3 Battery Generating System

[i_ron]

David Turion of three battery fame recently posted instructions on how to wind a “speed up under load” coil.

Here is my effort at a 12 stand coil. In this test I have it wired as 6 strands in series and then the two in parallel.

He suggests a variable speed drive to find the sweet spot. Lacking that and always used to using the RV as test bed I carried on as usual. The RV is very precise as a reverse prony brake, 10 watts out and you look over and the input has gone up 10 watts (or more)

I had tried this new coil the other day with an 8 inch 8 magnet rotor and nada. Being limited to 1760 RPM has it’s limitations.

However, using my 24 magnet Phil Woods rotor I get a more pleasant outcome. I am only getting 5 watts output but the input went down 5 watts! Running at speed with no load and the input draw was 70 watts. Rectifying to DC and with a 20 ohm load I get 5 watts output and a 65 watt input.

A work in progress at this point but exciting to pursue this promising concept.

Thanks Dave

Ron

[IMG][/IMG]

[ewizard]

Hi Matt,

On ebay, there are cheaper choices vs the amazon offer for the same boost moduls that now failed for you. See this for instance:

https://www.ebay.com/itm/1500W-30A-DC-DC-Boost-Converter-Step-up-Power-Supply-Module-10-60V-Out-12-90V/263548581479

A search yields these other choices too:

https://www.ebay.com/sch/i.html?_from=R40&_trksid=m570.l1313&_nkw=1500W-30A-DC-DC-Boost-Converter-Step-up-Power-Supply-Module-10-60V-Out-12-90V&_sacat=0

I compared the ebay and the amazon moduls by the photos and they look identical, hopefully they perform also equally well in practice.

Gyula

Same thing here from Los Angeles and about 3 bucks less than Amazon:

https://www.ebay.com/itm/1500W-30A-DC-Boost-Converter-Step-up-Power-Supply-Module-In10-60V-Out-12-90V-NEW/273212835558?hash=item3f9cc106e6:g:u~oAAOSwiw9a-aHE

[i_ron]

**I_RON and Wanttomake
You both have my email, send me a message and I'll send you a schematic. Its worth trying.

Cheers
Matt

Matt, email on it's way

Gyula, I sent for the aliexpress one the other night. I am prepared for a wait!

Funny, I sent for two of the little buck converters recently and they were here in a week...first time that has happened. On an order, back in march, the item was here after a month according to the tracking info but was another month before it came to the door.

Mostly though I like Digikey... here the next day at noon generally/

Ron

[Matthew Jones]

The only test I was trying to show was a boost converter off the battery. The positive of the boost converter going to the positive of the inverter. The negative of the inverter going to the input + of a buck converter and the buck converter hooked the original battery.
Similar to what David showed the other day but with the buck converter.

Just the COP you can get from that circuit alone is pretty amazing in most cases. Some loads loose a good bit of power but most return a good bit. This is becomes real visible if you track the whole path with good amp meters and watch the potential difference closely.

I am going to put a couple together tuned just for the job I was trying. Sucks for you guys cause none of you put electronics together, but I think its worth seeing, that you can pull 2 common circuit on a battery and raise the efficiency 2-3 times, no magic just a little different wiring.

Matt

[Matthew Jones]

Hi Matt,

On ebay, there are cheaper choices vs the amazon offer for the same boost moduls that now failed for you. See this for instance:

https://www.ebay.com/itm/1500W-30A-DC-DC-Boost-Converter-Step-up-Power-Supply-Module-10-60V-Out-12-90V/263548581479

A search yields these other choices too:

https://www.ebay.com/sch/i.html?_from=R40&_trksid=m570.l1313&_nkw=1500W-30A-DC-DC-Boost-Converter-Step-up-Power-Supply-Module-10-60V-Out-12-90V&_sacat=0

I compared the ebay and the amazon moduls by the photos and they look identical, hopefully they perform also equally well in practice.

Gyula

Ya but you got wait a month to get it at least where I am at, about as far away from china as you can get in America. Amazon makes sense with free shipping.

[wantomake]

Smoking components

I spent more money on smoking parts than anything else.

Sent you an e-mail.

Thanks Matt,
wantomake

[gyula]

Hi Matt,

On ebay, there are cheaper choices vs the amazon offer for the same boost moduls that now failed for you. See this for instance:

https://www.ebay.com/itm/1500W-30A-DC-DC-Boost-Converter-Step-up-Power-Supply-Module-10-60V-Out-12-90V/263548581479

A search yields these other choices too:

https://www.ebay.com/sch/i.html?_from=R40&_trksid=m570.l1313&_nkw=1500W-30A-DC-DC-Boost-Converter-Step-up-Power-Supply-Module-10-60V-Out-12-90V&_sacat=0

I compared the ebay and the amazon moduls by the photos and they look identical, hopefully they perform also equally well in practice.

