Eric Dollard

[Sputins]

I would also suggest (along with Ajay) adding in a variable capacitor (combo of fixed and variable) to act as tank capacitor on your primary coil system. It does improve the system overall, or at least the the current draw on your transmitter should reduce. (But I don't know what kind of Z match system you have).

As a guess I'd say your two in phase primary circuit has an inductance of around 2 to 6 micro Henry's?

[Macak]

[mikrovolt]

Macak
I would not publish all at once. But show a logical development history of the experiment.
It is those few with appreciative feedback that deserve help in good Tesla replication.

I am happy to see the Dollard work continue in it's own contribution.

I recommend starting your own thread to be objectivel and to set the rules
for taming the wild cats that prowl from time to time.

The work is clever and well thought out.

[Sputins]

Interesting that the trash can provides a better counterpoise than the earth in the case where the bulb is in series with the neutral. Probably because it is under the effect of the near field of the driven coil. In either case the bulb reduces the neutral current and the E field of the coil compared to the hard wired neutral to ground. Also the Fo of the system goes up with the bulb in the circuit. Pictures below are for numbers 1,2 & 3 just above. The earth connection is in the floor, the current transformer threads into the top of the steel rod when connected

Yeah that is also an observation made by dR-green and myself that a capacity makes a better counterpoise than a ground. The displacement current tends to flow towards a capacity. So your bin would fit this requirement well.

That is all for now, I have lab notes and images for more transmission mode experiments performed outside last winter / spring where the neutral wire was up to around 300 feet long with excellent energy transmission.

[Ajay]

Litz wire and the coil Q factor

Hello everyone,
I came across a very interesting link describing how a coil with solid wires has roughly 1/6 the Q factor compared to that of litz wire (wire with multiple fine strands of copper). He also says that litz wire reduces the losses due to wire spacing considerably compared to solid wires.

Here is this article:Q of ferrite-rod inductors & contra wound coils, applied to crystal radio sets

Another interesting thing in this article is the comparison of the Q factors of normal coils compared to that of contra-wound coils (aka bucking coils). Apparently contra-wound coils have a higher Q at higher frequencies than a similarly constructed regular coil.
I wonder why Eric doesn't use litz wire in his coils to raise the Q factor?
Nikola Tesla also said this kind of wire would be ideal for coils but he said it was "not to be had" in his era.

There appears to be no advantage to using solid wire in the construction of these coils (edit: except for the ease of the surface area mathematics). Please let me know if I am overlooking something.

[Ajay]

White Plasma Globe

I think the whole globe will light up brilliantly white with a properly tuned coil.

I saw evidence that my assertion (quoted above) was correct in this link:
Flat Spiral Secondary and Longitudinal Waves Experiment - Plasma Balls and Conclusion
If you have not been to this guy's page, I recommend checking him out. This article was specifically interesting because he is using a schematic nearly identical to mine, and he is operating a plasma globe with it just as I did. As you can see, the plasma he produced with his spiral wound secondary was very different from mine. In one picture it even appears brilliantly neon green and white uniformly throughout the globe. Obviously that doesn't happen in ordinary plasma globes.

This is a simple experiment is significant in Tesla research because Tesla often spoke about how his single terminal globes where the ideal terminal capacitance in some respects (greater capacitance than surface area).

The globe is also a homemade superluminal particle accelerator (and collider) according to Tesla's theory of how his single terminal light bulbs worked. Not bad for a $30 home experiment. I hope that more people attempt this experiment so we can catalog the plasma effects (i.e publish the pictures).

[Aaron]

Recording of Live Call

Live Q & A with Eric Dollard, Feb 21, 2016 - Eric P. Dollard - Official Homepage

[Sputins]

I saw evidence that my assertion (quoted above) was correct in this link:
Flat Spiral Secondary and Longitudinal Waves Experiment - Plasma Balls and Conclusion
If you have not been to this guy's page, I recommend checking him out. This article was specifically interesting because he is using a schematic nearly identical to mine, and he is operating a plasma globe with it just as I did. As you can see, the plasma he produced with his spiral wound secondary was very different from mine. In one picture it even appears brilliantly neon green and white uniformly throughout the globe. Obviously that doesn't happen in ordinary plasma globes.

This is a simple experiment is significant in Tesla research because Tesla often spoke about how his single terminal globes where the ideal terminal capacitance in some respects (greater capacitance than surface area).

The globe is also a homemade superluminal particle accelerator (and collider) according to Tesla's theory of how his single terminal light bulbs worked. Not bad for a $30 home experiment. I hope that more people attempt this experiment so we can catalog the plasma effects (i.e publish the pictures).

