear to show those lines at all. (see attached)

    This could lead one to conclude that the Kapagens shown are merely imitations or variants of the true Kapanadze device.

    So Duncan, is the head going into or out of the sand?.

    Leave a comment:

Working...
X