Announcement

Collapse
No announcement yet.

Imhotep's Radiant Oscillator Video

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • nat1971a
    replied
    @ALL

    RE: TESLA's TRANSMISSION OF WIRELESS RADIANT ENERGY

    ok i will try and put my own theory to this based on what Tesla has left behind....but you have to keep in mind that i dont have a background in electrical anything or electronics. So here goes

    An extreme high frequency positive potential is rapidily repeatly created and then stopped in the transmitter circuit which then creates a pump via the insulated high polish stainless steel sphere (the theory that i have read so far suggests that it (the sphere) is creating a vortex that is resonating with either the ether or with light or both)...which then pumps in more energy from the environment.......via resonance (of the ignition coil) this positive potential is transferred to the reciever ignition coil...(as i dont have a ground connected to the transmitter)......once this positive potential is in the receiver ignition coil this then sucks negative energy from the ground via my aluminum ground connection.....is stepped down...(i assume this steps down the frequency)...this energy is then available to run lights & motors....which is my primary goal......

    The higher the voltage input the more energy you will extract from the enviroment as the pump will be working harder (more efficiently)...

    Tesla wanted free energy for everyone.....well here it is folks.....it has taken me 3-4 years to understand it all....having no clues about electricity or electronics or what Tesla was saying...Just had a burning desire to stop paying electricity bills....The world can not continue the way it is going. Huge change is required and this will make it happen.

    Please replicate as fast as possible!!!!

    P.S This is basically how Tesla was powering his boat and probably his car (refer Tesla patent 613 809). Notice the transmitter in figure 9. Not sure what the batteries on the boat are for but they are not for running the motor that is for sure

    Last edited by nat1971a; 10-18-2008, 09:31 PM.

    Leave a comment:


  • Guest
    Guest replied
    Hi!

    Great job Nat and everybody else here! I think with the right theory behind the results will come 10 times faster.

    I just wanted to touch base and could tell you that Meyl made an experiment with microwave frequencies and capacitors. As we are talking about dielectric discharges from the capacitor(s) try to sheet it with some silver or other good conducting metal. I think he got about 5 times better Q value with a good silver sheeting to stop the potential vortices(dielectric current) from leaking away.

    Remember, everything is inverse. For hot current we insulate with dielectrics to stop leakage of Eddy currents, for dielectric currents we should invert this. So use a conducting sheet for better results, good luck!

    Maybe it will not work but logically it should.

    Another thing to check is the 1-wire system and the dielectric wires with nodes for perfect transfer. Meyk believes the MT will be dangerous for ecology and photosynthesis longterm. And after reading his book you will not microwave anything that you eat - ever again....

    Leave a comment:


  • Bodkins
    replied
    Originally posted by nat1971a View Post
    YouTube - BEDINI IMHOTEP BODKINS UPDATE9 RADIANT ENERGY - WIRELESS RAD

    mini update wireless transmission without charging battery
    is the receiver oscillating too Nat, in resonance to the first spherical electrode. identical frequency and opposite phase.
    and you say some bulbs not connected to anything! would be interesting if you give them a ground to flow too!
    Last edited by Bodkins; 10-18-2008, 07:23 PM.

    Leave a comment:


  • Bodkins
    replied
    Electricity in the Air | Popular Science

    What bugs me about this wireless energy they are doing now is tesla did it 100 years ago and it was free energy. Receiver getting more energy than transmitted kicked out in the scalarwave.


    It is like we are doing Lid, but they dont care for the crumbs we like picking up, thats the difference WE CARE.
    Braden,You found any relays in the uk yet, see one at halfords but its 30amps maplains has some but not right type
    Last edited by Bodkins; 10-18-2008, 06:52 PM.

    Leave a comment:


  • Hoppy
    replied
    Another observation is that charging can be improved by increasing supply voltage with virtually no change in supply current and no sign of contact arcing even in a darkened room. The radiant production at 24/36v on the scope is very impressive. I have also experimented with different charge battery voltages and am currently charging 2 x 12V batteries in series from a 24V supply. At 24V supply voltage the power consumed as measured with an analogue ammeter is 24*.01A = 0.24W.

    A very effective battery conditioner / charger should be possible at low cost by modulising to increase power.

    Hoppy

    Leave a comment:


  • braden
    replied
    new toy to play with

    Lid,
    I think this is the patent that refers to these devices 4685047
    looks like it would be simple for you guys to put together and try out
    radio.doc

    Leave a comment:


  • Lidmotor
    replied
    Electricity in the air---Noise in the air

    Braden,
    I went to that Popular Science link that you posted a ways back -- Electricity in the Air | Popular Science and mentally connected it to what Nat, Bodkins and I are doing. This technology that we are playing around with is already heading toward real products that we will be using. Tesla's day has arrived. I read the comments at the link, though, and I think that there will be a lot of resistance to it. One guy made the comment about people stealing the electricity that was in the air. As I remember that is what stopped Tesla. The big boys couldn't figure out a way to put a electric meter on the energy. No money--No more project.

