Tiger's Device 0.150-1Kwt replicant

[Ganzha]

Utkins Free energy oscillogramm

Hey! Utkin maybe right!
there is my oscillogramms!

[Groundloop]

I don't want to make a big thing of it, I'm just saying what I think I seen.

Looks like 0.11 Amps to me.



Uploaded with ImageShack.us

Cheers

P.S. I'm not questioning his math I am questioning the validity of the meter
reading. Doesn't matter to me either way of course.

..

Hi,

There is two bulbs connected to the transformer. The first light bulb has no on/off switch.
The second light bulb has a on/off switch. The last video frame shows the unit with
the second bulb switched on. Thus, the input current has gone up to 0,11 Amp.

GL.

[Duncan]

a stich in time

Hey! Utkin maybe right!
there is my oscillogramms!

There is a lot to digest, Its rather like Aidal,Tiger,Wesley and Arunas have knocked the first brick out of the wall. I wonder how long Utkin has waited until he thought it was safe enough to release the information? anyway its out now!

[Duncan]

Aetheric power

I.M.H.O luminous Aether as Tesla explains is a essentially a linear wave seen here thundering into this essentially mechanical machine (perhaps) varying with speed and slowly fading at the end of the Vid.F.M.CHALKALIS ENERGY MULTIPLIER - YouTubePart 1 of 6: Eric Dollard Tesla Longitudinal wave Energy SBARC Ham Radio with Chris Carson - YouTube if you are interested in building anything at all then this simple construction will very soon demonstrate the power source of this machine and a clear demonstration of the linear wave.http://freeenergynews.com/Directory/...pr-21-2011.pdf

[Farmhand]

Hi,

There is two bulbs connected to the transformer. The first light bulb has no on/off switch.
The second light bulb has a on/off switch. The last video frame shows the unit with
the second bulb switched on. Thus, the input current has gone up to 0,11 Amp.

GL.

Ok then that explains that, I still question the accuracy of the meter when
measuring those small values and less than sine wave input-output. Is the input and output 50/60 Hz AC ?

When measuring the output the meter says 1.60 A then he has another go
and it reads 1.68 A, that's an 80 Ma variation. It's the meter that causes me
not to be convinced. Going by the sound it is emitting I'm guessing there is
some pulses, and both input and output are not sine wave or 50/50 AC square
wave, but hey what do I know, I'm no expert so don't pay much attention to
me. Lots of people can show over 100 % out but is it really OU ?

If it is legit where can I get a schematic ? Is there any replications yet ?

If it is legit someone craving OU should replicate it.

I can show over 100 % output to input too with meters, and the resistor
method measuring DC too, but mine was not OU because of the pulsed output
and input, I am still waiting for someone to call me on it but it didn't happen
yet. AC can be pulsed AC too.

Not to worry I eagerly await a replication.

Cheers

[Michael John Nunnerley]

supper conductor or no supper conductor

I just want to explain what goes on with an electron discharge, this is a proven fact by others whom devote all their time to science.

Through winding of coils as predominently CAPACITIVE as I have explained before, there are three phases as to what happens, avalanche, streamer and decay. In the avalanche phase the seed electron is released from the cathode and during it's travel to the anode, IT MULTIPLIES. In the streamer phase when the multiplied electrons reach the dielectric, a streamer form occurs and approaches the cathode, in this phase the CURRENT and the ELECTRIC FIELD INCREASE RAPIDLY. In the decay phase the discharge is collapsed and so accumulates surface charge onto the dielectric barrier.

In this case the conductor is a PLASMA, "supper conductor" maybe depending on each persons view, but the important parts are electron multiplication and current, and electric field increase which is picked up by the secoundary coil of the transformer for free (the output must be LOADED or the input wattage will increase due to accumulated surface charge.

Mike

[Duncan]

Well it's all interesting. I have put the coil that I have shown on a HV supply to see what the frequency is to vibrate the ferrite "make it sing" before I rap the other coils over the top at 90 degrees, of course those will change the frequency as will driving those coils, but I just wanted to prove the theory that this linear coil made as a capacitor and not a coil, would do the job. Well with just 12v into the ign: transformer coil, SHE SANG LIKE A BIRD at just one frequency input but radiated harmonics that were of equal power, I just may do a video of it if I have time.

