Oscillating Reed Switch Pulse Motor.

[Allen Burgess]

Spiraling plasma magnetic field lines.

"Electric currents, and in particular, magnetic-field-aligned electric currents (which are sometimes generically referred to as "Birkeland currents"), are also observed in the Earth's aurora, and in plasma filaments".

"However, the existence of charged particles causes the plasma to generate, (and be affected by), magnetic fields".

The image below on the left depicts "The complex self-constricting magnetic field lines and current paths in a field-aligned Birkeland current that can develop in a plasma."

It's obvious from the image of the (Birkland Current) on the left that the "Magnetic Field Lines" that are generated in the Reed switch plasma discharge, on the right, are spiraling!

[Allen Burgess]

zebok3 1 day ago:

"What the hell is that thing that appears to be spinning around in the back"?

Reply•1

gilbondfac, 2 hours ago,

"The engine? With LED's" !!

Not evidence of "Spin Waves"; but even more importantly; A demonstration of (Omni-Directionality) of "Plasma Arc" power transmission.

[Allen Burgess]

Half dome transmission coil.

Hooking "Tube Confined Plasma Arc Electrodes" up in series to this kind of coil should allow for omni-directional power transmission, and multiple spinners. We see pickup coils both in front of and behind "Gilbonefac's" plasma spark. This kind of (Coil Antenna) will amplify the "Spark Propagated Magnet Wave", just like the antenna on his "Coherer" piezo igniter.

[Allen Burgess]

Plasma tube.

The Reed switch is not really designed to handle a "Plasma Arc" like the (EMEM 3) tube below $219. This specially designed "Plasma Tube" has internal electrodes and wires attached to each electrode to which you can make your connections. This partially evacuated mini "Pyrex" quartz plasma tube comes filled with Argon gas and tungsten electrodes for longevity:

Bill's Plasma Tubes Gallery

"The final step is then to put the tube on a vacuum pump for several more hours to bring the interior to a near absolute vacuum. At this point, the tube is carefully filled with the required gas to the desired pressure, which is usually in the 6 to 10 mm of mercury range. Many don't realize that this "pressure" range is in reality, still at a near vacuum".

The Reed switch may be needed in parallel to "kick start"' the plasma tube arc with the "Simplefix2969" circuit. Then it can be switched off. The plasma tube in series with the coil turns the power coil into a magnet wave transmission antenna. A hemispherical coil may power multipal spinners. Remember, the Plasma discharge propagates a "Magnet Wave" unlike the transistor.

[Allen Burgess]

Coherer antenna.

At 2:50 in this video, Gilbondfac attaches an antenna to a piezo spark igniter to activate his "Coherer" from a distance. The antenna increases the broadcast strength of the "Magnetization Wave".

https://www.youtube.com/watch?v=Q1ohAfCdKvM

The bifilar power coil in series with the plasma charged reed switch begins to work as a transmitting antenna for the same kind of magnet wave. This steady plasma arcing propagates a vortex wave in the spinner field that powerfully accelerates the neo magnet tube.

[Allen Burgess]

Magnet spinning plasma.

"Gilbondfac" spins plasma with a rotating magnet in this video. Maybe a spark propagated "Spin Wave" can achieve a similar kind of effect, as it appears to do in the first video I posted above?

https://www.youtube.com/watch?v=TxNYO_2FMpI

[Allen Burgess]

Spark Powered Rotary Motion.

This very recent short video by "gilbondfac" shows a "Plasma Arc" not only broadcasting wireless power to light a neon bulb and run a fan, but if you look carefully toward the back you'll notice something that appears to be spinning around:
Evidence of a spark propagated "Magnetic Spin Wave"?

https://www.youtube.com/watch?v=wY3w3nzaWFg

I submitted an inquiry to "gilbondfac's" youtube video to learn more about this. The "Spin Wave" may be swirling a bulb plasma. This would still constitute a major cutting edge demonstration. It took the "Stanford Synchrotron Radiation Lightsource" project to profile this effect!

[Allen Burgess]

Wardencliffe coronal plasma.

Look at the "Coronal Plasma Spark Gap" in this preliminary Wardencliffe "World Power Broadcast Tower" drawing of Nicola Tesla's on the left:

The original spark gap transmissions were received by every "Coherer", regardless of distance or location. The longitudinal magnet wave is (Omni-Directional). A hemispherical power coil shaped like Tesla's Wardencliffe transmitting antenna, on the right, could run multiple neo magnet rotors with the same signal, from one single oscillating Reed switch plasma arc!

