Announcement

Collapse
No announcement yet.

Assembled Power Cell With 1 Amps !!!

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Assembled Power Cell With 1 Amps !!!

    Hi my power cell with 1 amps is completed :

    I broke of a small piece of the blue crystal and
    covered it with toilet paper with sea salt and
    ​​​​placed it in the center of the four rubber gaskets
    which where stacked and glued together and
    I used silver coin and aluminium foil as electrodes
    and measured 1.2 amps and 0.6 volts !!

    Now there are 2 things to do - increase voltage and connect wire with usb-c !!

    Kai Anders Wold

    Completed Power Cell With 1 Amps !! 0.jpg

  • #2
    Hi have been doing changes to increase voltage of my power cell :

    Swapping aluminium disk with zinc\iron disk made voltage jump from
    0.6V to 0.9V and the amps output was similar 1-1.2A !!

    It was not necessary to use wet toilet paper in the power cell and
    i even changed glue type used - universal glue instead of super
    glue...

    Kai Anders Wold

    Comment


    • #3
      Discovered that the reason to the high "1 amps" reading was that i measured amps
      without load or resistor and measured only a electric "shortcut" and usually there
      would be much lower amps than 1 amps ...

      Kai Anders Wold

      Comment


      • #4
        Puede suceder, fue un error, pero te diste cuenta, rectificar es de sabio

        Comment


        • #5
          Increased to 1.4 amps with simple power cell setup :

          I glued the aluminium plate to one side of the rubber gasket with super glue
          and filled the center of the rubber gasket with wet sea salt crystals and glued
          silver coin on the other side of the rubber gasket and the specifications was
          1.4 amps , 0.6 volt , 0.8 watt and 0.4 ohm.

          The power cell is suitable to low power electronics..or small projects !!!

          Kai Anders Wold

          Comment


          • #6
            Discovered one big error :

            I thought 3.00 - 1.00 on my digital multimeter was 1-3 amps
            but it turned out to be 1-3 milliamps … bad news !!!

            Kai Anders Wold

            Comment


            • #7
              Originally posted by String Theory View Post
              Discovered one big error :

              I thought 3.00 - 1.00 on my digital multimeter was 1-3 amps
              but it turned out to be 1-3 milliamps … bad news !!!

              Kai Anders Wold
              Happens to the best of us, but don't get discouraged

              Comment

              Working...
              X