Imhotep's Radiant Oscillator Video

[tai61]

555 driver

thanks bodkins
coil driver ran cfl not so bright, but charged gel battery good.
It was set at 133hz so i added 2 pots to it and wound it up to the highest pitch, both darlington and bulb went coldest i had felt ,got abit more liht outa cfl.
wanta hear some thing weird.
was using one battery to run light so added diode in4007 to negitive lead returning to battery from light, bulb went really dim but battery started charging itself up.
Has any body come across this,battery is running 555driver using 600ma, into coil ,plus a dim cfl and has gone up from 10.30v to 10.58v and climbing.
Can any one explain,cheers te.

[Bodkins]

howdy is anyone using a 555 driver circuit for the coil, im not getting as bright a light as the relays and would like to compare notes,any circuits for twin coils,double coils,cheers te

Hi tai61
the problem with the 555 is these no coil collapse to add the the ignition coil, the relay Back EMF is uesd with Low volts for the battery to light the bulbs.
I THINK THIS IS WHATS HAPPENING?????????
IMHOTEP can you verify this is correct Please
I only have one coil and its small.the draw around 700ma at the best brightness.
Im moving on to ignition packs. all fords in the UK use the same pack.

[patmac]

I hooked up the ignition coil as the power coil in the bedini circuit and then set it into self oscillation mode. Normally the wheel goes into self oscilation mode while balanced between the magnetic poles on the wheel. Pretty bright and cheap and charging my secondary banks better than before with the wheel running! Current draw is only 190-200ma in the picture.
Also observing a radiant effect whereby i can remove a connection in the series of bulbs and one or more will keep running with only one lead hooked up.
WILD! I love this stuff.

Heres a video to show what i'm seeing on Modvid.com

Or on Youtube, which ever you prefer.




I'm going to hook up my probes and try to get some scope shots to show.

Thedude....

Very well... you put a trigger coil on Bedini to activate Base transistor, and C-E activate the Car Coil? You save energy waste on relay or 555?

I was trying to feed the car coil with BackEMF from Bedini but is insufficient, my motor is a little. You setup seems ingenius...

[tai61]

555 driver

howdy is anyone using a 555 driver circuit for the coil, im not getting as bright a light as the relays and would like to compare notes,any circuits for twin coils,double coils,cheers te

[waterhouse24]

I'm now using my SSG Bedini computer fan to run the lights. By connecting a wire from the collector of the transistor to the negative of the coils it provides brightest light and no relay noise.. I can then use the potentiometer on the SSG fan to control amp draw.

I'm just playing around with using the relay along with the fan to see if it will improve brightness more.. at the moment all it is doing is adding amp draw but no extra brightness.

Like thedude I can stop the fan and it continues to light up even brighter!