[Ajay]

Plasma Globes vs Tesla Bulbs

Yes that was me. I realized I had a dozen more questions about an hour later, so I am going to have to write him a letter (the old school way). I am sorry to hear about your health issues. I hope they work themselves out. You may want to try constructing this and using it as an elevated capacitance: Construction details for the Life Field Transformer device
It outputs a leftward spinning circularly polarized wave which is healing to all biological systems. I have been testing it on dying plants and it seems legit. One of my plants made a full recovery very quickly after looking like it was going to die.

As for the Plasma globe, I realize that it is not an ideal or legitimate replication of Tesla's bulb. In my plasma globe I replaced the swarf with a copper ball. However, isn't carbon a dielectric? I was confused by Tesla's description because how can you connect carbon to the terminal of a coil and have it act inductively on plasma if it is non conductive?
I figured that the conductive terminal must therefore be covered by the carbon inside the bulb. If that is the case, then the plasma globe is not too different from his style of bulb. The plasma globe does appear to add a large capacitance even though the plasma is not directly connected to the coil (dielectric discharge in the plasma).

[Risbo]

Hi!

There are such things as "undertones" although acoustic instruments don't naturally tend to produce them.

The table doesn't show what happens at higher frequencies. Is there no resonant peak above the fundamental?

[edit] But again, harmonics in this context usually refer to harmonic frequencies produced by something oscillating, as in a harmonic spectrum of an oscillating string at a fixed frequency. Resonant peaks are different. Is this a harmonic spectrum, or a graph of the resonant peaks after doing a frequency sweep? I notice Eric refers to them as a "resonant series" in the diagram and not "harmonics", suggesting it's a series of resonant peaks found when doing a frequency sweep.

Will you be kind and explain what do you mean by term"undertones" in the context of Tesla Coil structures?

[Aaron]

Eric Dollard Live Call Tomorrow

If you have any questions for Eric, we have a live call tomorrow:
This coming Sunday the 27th at 11AM Pacific Daylight Savings Time

[dR-Green]

You look like a Lilliputian with those coils! Impressive stuff. Welcome aboard, thanks for posting your experiments!

[dR-Green]

Hi!

Will you be kind and explain what do you mean by term"undertones" in the context of Tesla Coil structures?

I wasn't referring to Tesla coils, but music. But in basic terms it's the opposite of overtones. It's harmonic frequencies which are below the fundamental frequency, rather than above it. A cymbal for example can produce undertones, because the initial crash can have a certain (high) pitch and a broad range of frequencies somewhat similar to white noise, but a heavy cymbal continues to resonate at a frequency which may be below the initial crash pitch and that continues to ring after the high frequencies have faded.

[David G Dawson]

Eric Dollard Live Forum

Eric Dollard Live Forum:
A question for Eric:
What would be the best application for your 2C22 'Regenerative Magnifying Receiver' (RMR) to be used for - picture attached?
Was this intended as a receiver for the 'Crystal Set Initiative' (CSI) and how was it to be applied and over what distance as an example?
What was the input required or was it just the Telluric Radio Station signal that was to be detected/received?



I also built your 6SN7GT CRI/CSI (Crystal Radio Initiative) Triode Driver.
This has lead to the building of 4 x 6BQ7 amplifier/drivers for use with an Implosion project I am currently working on.
NO solid state allowed.

I am attempting to get back to all of this but have too many projects currently in the build state.
By the way the Lester Hendershot device did NOT work but have intuitions that may help in resurrecting this device when time permits.



My CSI is still working as is the Cosmic Ray Detector (CRD) and have attached some pictures for reference.
Thankyou.

Smokey

[Aaron]

question for Eric

Hi Dave,

Eric won't be able to see these but I'll see if I can ask him on the call.

Eric Dollard Live Forum:
A question for Eric:
What would be the best application for your 2C22 'Regenerative Magnifying Receiver' (RMR) to be used for - picture attached?
Was this intended as a receiver for the 'Crystal Set Initiative' (CSI) and how was it to be applied and over what distance as an example?
What was the input required or was it just the Telluric Radio Station signal that was to be detected/received?



I also built your 6SN7GT CRI/CSI (Crystal Radio Initiative) Triode Driver.
This has lead to the building of 4 x 6BQ7 amplifier/drivers for use with an Implosion project I am currently working on.
NO solid state allowed.

I am attempting to get back to all of this but have too many projects currently in the build state.
By the way the Lester Hendershot device did NOT work but have intuitions that may help in resurrecting this device when time permits.



My CSI is still working as is the Cosmic Ray Detector (CRD) and have attached some pictures for reference.
Thankyou.

Smokey