Oscillating Reed Switch Pulse Motor.

[Allen Burgess]

Magnetic dip.

The power of the magnetic force in the "Coherer" range is very low, on the leval of the "Earth Field". To fully maximize the combination, "Magnetic Dip" needs to be utilized. The spinner would get it's peak propulsion from a circle of wire positioned so the plane were tilted on the angle of magnet deflection: The spinner would move on an overhead throw. The pulse power for this kind of "Earth Stator Rotor" would be in the very low "Coherer Locking Range". It might take a series of pulses to get a full revoloution to start; However, very high speed would be attainable. We could bleed the torque off one while a coupled twin accelerated for constant output.

[Allen Burgess]

"Earth Field Stator".

@Bob Smith,

Thanks Bob!

The "Earth Field Stator" Oersted spinner runs at Overunity because the magnet rotor is propelled past it's North dwelling position by the momentum, and only needs sufficient power to push it from there to it's 180 repulsion position. Nearly all the power comes from the combined repulsion and attraction of the Earth's magnetic poles after the rotor's turned around. This force powers the spinner for two or three free rotations before additional pulse power needs to be applied. Lawerance Tsung calls this momentum "Lead out Energy" and has achieved OU results this way with his "Fung Wheel".

I think the disproportion comes from "Shearing" into a "Perpendicular" propulsion.

[Bob Smith]

Great stuff! Following with interest.

[Allen Burgess]

Joseph Henry type remote magnetization.

I succeeded in remotely "Spark Locking" six 1/2 inch steel "Hex Nuts" with a loop of wire threaded through the center of the nuts and connected at both ends. This wire was the same length and gauge as the wire loop shorted between the 12 volt battery electrodes, and in close adjacency on the test bench.

This was the kind of experiment Joseph Henry conducted at Princeton in the 1850's, where he managed to magnetize sewing needles at a distance of 220 yards between a primary and unconnected seconday antenna with an electrical spark from Leyden Jars.

I'm betting right now that I can lock all 48 "Hex Nuts" at a few Hundred yards with an "Earth Ground" connected to the negative electrode of the battery, and an "Earth Ground" on the "Hex Nut" reciever antenna. The follow up experiment, after that, would involve multiple "Earth Grounded Receivers", each with sets of 48 "Hex Nuts".

It should be no problem to fill an acre of land with grounded "Earth Field Stator" Oersted spinners, all running off the same series of relay oscillating battery sparks.

[Allen Burgess]

"Earth Field Stator" Oersted motor magnet spinner

The stack of axial polarized neo magnet discs is so powerful, it acts as a compass needle when freely suspended from above. The magnets can be nudged into spinning full circle, after orienting the current carrying wire towards magnetic north directly underneath the (magnetic north south) pointing magnets.

"Earth's Magnetic Field" acts as a permanent motor stator for this kind of spinner! The magnetic field from the D.C. current in the wire that begins to deflect the magnet is as weak as the "Earth Field". The magnet rotor gets the powerful kick to spin it from the "Earth Field" pole repulsion at 180 degrees.

A limitless number of "Oersted Earth Field Stator" motor rotors could be powered up to very high speed by oscillatory current between the "Earth Ground" and the antenna of "Magnet Power" reciever wires, acting like "Wireless Telegraphy" coherers. The limitless number of rapidly spinning "Oersted Earth Field Stator" motor rotors could be powered by the fixed input of a series of spark gap broadcast "Earth Ground" and antenna pulses.

The frequency of the broadcast signal determines the exact length of the antenna wire to match the wave length. State of the art prismatic polygonal slot antennas can miniaturize this clumsy part of the reciever.

[Allen Burgess]

Infinite magnetic force.

Magnetic locking force is a function of conductor mass, not input alone, so it follows that infinite magnetic force can be produced through an infinite conductor (Earth Ground). That's how our first wireless telegraphy worked; A spark of limited input has the power to magnetically lock a limitless number of coherers all over the entire planet.

[Allen Burgess]

Wireless telegraphy grounding.

An interesting early exerpt on the subject of wireless telegraphy grounding:

"Each change or movement of a semiloop of electric strain above ground has its equivalent below ground in inter-atomic exchanges or movements of the electrons, on which the ends of these semi-loops of electric strain terminate. The Earth, must play therefore, a very important part in so-called 'wireless telegraphy,' and we might almost say the earth does as much as the ether in its production.

The function of the receiving aerial is to bring about a union between these two operations above and below ground. When the electric waves fall upon it, they give rise to electromotive force in the receiving aerial, and therefore produce oscillations in it which, in fact, are electric currents flowing into and out of the receiving aerial. We may say that the transmitting aerial, the receiving aerial and the earth form one gigantic Hertz oscillator".

[Allen Burgess]

"Earth Ground" as copper mass.

