Announcement

Collapse
No announcement yet.

Imhotep's Radiant Oscillator Video

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Hoppy
    replied

    Aromaz

    From the video shot, your pos analogue meter lead appears to be plugged into the 10Amp socket. Check your manual on this because I think this should be just for the 10Amp current range?

    Hoppy

    Leave a comment:


  • Aromaz
    replied
    Thanks

    Originally posted by Inquorate View Post
    Try conditioning new master transistors with pulses from imhotep fan or imhotep self oscillating relay - to base, first..........
    Will play around more later this weekend, now got to get my nerves calmed down, or.....

    Re coil: Remember in one video I think / I said there is something more about the coil. I am much furhter develloped, so do not mind sharing it now. Bi-filar coil around fluorecent tube - the end of the one wire became the beginning of the reverse flow. Tesla's style in one of his patents. It magnifies the energy exponental.

    If you do not understand this, I can explain more later.

    Leave a comment:


  • Aromaz
    replied
    I did and lost it

    Originally posted by nat1971a View Post
    i have wondered for quite a while why not many people experiment with vacuum tubes especially when i think edwin gray did and Tesla apparently did with his car....makes a lot of sense to start experimenting with them

    Leave a comment:


  • Inquorate
    replied
    Conditioning, one wire, no wires

    Try conditioning new master transistors with pulses from imhotep fan or imhotep self oscillating relay - to base, first. Then they should respond to aether waves from ignition coil and system will self oscillate.

    @Aromaz - when I was charging battery with only one wire from pos of secondary of ignition coil to bat pos, battery did charge. I then tried wireless transmission of energy across air from point of alligator clip to cap connected to bat pos. Didn't charge until I put ground wire on bat neg.

    My point being, you have one wire to cfl's on your vids. Try removing that wire, grounding cfl's instead. They should light up. Also try wrapping long fluro tube in alternating layers of wound copper wire - insulation - aluminum foil with holes - insulation etc. Might give auto intensifying effect.

    Leave a comment:


  • Aromaz
    replied
    Last edited by Aromaz; 01-14-2009, 07:35 AM.

    Leave a comment:


  • ren
    replied
    @ Aromaz.

    I replicated your circuit this morning after some minor problems. It appears there are a number of 2222's around, mine is KSP2222a and pins are opposite to 2n2222a.

    First off.

    1 light wouldnt start. I had to touch the base of the 2222 and it would run. Take my finger off the base, it switches off.

    With three lights touching the base starts them and they keep going when I remove my finger. All are dim compared to my replication, but amp draw is also microscopic non polar cap in a series LC with the power coil changes the frequency. More tests to follow. No ground connection off the emitter of 2n2222 as yet.

    Leave a comment:


  • Inquorate
    replied
    No, I'm brian

    The link re tesla car was by me :-) there's another link I didn't post, at bottom of page called 'another version' or something. Read that too. Also the link someone posted re moray book. And... Here's a link about the testicata machine also very interesting.

    Paul Baumann: Testatika Generator (Methernitha Group)

    @Aromaz. Don't forget that these lcw in aether supposedly self multiply when they encounter segmented surfaces. Tesla started scratching grooves in his caps. Also, he says the small wire on secondary coil of his transmitting tower was not an issue with the millions of volts, as it treated it 'like' a solid pipe of same diameter.

    In G Vassilatos book, he claims tesla was auto magnifying voltage 10,000 times with each inch of single turn copper helix.

    Also remember radiant event travels at right angles to current flow (when it's a dc pulse) -

    And tesla magnified negative OR positive aspect of aether waves, depending on wether copper helix was placed (or was it spark gap was placed?) nearer pos or neg terminal of dynamo (high pressure dc source)

    Anyway, food for thought.

    Leave a comment:


  • nat1971a
    replied
    It is also interesting to note that aromaz is now using 6 transistors and getting awesome results....and Tesla apparently was using 6 vacuum tubes on one side of the AC motor and 6 on the other side.....coincidence...maybe.....but my instincts tell me otherwise...
    Last edited by nat1971a; 12-04-2008, 02:40 AM.

    Leave a comment:


  • stringguy
    replied
    this is probably silly, but the thing that stood out to me reading about the tesla car was the box and rod measurements:

    24 inches long, 12 inches wide and 6 inches high. Two rods 1/4" in diameter stuck out of the box about 3" in length.

    24,12,6,3 hmmm its prob nothing...dont mind me,

    Leave a comment:


  • Inquorate
    replied
    Ps

    If I'm right, a conditioned battery or capacitor will spontaneously charge, wether in naturally existing longitudinal compression waves in the aether (that's getting boring to write. Abbreviated : lcw) or artificially created ones.. While a non-conditioned bat or cap will not. It's possible tesla didn't know this, his tower probably conditioned everything for miles around. I can't remember who was collecting natural waves from aether using big metal sheets on their roofs to a cap and diodes, or even if they were on this group, but their movies are on youtube. If the caps were conditioned with super high frequency dc pulses of lcw, maybe would work better than unconditioned cap setup too.

    If someone is going to their local for new parts, cap/bat could they test this? My parts all been in this field and I'm flat broke right now so can't do.. As usual, must live vicariously.

    Leave a comment:


  • nat1971a
    replied
    come to think of it we are actually given the apparent part number Tesla used in his car

    12 Vacuum Tubes (70L7-GT rectifier beam power tubes)

    this is from the link that aromaz posted on the previous page.....

    Leave a comment:


  • nat1971a
    replied
    i have wondered for quite a while why not many people experiment with vacuum tubes especially when i think edwin gray did and Tesla apparently did with his car....makes a lot of sense to start experimenting with them

    Leave a comment:


  • Inquorate
    replied
    no, I'm brian

    No, I'm brian, and so's my wife :-)

    Leave a comment:


  • hh1341
    replied
    I too, am going to start playing with vacuum tubes.

    Carl

    Leave a comment:


  • Inquorate
    replied
    Addendum to above

    When we touch base of transistor, or hold hand near it, we are increasing capacitance (or supplying a few electrons) - the extra capacitance as we know catches aetheric waves, either natural frequencies or our own created ones. These aether particles grab electrons and feed them to semiconductor (P), and switch goes on. Over time as atomic latticework of semiconductor alters to respond to positive aether particles, capacitance required would be less, and the system gets ever more touchy.

    Leave a comment:

Working...
X