    On another subject---The relay---I found an almost identical relay at Auto Zone auto parts. It costs $5. It seems to be a little quieter. Agongon--I like your new circuit diagram. I'll have to try it. All of my attempts to run the CFL off of the one source battery have failed. Hoppy---thanks for tip about the diode. I have tried the two relays that I have running together in parallel and they work fine. Amp draw doubles but who cares because they draw so little.


    Lidmotor

    Leave a comment:


  • Agongon
    replied
    Originally posted by Hoppy View Post
    The type of diode makes a lot of difference and I found that a UF4007 worked a lot better than an IN4007. The charging is good for such a low powered 'buzzer' type oscillator and I could see no spark damage to the contacts over a long period of running.

    Hoppy
    Yes Hoppy, you are right and I second that. UF4007 is a better choice.



    .

    Leave a comment:


  • Agongon
    replied
    The Imagination is the limit

    A concept of Multiple Relay Charger/Emergency Light. I haven't actualized this yet.


    .
    Attached Files
    Last edited by Agongon; 10-19-2008, 01:15 PM.

    Leave a comment:


  • Hoppy
    replied
    Hi ALL,

    I have tried out the Imhotep relay radiant oscillator and can run it down to around 7mA with the help of a magnet on the opposite end of the relay pole piece. The type of diode makes a lot of difference and I found that a UF4007 worked a lot better than an IN4007. The charging is good for such a low powered 'buzzer' type oscillator and I could see no spark damage to the contacts over a long period of running. This is a Bedini SG style charging circuit with the relay contact giving fast leading edge pulses resulting in good radiant energy production. I think that this circuit could be paralelled up to produce a more powerful charger.

    I've not yet established how high the charging battery will climb as it will take a very long time to get my 2.8A/hr SLA test battery up to the necessary 15V plus level.

    Hoppy

    Leave a comment:


  • nat1971a
    replied
    Bodkins,

    Yeah i will build 2x pancake coils next. Should be very interesting.
    I should have measured the voltage on the receiving coil....oh well its broken now anyway.



    Cheers

    Nat

    Leave a comment:


  • Bodkins
    replied
    Originally posted by byjoveoldchap View Post
    Haven't got a 40 amp relay yet, but I couldn't wait to test this out as I knew it was going to be be exciting

    Using a small 9 -12v circuit board relay, here are results so far:

    Supply voltage (Nicads) = 12.37v
    Capacitor voltage achieved = approx 80 volts
    Current being drawn = 8mA - (yes EIGHT)

    and the neon buzzes away beautifully with no load ~ ABSOLUTELY AMAZING ~ and only using 8mA...!!!



    NAT1971a EVERONE LOOK AT THIS YOU CAN BUY ONE
    XT-Commerce - Demonstrations-Sets
    *** CONGRATULATIONS Imhotep ***

    - I feel this device is going to explode with incredible test results and we'll see hundreds reproducing your idea on U-Tube within a few weeks.

    If anything can wake up the public to simple free-energy devices, THIS IS IT...!!!

    Now where can I find 50 old car batteries to charge all at once...?
    I get loads of old battery from the recycle depot they have tons of them all waiting for me to give them life!!!
    @Nat
    I dont think we will get energy transmission without the spiral Coil Number 8 style !!!!!! thanks Gauss !!!!!!
    Meyl - Scalarwave-Technology - The european website of www.k-meyl.de
    Listen to to radio interview he talks about understanding tesla patent. the best we can hope for is picking up Longitudinal Electric Waves, the ignition coil cant oscillating at megahertz.
    A very good read is http://www.k-meyl.de/go/60_Primaerli...ID_Eurasia.pdf
    The above web site it a gold mine

    EVERYONE LOOK AT THIS YOU CAN BUY ONE
    XT-Commerce - Demonstrations-Sets



    also more on earth batterys here http://www.pat2pdf.org/patents/pat600457.pdf
    Last edited by Bodkins; 10-18-2008, 11:08 AM.

    Leave a comment:


  • nat1971a
    replied
    just took her up to 72 volts and even the non converted cfls are lighting up now......but then something blew....might be the trannie

    Leave a comment:


  • nat1971a
    replied
    YouTube - BEDINI IMHOTEP BODKINS UPDATE9 RADIANT ENERGY - WIRELESS RAD

    mini update wireless transmission without charging battery

    Leave a comment:


  • nat1971a
    replied
    I just disconnected the charging battery...the neon fused.....and the lights are working heaps better

    Leave a comment:

Working...
X