Hendershot Replications

[Dave45]

A magnets magnetic field is static but its electric field is very kinetic
JK Plasma Magnetics Experiment 1 - YouTube
The fields move away from the bloch wall from the center out in both directions, you can prove this to yourself take a cw spring and turn it end to end and you can see you will always have a right hand turn but if you take two springs cw and ccw put them together end to end and turn the whole you will have the right and left hand spins at each end.
The electric field is asymmetric.

[T-1000]

Hi T1000,

I am not the only one opinionating that that is a HOAX.
Read Morpher's own comments here -
"Hendershot Fuelless Generator" - Relay Pulsing (Part 2) - YouTube

Thanks for comment.

That buzzer is same as pulsed coil with square wave. Obviously it wasn't in Hendershot's design to do that.

FACT - 1,000uF caps are like a short circuit at 50Hz and up.
CH1+2 are pulse grounded via C4 - T2 not energised.
*IF* 110Vac output to lamp, trace wires back from the lamp,
they end up on the 20Vac winding of T1, and it would saturate.

I agree about capacitors. Unless you interrupt capacitor charge with magnetic field from coils around it it would be dead short circuit! But in this case the big caps in center of coil seems to have different function. The entire LC tank circuit has capacitor inside of coil and this is where it got my attention by means of electrostatic induction. I already pulsed capacitor with coil wound on it previously and seen what happens in it...

Obviously In http://www.hendershotgenerator.com/f...schematics.pdf I do not see any dead short circuit..

Also buzzer in original Hendershot's circuit looks like regulating and pulsing element by mechanical means from magnet magnetic field.

Cheers!

[GSM]

Hi,

In http://www.hendershotgenerator.com/f..._and_tools.pdf / http://www.hendershotgenerator.com/f...schematics.pdf and http://www.hendershotgenerator.com/f...rshot_book.pdf there are unipolar capacitors mentioned:

- 2 unpolarized capacitors, 500 micro Farads each
- 4 unpolarized capacitors, 1000 micro Farads each

Does anyone know what voltage rate and type of capacitors was there? Looks like big motor starter ones but not sure about it..

Cheers!

Hi T1000,

I am not the only one opinionating that that is a HOAX.
Read Morpher's own comments here -
"Hendershot Fuelless Generator" - Relay Pulsing (Part 2) - YouTube

Free energy ? YES !!!!!
- to the person selling the plans !

LOOK AT THE CIRCUIT.
FACT - 1,000uF caps are like a short circuit at 50Hz and up.
CH1+2 are pulse grounded via C4 - T2 not energised.
*IF* 110Vac output to lamp, trace wires back from the lamp,
they end up on the 20Vac winding of T1, and it would saturate.

Only those investigating magnetic 'buzzer' action will gain knowledge to succeed with Hendershot designs !

Cheers ........... Graham.

[Dave45]

MAGNETIC FLUX SPIN VALIDATION by Al aka. "Magnetflipper" - YouTube

[Dave45]

v gate

[T-1000]

Hi,

In http://www.hendershotgenerator.com/f..._and_tools.pdf / http://www.hendershotgenerator.com/f...schematics.pdf and http://www.hendershotgenerator.com/f...rshot_book.pdf there are unipolar capacitors mentioned:

- 2 unpolarized capacitors, 500 micro Farads each
- 4 unpolarized capacitors, 1000 micro Farads each

Does anyone know what voltage rate and type of capacitors was there? Looks like big motor starter ones but not sure about it..

Cheers!

[Dave45]

If it was just this one device Rob 33's and no one else could get it to work then I would believe it was faked but there are countless devices using the v gate.

[RAMSET]

He posted a disclaimer at the time

Dave
Rob 33 retracted the 'working magnet motor' claim at the time.....
saying it was a fake!

His comment not mine.......
thx
Chet

[Dave45]

Believe what you will, the device works and the Hendershot device works on the same principle, we can use gears as an analogy and understand how it works.
If we use gears as an analogy we can understand how to make free energy,we can understand how magnets and coils work and how they relate to each other, take a good look into planetary gears, there are a couple of devices that use this to make free energy, I am working on this, its here, its now, do it.
gotta get to work
later
dave

The planetary gears actually do relate to how our planet and the other planets relate to the sun, being they are all magnets.

[RAMSET]

Rob 33 was not the real deal?

Dave
its been a while but I recall that motor being "outed"
I believe I spoke with a fellow from Texas who was the "inventer"
a few years back ......
NG on the 33.

I do recall he has a web site where he posts his builds,on the phone he claimed they worked,he was talking about mixing gates outside a drum with others inside the same drum to get a better result?


I believe the V gate Taunts us ,the "wall" always wins, although it does seem a few addendums to the design should win out.......

thx
Chet
PS
I've been super busy lately with a major life overhaul [building a place to work].I will look trough my old data for more info on this.

[Dave45]

I wonder if the device can put out more if we use ferrite rods in place of the wooden sticks.
I believe it works on the same principle as the V gate.
Permanent Magnet Motor V-gate Re-gauging from Roobert33 - YouTube
This needs to be studied extensively.
It really chaps my hide when I think that we have had free energy since 1945
Starving cold children
War over oil
Oil spills
Sink holes
Underground water poisoning
They should be arrested for crimes against humanity.

[luno]

[Indigo Sovereign]

Building a Hendershot Generator

I recently bought instructions to build the Hendershot Generator from this site:

The Hendershot Generator

I was wondering if anyone else had done this and where they got the parts to build it?

The instructions are on this page (if you can get to the member's area):

Member's Area

[GSM]

Want to build a Hendershot generator. Have a parts list and have been questioned be parts person as to the voltage of the 2 types of capacitors that I need. One is a 500 micro Farads, (need 2 of these) the other type is a 1000 micro Farads (need 4 of these). Do you know the voltage that these should be working at?

http://www.energeticforum.com/renewable-energy/12413-mr-lester-j-hendershots-magnetic-generator-5.html#post214546

That hoax is not worthy of entry in either thread.

[strongbow]

voltage of capacitors

Want to build a Hendershot generator. Have a parts list and have been questioned be parts person as to the voltage of the 2 types of capacitors that I need. One is a 500 micro Farads, (need 2 of these) the other type is a 1000 micro Farads (need 4 of these). Do you know the voltage that these should be working at?