[Allen Burgess]

"The coherer could not detect AM (radio) transmissions. As a simple switch that registered the presence or absence of radio waves, the coherer could detect the on-off keying of wireless telegraphy transmitters, but it could not demodulate (rectify) the waveforms of AM radiotelephone signals".

The power of spark gap magnetization grew obsolete with the advent of radio waves!

Prior to this advance, Marconi magnetized metal filings across the English channel with sparks!

The important point here is that the spark is transmitting a magnetization wave. This thread is about a magnet motor. The main point here is that the vacuum Reed switch "Plasma Spark" has been experimentally observed by me to "forcefully" power a neo magnet rotor by "Magnet Wave Transmission" not ordinarily.

AM radio waves can't effect a neo magnet. A spark can!

[Allen Burgess]

Coherer.

"In 1835 Swedish scientist Peter Samuel Munk noticed a change of resistance in a mixture of metal filings in the presence of spark discharge from a Leyden jar".

Nearly 50 years later, in 1884, the coherer was invented by an Italian physicist, Calzecchi Onesti, pictured below: Ten years later in 1894, Marconi used it to make the bell of his first radio receiver.

https://www.youtube.com/watch?v=DX7cTJjqomg

What causes the nickel and iron filings to magnetize when Roobert33 clicks the spark on his barbecue igniter?

[Allen Burgess]

Bifilar plasma resonance

Building the "Simplefix2969" LC tank to resonate at the ultrasonic frequency of 44 KHz, and matching a spiral bifilar power coil built with the same self resonating frequency as the LC tank, (44 KHz), would synchronize with the "Plasma" frequency oscillation. A "Bearingless Neo Sphere" could then be powered up inside the coil core center with the plasma Reed switch attached to the spiral coil. The speed should stabilize at the (energy enhancement) "Plasma Resonance" speed of 2,640,000 RPM, a speed clocked by RWG, and run cold with quenching. Russ's compressed air spin floater might be the best approach at this point. Remember, the spark generated magnet wave behaves much differently then the transistor version.

[Allen Burgess]

Bifilar coil feedback on plasma tube.

The "Oscillating Reed switch motor" has the (plasma forming) Reed switch fixed to a series connected bifilar coil. "The Old Scientist" performs an experiment starting at 7:26 in this video where he demonstrates the "Energy Enhancement Feedback Effect" his bifilar coil has around a plasma tube at ultra sonic frequency:

https://www.youtube.com/watch?v=A0OuTDHTDOw

"The Old Scientist's" spiral bifilar coil goes into resonance in series with the plasma tube and the load at 44 Khz. Very similar to the "Plasma state Oscillating Reed switch in series with the solenoid bifilar power coil".

[Allen Burgess]

longitudinal plasma wave frequency.

The "Plasma Arc" propagates electro-magnetic waves randomly from every direction. The "Longitudinal Waves" occur at an irregular frequency, but act as rain drops on a paddle wheel; the "paddle wheel" is analogous to the "Spin wave" of the neo magnet rotor.

A magnet moved in parallel to coil windings has no influence on the flux, but turned 90 degrees generates power. The same holds true for the electro-magnetic wave.

More like throwing a box of toothpicks at something, every angle of deflection would contribute to a proportion of the overall magnetic "force-field".

[Allen Burgess]

"In longitudinal waves, the displacement of the medium is parallel to the propagation of the wave. Maxwell's equations do lead to the appearance of longitudinal waves under some circumstances, for example, in plasma waves".

So the longitudinal "Plasma Wave" is the transverse wave moving "Sideways", not back to front in the ordinary direction of propagation. You can see how the compression nodes of the longitudinal wave on the right, correspond to the parallel projection of the magnetic nodes of the transverse wave on the left, in the diagrams below:

The parallel projection of the transverse "Plasma Wave" causes the magnetic (Soliton Tsunami) "Spin Wave" that accelerates the neo magnet rotor in the "Oscillating Reed switch motor".

[Allen Burgess]

Plasma in a Reed switch and lightning.

Compare these photos below: This kind of lightning discharge, pictured on the right, successfully magnetized sewing needles at a distance of 20 miles on Joseph Henry's roof in 1843! This effect is far different from the broadcast and reception of radio waves.