Gyula

Here's a big boost module and they run in parallel and they run well.

https://www.amazon.com/DROK-Numerical-Regulator-Converter-Adjustable/dp/B076TTBKFG/ref=pd_sim_23_1?_encoding=UTF8&pd_rd_i=B01GFVI6R6&pd_rd_r=WSKY22X6R2AK0DH965EW&pd_rd_w=cYQwR&pd_rd_wg=rdzxG&refRID=WSKY22X6R2AK0DH965EW&th=1

Matt

[Matthew Jones]

Funny thing happened today. I was filming what I wanted to show you guys today and I started to blow fuses in my boost converter's. The batteries go negative often on me and start sucking current through the circuits, and since returning power to the source battery or a secondary battery is part of the entire load of this circuit it adds up in current and the components can't handle it.
I intend to get some new batteries soon so I can avoid this but for now both my Boost Converters are scrap parts. Some of that was greed, I was trying to show 300 watts running at a cost of about 90 watts giving me a cop of about 3.3. I felt really pissed about it until I found out people are trying real hard to obtain information that I have yet to give out. People who write books and sell information. People who would not pitch one fu**ing dime into a project but would happily run off with what you offer and make money from it. People who snake their way into the door with false promises of research money and favor.
"Matt, If you build it and pay for it, we'll all get rich!"

So a bad day again turned into a blessing.

I wanted to give a little and see you guys move forward but this is just how turns out every time. To many events for one day.

**I_RON and Wanttomake
You both have my email, send me a message and I'll send you a schematic. Its worth trying.

Cheers
Matt

[ilandtan]

Neight,
I think you will find that battery one will hold its own. It is usually the second battery of the two in series (the one with the neg connected to the neg of battery 3) that tends to drop in voltage. You will get some charging of batt 3 and then it will level off. At this point the two batteries will hold level for a while and then #2 will begin to lose a little charge. This is when I will shut it down and allow my batteries one and two to recover. If you push it too far, they won't. The longest I have had to wait for full recovery is two days. But I have been running loads on battery three for "free" during the time it was running. My next attempt will be to switch my motor to between the two NEGATIVES at this point and see if I can flip the polarity of the batteries back the other way. Run it this way for a while, and then go back to splitting the positives again. Once that polarity has flipped and run that way for a little while, that's when we lose the ability of the system to generate power without USING power. Getting it to sustain the power production without using power requires a VERY SPECIAL battery in the third position. You need one that will still let current flow, but will NOT accept a charge AT ALL. Totally sulfated!!! This will be very hard to find. Possibly switching the motor to between the negatives and then back to between the positives will extend the power production window. I don't know. That's what I will be working on tomorrow, among other things.

You may find that this setup "fixes" your bad battery. I have 'fixed" several. LOL It really ticks me off!

David

If a battery is a chemical/electrical relationship, maybe you can fool around with the chemistry, like diluting the electrolyte. I know you can buy unfilled batteries that send you the acid to add after transport, which mean you can mess with it.

Maybe use a saltwater battery? Saltwater allows current to flow, so maybe you have created a device that doesn't hold a charge but but allows electricity to pass and allows gain from an ancillary effect such as Casimir.

[wantomake]

Ready

I'll be early with note book and coffee ready to go.

wantomake

[Matthew Jones]

I am not sure anyone can patent the little I am going to put on here but you could cut your electric bill in half or more by scaling it up. You could double the output of a solar system either by wattage or time if you run an island. Cost a bit though to go that big.

Anyway I didn't get to the store today but I am going first thing morning and everything else is pretty much setup so I'll get the film up for sure in the morning.

Matt

[wantomake]

The curtain

I'm afraid to look behind the curtain. There might be people behind it leaning and bending or squatting.

If by some crazy chance someone got your ideas I very seriously doubt tptb would allow a patent. Just my arm pit opinion. Cause I couldn't afford such.

If by chance in next few days I actually get one of these setups replicated, I'll share here and be serious again.

For now just need to lean west and go down to the shop located east of Mississippi River.

wantomake

[i_ron]

You watch, if Matt shows this circuit, some guy or gal will build it, make a video, and start a Kickstart campaign to creates a larger free energy device. Without ANY understanding of the principles behind it or how to scale it up. Which is why we have shared so little of what’s behind the curtain.

And it won’t work for him anyway, because he forgot which direction to lean while building it. Lean East of you are West of the Mississippi or West if you are East of the Mississippi. Unless of course you are below the 40th parallel. In which case it is reversed. If you are outside the US, you have to bend over backwards. Sorry, it’s the 13th law of Thermodynamics. By the way, truly, no laws of Thermodynamics will be broken by this prototype. By THIS prototype.

And no good deed shall go unpunished!!!

Ron

[Turion]

People

You watch, if Matt shows this circuit, some guy or gal will build it, make a video, and start a Kickstart campaign to creates a larger free energy device. Without ANY understanding of the principles behind it or how to scale it up. Which is why we have shared so little of what’s behind the curtain.

And it won’t work for him anyway, because he forgot which direction to lean while building it. Lean East of you are West of the Mississippi or West if you are East of the Mississippi. Unless of course you are below the 40th parallel. In which case it is reversed. If you are outside the US, you have to bend over backwards. Sorry, it’s the 13th law of Thermodynamics. By the way, truly, no laws of Thermodynamics will be broken by this prototype. By THIS prototype.

[i_ron]

Here is the two battery system running on the atc 422.

Just on the 10 minute setting ATM but can change over to hours at anytime.

Running two boost converters as the atc 422 wants 24 volts to run.

Charging a third battery with the fly back, so system is doing work.

Ron

PS: my nephew was into demolition so collected a lot of air conditioning controls the atc 422 was one such item... I wouldn't want to buy one at today's prices.

[IMG][/IMG]