Not seeing the Negative energy

[lerameur]

Hi,

I would like to know what i would need to do to get the negative energy out of my SSG. The motor seems to be running fine with 12 ceramic magnets on a 10 inch wheel. I m am posting the output of my oscilloscope:
http://groups. yahoo.com/ group/Bedini_ Monopole3/ photos/album/ 1924464571/ pic/1989494224/ view?picmode= &mode=tn& order=ordinal& start=1&count= 20&dir=asc
where are on the nergy from the vacuum DVD 7. I posted bedini output :
http://groups. yahoo.com/ group/Bedini_ Monopole3/ photos/album/ 1924464571/ pic/334321589/ view?picmode= &mode=tn& order=ordinal& start=1&count= 20&dir=asc
The two waves are very similar, but mine to not go below the reference voltage , 0 volt, while his goes 12v below.
I build 2 motors and I get identical results, does anyone has an idea what is wrong?
thanks
K

[Aaron]

negative energy

Lerameur,

I don't know if this would help you at all but this is one of my old vids:
YouTube - Bedini SG | Inverted circuit "E-AMP"

Actually, I believe you're doing it already with the SG's.

The inductive spike coming back when a coil collapses is a negative voltage. It is not simply a negative voltage. The properties of that voltage spike are different than positive voltages.

Caps charged with it can jump a gap further than the normal dielectric breakdown voltages that are supposed to be associated with the positive voltage equivalents.

There are other traits that are different too.

[lerameur]

HI, thanks for the reply,
but if you look at the scope reading, the spike is at the beginning of the impulse, not at the end, therefore I believe the spike is not coming from the coil collapse, am I wrong here ???

k