The "Hex Nut" locking test demonstrates the relationship of copper mass to magnetic force. What would the effect of a common "Earth Ground" have on the locking force between the high voltage D.C. spark transformer and the "Branly Coherers"? Tesla stated that the "Earth Ground" acted as an infinite conductor. The locking effect through a common "Earth Ground" should be equal anywhere on the surface of the planet!

"How an early radio using a coherer detector worked. ... early 1890s with Marconi's adaption of Branly-Lodge coherer about which a lot more will be said soon. ... A good earth ground is just as important as a high and correctly tuned antenna".

Oersted magnet spinners should rotate any where in the "World" the same way with an "Earth Ground" and antenna too!

[Allen Burgess]

Hi-voltage D.C transformer.

Hi Richard - Your order has shipped:

DC 3v-6v to 400kV 400000V Boost Step-up Power Module High Voltage Transformer

Estimated delivery : Thu. Oct. 27 - Tue. Nov. 15
Tracking Number : HK694127915PY
Shipping service : Economy Int'l Shipping

Next, I plan to try and lock those "Hex Nut" sets remotely as "Branly Coherers" with a 400Kv D.C. Transformer spark. The transformer is in the mail!

[Allen Burgess]

New video: Locking 48 "Hex Nuts" from a single spark.

(48) "Hex Nuts" locked off one spark: I checked the entire 48 nuts, and they all locked successfully. The two outer sets were 1/2 inch in diameter and the remaining 36 inner sets, 1/4 inch in diameter:

https://youtu.be/YeJ5wHBpaf4

This test video demonstrates the "Asymmetrical" relationship between the input and the work done by the magnetic force field in the wire. Doubling the length of the wire would potentially double the amount of locking force on additional "Hex Nut" sets for the same input.

[Allen Burgess]

"Hex Nut" locking setup video.

Here's another video showing the "Hex Nut" locking setup:

https://youtu.be/3LORQe7gzd4

The "Oersted" video shows a neo magnet stack rotating over a wire from a D.C. pulse; Like the locking experiment, a multitude of spinners can be rotated over the same wire for the same input.

The "Branly Coherer" locks six spheres through an antenna from a high voltage D.C. pulse. I believe it's possible to lock the "Hex Nuts" by high voltage D.C. pulse as Branly did his coherer spheres. Now, the possibility exists that we can spin multiple rotor magnets over the "Branly Coherer" antennas, as with the single wire "Oersted" rotor, for the same input with a high voltage D.C. pulse as well.

[Allen Burgess]

Hex Nut Test.

I bound six 1/4 inch Hex nuts tightly in a hexagram shape inside a long plastic zip tie lasso, and suspended the nuts over the test bench. I threaded a 12 gauge wire through a piece of duct tape with a hole cut through the center stuck to side the nuts. I bought a new 12 volt 10 amp motorcycle battery and am awaiting my Tica cell phone photographer to capture another exciting video. I'm proud to report that the first set of "Hex Nuts" locked tight like "Magic" with one solid spark. The plastic zip tie makes this test a snap compared to the miniature wooden table with the hole drilled through it that we see in the other "Hex Nut" test videos! The zip tie just slips off easily leaving the solidly locked nuts. The loosened nuts squeeze right back in the same zip tie loop for another "Locking Zap" after they're seperated. This setup will allow me to string multiple "Hex nut" sets each along side the other for any distance I choose. I want see how many nuts I can magneticly lock with the same battery spark for the record book! I plan to upload an exciting series of videos soon.

I succeded in locking three sets of "Hex nuts" for a total of eighteen nuts with the same single spark. I need to make another trip to the hardware store to buy additional "Hex nuts", but the results of this last test bears my theory out so far; This is proof I'm on the right track!

[Allen Burgess]

Branly Pendulum.

Here's the video I promised of the "High Voltage" ignition coil spark helping sustain the pendulum oscillation of a stack of neo-magnets:

https://youtu.be/Ep-H4J4TLu0

[sprocket]

Just thought I'd mention that I fried my bench PSU just by using it to power a 'tiny' 7kv one of those - it looks identical to the square one he shows near the end of the video. I did nothing other than power it from the PSU, but noticed while sparking, its LCD display would become corrupted. This 'feedback' eventually blew one of the op-amps inside. I also managed to kill a $100 Extech clamp meter with one of these, can't remember the details. After that, I concluded that me & HV don't get along! But I'd definitely recommend that you only power these from batteries.

[Allen Burgess]

6v to 400kv transformer.

I just ordered this 400kv D.C. transformer off ebay for $2.40 to test a long range "Branly (Hex Nut) Coherer": I plan to also run some multiple (Hex Nut Sets) locking tests off a 12 volt battery. I got the new digital camera to record.

DC 3v-6v to 400kV 400000V Boost Step-up Power Module High Voltage Transformer:


Here's one in action:

(Just fast foward to 7:33)

https://www.youtube.com/watch?v=c7elFC3CHKM