Donald Smith Devices too good to be true

[Farmhand]

Hi abc1200d, I think I agree, is that Mega watts though or milli watts.
Your post is a little cryptic, but I'll try to "get" your meaning about the turn of
the century comment.

Point 6 and point 7 I agree with entirely.

Cheers

[vidbid]

Radiant Energy

Hi ! Vidbid and David Fine!

there wont be any deletions from my side. i held the decision as per your request. I wont burden David Fine for salvaging more deleted posts of mine coz its a herculean task and indeed is very time intesive and takes a lot of effort.

I wish David fine good luck and happy recovery. Thank you for salvaging my posts for the benefit of members. i wont burden u with the work of doing the salvaging work. i will not del my posts further.

cold electricity vdo

RADIANT ENERGY/COLD ELECTRICITY RESISTANCE TEST 1 & 2 - YouTube


rgds
zzzz

Thanks, Zilano. We appreciate your decision not to delete your posts.

Thanks for posting a link to an awesome video. Click here to download it as an mp4 file.

YouTube Video:

http://youtu.be/yVzhKpEqUgc

Video Description:

The following Video shows one of the astonishing properties of Cold Electricity, obtained from the Spectrum of Radiant Energy, that has existed all over our beautiful Planet, and in every part of our Infinite Universe before Mankind ever existed.

This type of Electricity Brakes, Ignores, Grows and Thrive over one of the Oldest Concepts in Classical Physics, Electricity and Electronics Laws written One Hundred and Eighty Five (185) Years Ago...

Ohm's law states that the current through a conductor between two points is directly proportional to the potential difference across the two points. Introducing the constant of proportionality, the resistance,[1] one arrives at the usual mathematical equation that describes this relationship:[2] I = V/R

Resistors are circuit elements that impede the passage of electric charge in agreement with Ohm's law, and are designed to have a specific resistance value R. In a schematic diagram the resistor is shown as a zig-zag symbol. An element (resistor or conductor) that behaves according to Ohm's law over some operating range is referred to as an ohmic device (or an ohmic resistor) because Ohm's law and a single value for the resistance suffice to describe the behavior of the device over that range.

Ohm's law holds for circuits containing only resistive elements (no capacitances or inductances) for all forms of driving voltage or current, regardless of whether the driving voltage or current is constant (DC) or time-varying such as AC. At any instant of time Ohm's law is valid for such circuits.

Applying Resistance to any given Circuit, (Up to NOW) we can be able to Control the Current and Voltage, therefore reducing its Potential (V) and Intensity (I) of the Electricity/Electronic Flow...Resistors Regulate and control at ALL levels of Electrical and Electronic Equipment in our actual World.

The problem that resistors have, is that in order for them to reduce/convert Higher Energy Power (Watts=Voltage (V) times (I) Intensity) into a Lower level of Electricity Flow...They have to Transform all that excess of Energy into [Unnecessary up to Now] Heat...According to our Energy Conservation Laws.

This constant Energy converted in useless Heat, exist in every circuit we know up to now , no matter how big or how small it could be.

Radiant Energy (RE) converted into Cold Electricity, from a simple process of Pulsating Electro Magnetic Field Exchanges of low power consumption [We 'Invoke' RE, by creating a small Resonating (Pulsating) Electro Magnetic Field, and RE comes into Our Systems doing the Opposite Process, Converting Her Electromagnetic Field into the Beautiful, harmless Cold Electricity, but, Multiplied in Excess over our minimal spending]

However, Radiant Energy (RE), is much faster than our 50-60Hz Cycles per second, Electricity, Radiance (RE to Cold Electricity Process) does not get even affected by the most powerful ways to reduce our typical and OLD power supply system of our World. So she travels conductors , circuit lines, Integrated Chips and even Light Bulbs at a minimal fraction of what it cost Us Today...
Now Upon this great -not Discovery- I would say, but FINAL DISCLOSURE of a HIDDEN SECRET, because Cold Electricity has been spoken by many of the greatest Scientists in our Planet, Since... Nikola Tesla, (The Inventor of Alternate Current Systems (A/C) that involves over 700 patents just related to this great technology still in use up to now), back in the Eighteen Hundred's, spoke, wrote researched and developed this Incredible Electricity, and even patented many documents related to His Studies and Developments...Then Many more Bright and Humanitarian Scientists followed Tesla's great findings and started newer researches and developments all along our History...
Dr Thomas H. Moray, Dr. Floyd Sweet, Arie De Geus, Stanley Meyer, Rory Johnson, Edwin Gray, Walter Russell, Hutchinson, Brown and so many more , who's lives were none that successful as They should have deserved to have lived...
We still have many Great Men like Mr. Tom Bearden, Peter Lindemann, John Bedini, Professor John Searl... among Us, Who have been standing Up for many years of their lives, writing Books, Articles, making Videos, Giving Conferences about this beautifully Natural Energy, that up to now Has Been Maintained as a Secret, considered by Physics as an IMPOSSIBLE, as a Taboo, claiming for THEM to RELEASE IT to ALL OUR PLANET , this Crippled, Seized and Controlled ...

But We Got it NOW...and It is GONNA GET RELEASED EVERY WHERE IN OUR ENTIRE PLANET...FROM CONTINENTS TO CONTINENTS, FROM LITTLE ISLANDS IN THE MIDDLE OF OUR MASSIVE OCEANS TO GREAT CITIES...
EVERY WHERE...

