Peter Daysh Davey Water Heater Query

[Duncan]

Hi ramset quite right the time to heat a fixed quantity of water and of course the power taken! Consider for a moment a holiday tea maker this sort of thing Travel Immersion Water Heater - Dual Voltage | Going In Style Travel Accessories

Duncan
You are absolutely Correct 100 %
This Resistance heating will manifest in the presence of two spoons
or whatever one chooses!

The real thing to measure here is Time to heat,and once we get a few replications going ,we can establish a test protocol for this.
We have a friend here "Tinsel Koala" who has assisted many times with measurements.
I will not pester him until it becomes obvious we have something special going on here!

Thank you so much for your contribution

Gotta get back to work...............

Chet

[RAMSET]

Muddy waters..........

Duncan

A true replication [as close as possible]
This device and Davey's may be working in similar ways,however
I can't take that to the bank!
There is a critical "TUNE" where things should start Jumping!! cop 12 is monstrous!! It will be quite evident when we hit the sweet spot!!

We have a PDF , a man who has a running unit and will answer questions .

Thats the direction to go, a replication of the Professors device!

Ans yes there are a slew of variables !

We think alike Duncan.

Lets do this.............

Chet
PS
S whatcha fixin??

[Slovenia]

Power Steering Pump

Hi Chet,
Power steering pump and accessories problems on a 1992 Toyota Celica. Had a hard time getting the dumb thing off to replace it and then broke the vacuum valve while trying to remove it from the old pump. That vacuum valve was a bear to find and cost me over $94 just for the valve. Anyway, it's been a real pain repair and I'm ready to get back to the boiler bad.
Best Regards,
Slovenia

S whatcha fixin??

[RAMSET]

Jump in and out of tune

Jason
I believe the can should have several tune spots,just like when we cut a wire for a given frequency 1/4 wave 1/2 wave ETC.
It seems ludicrous that we are tuning a can for 60hz ,but as you saw with your own eyes IT DOES.......... It may be razor thin slices or axe sized chunks?

Have we even established a 200mm can with .65mm diameter?
Is there such a thing? ,I am stuck away from Home working {LOTS}
very little time for Chet...........

Thanks
Chet
PS
Slovenia
Yes that can be a pain to get out,
I remember once when I was doing a job in the tunnel in NYC the Honda gave up the alternater
The fix was pull the motor to get it out ,
Had a sawzall and grinder went right threw the floor ......... [20 minutes]
should a Utubed that one!!

[Slovenia]

Pulley

I had to pull the pulley off before I could access the top bolt and had to make a special tool to hold the pulley so I could loosen the nut on the pulley shaft. Struts are a snap to change out but this has truly been a nightmare but we're about there if my air control valve ever gets here. That's the part that was locktighted in at the factory and wouldn't budge for me so I got mad at it.

Great to see all the activity. I know this bug/boiler works because I trust the inventor. How to actually apply it in a useful context might be the real hard part. I think Mr. "C" pumps the steam and water through a radiator and then back to the boiler for reheat.

Slovenia
Yes that can be a pain to get out,
I remember once when I was doing a job in the tunnel in NYC the Honda gave up the alternater
The fix was pull the motor to get it out ,
Had a sawzall and grinder went right threw the floor ......... [20 minutes]
should a Utubed that one!!

[RAMSET]

Your tuning procedure??

So Jason.......

Gonna post that Tuning Vid????????

Speaking of Vids?
@Slovenia ,did you ever figure out how to post Movies from your camera?
Is that even possible with an older style Camcorder?

I'm getting a chance to go home for a few days [tomorrow] ,so I'll be posting some sexy polish beer can Movies [I hope its the right size Can].

Chet

[Slovenia]

Movies on Camcorder

Hi Chet,

No, I got side tracked on some other home projects which kept me from playing with my camcorder. My wife's not sure about this project and she had a lot of other things for me to do and then the car had it's problem. We'll get back to the project soon hopefully.

Best Regards,
Slovenia

So
Speaking of Vids?
@Slovenia ,did you ever figure out how to post Movies from your camera?
Is that even possible with an older style Camcorder?
Chet

[cornfused]

Chet.....
Sorry I didn't get to video the tuning yet, trying to beat the rain thats coming tonight. I'm running out of weather!! And things didn't go my way at all today........ Ya all know how it is. Maybe can video later tonight I'll do my best.
Jason

[RAMSET]

hope you don't get that snow.........

Jason
Yes I certainly do know how things can Go!!

Thanks
Chet

[Slovenia]

Good Job!!

Jason,

You are doing a great job and it's nice to have you working with us on this!!

Best Regards,
Slovenia

Chet.....
Sorry I didn't get to video the tuning yet, trying to beat the rain thats coming tonight. I'm running out of weather!! And things didn't go my way at all today........ Ya all know how it is. Maybe can video later tonight I'll do my best.
Jason

[RAMSET]

A question to my friend

boguslaw
sometimes you talk about antennas , and how they can bring in extra
energy?
Like this??
{from Shokac at OU... TK thread]

Chaos I

The Chaotic Circuit I

I know this is off topic I just want your opinion!
Thank you
Chet

[Slovenia]

Stainless Ring Material

Here is a link to some really good stainless ring material cheap. You get twelve foot long strips .25mm in thickness by 1/2". This is the best deal I've located so far!!

Stainless Steel Strip .010x1/2'' (16) (k+s7151) K-S Hobby and Craft Metal Sheets Metal Strips

[Slovenia]

Conductive Glue

This conductive glue may come in handy with our ring manufacture. Solder is a pain in the neck and I think this glue is the answer and would also look much better. I'll have a go with it soon and let you know how it turns out.

Amazing Wire Glue-The Electronic Goldmine

[Slovenia]

Antenna

Somewhere Mr. "C" referred to the can as an antenna too, if I remember right, and I'm pretty sure I saw that somewhere.

boguslaw
sometimes you talk about antennas , and how they can bring in extra
energy?
Like this??
{from Shokac at OU... TK thread]

Chaos I

The Chaotic Circuit I

I know this is off topic I just want your opinion!
Thank you
Chet

[Slovenia]

Power1 HHO Parts for Liquidation

I have a lot of Power1 HHO Experiment parts for sale. I have three large pond foggers with one power supply and a powerful 40 KHz piezo vibration module. I need to raise some money quickly so that I can do some more intense things with this current project, including some help to Mr. "C". If someone in continental US would like these items, I'll make them a special deal and sell the previously mentioned items as a package. The powerful 40 KHz piezo module cost me $38 by itself. I have a lot of other stuff too including some heavy duty equipment necessary for the Power1 project. I got side tracked off the Power1 project and never got back to it. Now I'm really heavy into this project and need to scrape up some funds as soon as I can and the only way I know to do this is by selling off some of my experiment/project stuff.

I have an oscilloscope; really nice as new function signal generator; hot plate with magnetic stirring; and zinc oxide in unopened bag.

I don't want to ship outside continental US.