Normally you would expect the harmonics to be of lower power, steps, but these weren't, very encouraging. Also by putting a small piece of transformer lamina plate at right angles to the coil I could draw sparks off it, but direct to the coil NO, also very encouraging, can't wait to wind the other coils. Electrons are radiating into this 2.5" X 1/2" plate and putting a charge on it.

Also noticed that the ferrite warms up from the vibration after a couple of minutes, but at this low power level 6KV+- there is not a problem, but at 20-30KV might be another thing, I think I will start at around 15kv which is where the electron beam is visible

Mike

There is no diminishing in power all the harmonics are of equal power! Within the limits of the spectrum analyser and experimental error of course.
That represents a huge increase in available power! How efficiently it can all be harvested is a different matter of course. I'm lower down the food chain than Mike but this very simplified view I have formed works for me.! We are considering a phenomena that is supposed to be impossible and so we each resolve as best we can and put it into workman like language, A chemist would no doubt view the events from yet a different stance. I'm afraid I have to KISS but its spiffing to know it all fits into the big picture.. .

[cikljamas]

Let me amuse you with my new video inspired with Alexandar Kugushov video and also with one Duncans earlier in this thread linked video...

Maybe there would be some good and educational comments on this video, especially in a sense of already put question in my earlier post: how to wound transformer to achieve Alexanders result?

Or which combination of (in stores available) transformers we could use to get closer to Alexanders result?

My video is just demonstration of working principle, i am not claiming no claims, and there is no reason for that also, but there is hope to make much, much better results...

And bonus manifestation of this vid are blue rays, notice that when i disconnect third of four cfl bulbs (i disconnect them one by one), manifestation of blue rays phenomena stops, and when i again became to connect cfl bulbs which i disconnected in my previous steps, blue rays start to be noticeable again...

Enjoy...

P.S. As in most of my vids in this vid too there is at least one funny moment when at the end of the vid i failed to connect last (forth) bulb and then i expeled one famous croatian curse (**** hitler), that is why this video i was called by that name...

[RAMSET]

Shared your work

cikljamas
I shared your work here
New Overunity Transformer from Alexander Kugushov

The more eyes the better!!

Thank you
Chet

[Slovenia]

Tiger Query

Does anyone know Tiger's full name and where he is from. I'd like to see if we can find more information about his device another way but I need to know his full name and where he's from to do that. Thanks!!

We may be able to expedite this process a bit.

[hartiberlin]

Let me amuse you with my new video inspired with Alexandar Kugushov video and also with one Duncans earlier in this thread linked video...
.

Hmm ??
Please post a circuit diagram. It is very confusing what you are doing there,
Many thanks in advance.

Regards, Stefan.

P.S: The blue rays are just from overexposure of your camera CMOS or CCD sensor...

[TEKTRON]

Hmm ??

P.S: The blue rays are just from overexposure of your camera CMOS or CCD sensor...

Only one way to find out for sure, that I can think of any way. Rotate the camera while filming. If the rays stay vertical on the recording then it is over exposure. I think.

[RAMSET]

How its done

Cikljamas
Do you have a schem??

@Haan
"How its done"
"We are posting comments on the blue Ray over here"

http://www.energeticforum.com/renewable-energy/9890-visual-phenomena-observed-tesla-tariel-kapanadze-etc-research.html

Thanks
Chet

[Slovenia]

Replication

I have a really good friend who speaks fluent Russian and he knows of this device. He says it will provide 10 KW of electricity. Anyway, he says that there is enough information posted at the Russian site to replicate this device with no problems.

Russian Site:
FreeEnergyLT / FreeEnergyLT

[cikljamas]

circuit + bonus circuit

Hi guys!

I was busy today, so i couldn't see until now your requests for my schematic, and i have worked today on one another super schematic and now i can share with you both schematics :

First one (you can use it if you want fantastic brightness out from led torch for the minimum current cost 120-220 mAmps...)

Second one (schematic that you asked me for)

Cheers!