[Farmhand]

Yes but in your drawing the cap led is inversed, the Avamenkro's plug charge the capacitor right? so the charge stored in the led ligths the led rigth?

but your led is inverses

the led on this schem is in right position but in your scheme is inversed

Yes your correct c_henriques, current flows through an LED from positive to
negative, if current flowed through that particular LED in Zilano's drawing it
would charge the cap.

In all fairness it is easy to make a mistake like that. I do it all the time, but if
it was pointed out to me I would admit it, it's no big deal, to deny it makes no
sense.

What does make sense is that voltage can be measured across the LED but
no current. Amateurs like me can make that mistake but not an expert.

You Can Measure Voltage Across Leds But It Has No Current.

If U Dont See Any Lights In White Leds Across Bifilar Then Adjust Ferrite Rod In Or Out And When It Lights Up Keep Rod At That Position.

HEAT SINK REQUIRED FOR 2N3055 IF U FIND IT HEATING TOO MUCH OTHERWISE NOT

BOBBIN DIAMETER FOR COILING IS 1-2 INCHES. PLASTIC TUBE CAN BE USED. DO NOT USED NAKED WIRE FOR COILING. FOR MUCH MORE EFFECT U CAN INCREASE TURNS FROM 200-300. (SINGLE LAYER).insulate ferrite rod it may shock you.

Cheers

[vidbid]

Thanks Vidbid!!

Best Regards,
David Fine

You're welcome, and it was my pleasure, Sir.

[Farmhand]

That's more or less better;
Now, if u'r the "user" of 10kW unit why u do not post a right diagram at the first place?
Simple, u do not have it.
I believe u have to get guts and apologize for claim "user of 10kW" as well,
than we will go in one dirrection all together
If in the mood of course.

Yes I agree, well said.

Cheers

[vidbid]

OK, total newbie here, so go easy.

@nutgone

Welcome, aboard!

We appreciate you offering input.

[vidbid]

Hi Vidbid and Farmhand,

Let me explain..
Recently I viewed a video featuring Tom Bearden.
In this video he explains how the MEG spilt the electric field from the (around the electric field curling) magnetic field.
That's how he created Cold electricity.
So my logical thinking was, when you want to convert Cold to Hot, you need to put the magnetic field back.

Maybe I am wrong, but that is the reason why I asked Zilano for comment, and KajunkornKreations for the compass test.
Just curious.

Bert


ps. Thank you both for all your input on this forum, I enjoy reading your posts.

@Bert

Bert, thanks for offering your input.

If I'm not mistaken, Woopy performed a compass test in a recent video of his.

[zilano]

Yes but in your drawing the cap led is inversed, the Avamenkro's plug charge the capacitor right? so the charge stored in the led ligths the led rigth?

but your led is inverses

the led on this schem is in right position but in your scheme is inversed

simple- connect short leg of led to -ve of cap leg and longer leg of led to +ve of cap leg

zzzz

[vidbid]

That's quite an interesting video.

It led me to that users's other videos titled Teslas Impulse Technology (3 of) which are well worth watching.

Here's the link for the 1st one Teslas Impulse Technology - John Bedini Lecture1/3 - YouTube

@Haan

Haan, thanks for offering your input.

Studying Tesla's impulse technology deepened my understanding of the bloch wall.

[vidbid]

Save

Hi David

Dankie baie dat jy die geskiedenis van die werf bewaar en dit vrystel aan almal.

That is just short for thanking you that you go to all the trouble to record the posts on this thread and release it to all.

Thanks.
Best Johan

@Johan

Johan, thanks!

It is our hope that all members retain their posts here and not delete them.

Wie nie waag nie, wen nie

[vidbid]

You Can Measure Voltage Across Leds But It Has No Current.

If U Dont See Any Lights In White Leds Across Bifilar Then Adjust Ferrite Rod In Or Out And When It Lights Up Keep Rod At That Position.

HEAT SINK REQUIRED FOR 2N3055 IF U FIND IT HEATING TOO MUCH OTHERWISE NOT

BOBBIN DIAMETER FOR COILING IS 1-2 INCHES. PLASTIC TUBE CAN BE USED. DO NOT USED NAKED WIRE FOR COILING. FOR MUCH MORE EFFECT U CAN INCREASE TURNS FROM 200-300. (SINGLE LAYER).insulate ferrite rod it may shock you.

@Zilano,

Zilano, thanks for that post.

We appreciate your input.

[vidbid]

Looks like marine type blocking diodes to me.

Now I can imagine that too.

[vidbid]

@abc1200d

abc1200d, thanks for offering your input.

not going to disclose any further information

Thanks for offering what you have already offered.

[zilano]

Yes but in your drawing the cap led is inversed, the Avamenkro's plug charge the capacitor right? so the charge stored in the led ligths the led rigth?

but your led is inverses

the led on this schem is in right position but in your scheme is inversed

YES THANKS ERROR IS CORRECTED.







ADD ANY NUMBER OF DIODES ACROSS CAP UNTIL VOLTAGE CAPACITY OF 10 VOLTS REACHED IT DOESNT AFFECT AMPMETER A IN THE CIRCUIT.


RGDS
ZZZZ

[Gedfire]

Ok

Thanks Ged!! You're the Man. A better one is coming soon.

Slovenia, Fine, & Fiditti are the same fellow.

Excellent.Thanks for the info.

Ged