Not shown is the 3rd type (hard to photograph), which shows the inertial plane of a magnet
Ive been experimenting with ferrofluid suspensions for a LONG TIME.
ferrofluid is very cheap on ebay.......ultimately you only need a small vial to make a LOT of testers (people LOOOOVE them as gifts)
Cost to make? About $1 or less EACH.
You need test tubes, ferrofluid, rubbing alcohol, baby oil/mineral oil
sugar and water.
1. type 1, add 5-12 drops of ferrofluid , then add 70% rubbing alcohol
RESULT: Makes very very fine hair like spikes (regardless of the magnet)
2. type 2.......add a large pinch of sugar to test tube 3/4 full with water...shake it.......THEN add 5-12 drops of ferrofluid , then fill to full and cap it.
RESULT: This makes the large teardrop shapes and diff field effects than #1.
3. type 3.....add ONLY 2 drops (NO MORE!) of ferrofluid....then add mineral oil or baby oil......RESULT? This makes an inertial plane viewer "Bloch wall"
TYPE 1 here:

(that one is the best in my opinion<<<)
TYPE 2 here:

Using EITHER type showing the dielectric inertial plane displacing the ferrofluid on the edge of this GIGANTIC DANGEROUS $800 magnet
You cant really see it below, but this is a 6 inch by 2" thick N48 Neodymium, shes a 'killer', a monster.

making them at $1 , Ive made a LOOOOOOOOT of them, people LOVE LOVE them as gifts.
Theyre wonderful field testers, and demo tools, toys, gifts, etc etc.
Ive been experimenting with ferrofluid suspensions for a LONG TIME.
ferrofluid is very cheap on ebay.......ultimately you only need a small vial to make a LOT of testers (people LOOOOVE them as gifts)
Cost to make? About $1 or less EACH.
You need test tubes, ferrofluid, rubbing alcohol, baby oil/mineral oil
sugar and water.
1. type 1, add 5-12 drops of ferrofluid , then add 70% rubbing alcohol
RESULT: Makes very very fine hair like spikes (regardless of the magnet)
2. type 2.......add a large pinch of sugar to test tube 3/4 full with water...shake it.......THEN add 5-12 drops of ferrofluid , then fill to full and cap it.
RESULT: This makes the large teardrop shapes and diff field effects than #1.
3. type 3.....add ONLY 2 drops (NO MORE!) of ferrofluid....then add mineral oil or baby oil......RESULT? This makes an inertial plane viewer "Bloch wall"
TYPE 1 here:

(that one is the best in my opinion<<<)
TYPE 2 here:

Using EITHER type showing the dielectric inertial plane displacing the ferrofluid on the edge of this GIGANTIC DANGEROUS $800 magnet
You cant really see it below, but this is a 6 inch by 2" thick N48 Neodymium, shes a 'killer', a monster.

making them at $1 , Ive made a LOOOOOOOOT of them, people LOVE LOVE them as gifts.
Theyre wonderful field testers, and demo tools, toys, gifts, etc etc.
Comment