Announcement

Collapse
No announcement yet.

E V Gray, Ismael Aviso, Tesla car or energy from the Vacuum

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • hermesatar
    replied
    Hi everyone,

    I have experimented today and made a great discovery that has to do with the Edwin V. Gray capacitor discharge motor.

    Take two 4700 uF / 25 volt capacitors. Connect them in parallel so that you get 9400 uF / 25 volts and charge them with 9 volts from a 9 volt battery. Take an electromagnet whose one end attracts a permanent magnet. Connect a 3 amp diode in series with the capacitor and connect the diode and capacitor to the electromagnet. Check how far the permanent magnet fires.

    Connect 2 4700 uF / 25 volt capacitors in series so that you get 2350 uF / 50 volts and charge them with two 9 volt batteries in series, so the total voltage is 18 volts. Take an electromagnet whose one end attracts a permanent magnet. Connect a 3 amp diode in series with the capacitor and connect the diode and capacitor to the electromagnet. Check how far the permanent magnet fires.

    By entering the values in the following capacitor energy calculator: https://www.omnicalculator.com/physics/capacitor-energy

    You get the current charge and the energy charge and can calculate how far the permanent magnet is fired. Is that in line with the theory?

    You will find more information on my Edwin V. Gray page that I have made today: http://gratisenergi.se/gray.htm

    Best Wishes, Hermes

    Leave a comment:


  • hermesatar
    replied
    Recently I have been thinking of Edwin V. Gray and his EMA motor and I did come up with this idea:
    dema.jpg

    Leave a comment:


  • nafanja
    replied
    The extra-reppeling force

    Hello everybody. decided to talk about some force that has been exciting me for a long time. This force was fond of Edwin Gray, Izmael Avio and probably many other inventors including Nicola Tesla
    [VIDEO]
    https://www.youtube.com/watch?v=P03E4I9a_Ag[/VIDEO]

    Leave a comment:


  • nafanja
    replied
    The first steps in Motor

    [VIDEO]https://www.youtube.com/watch?v=P03E4I9a_Ag[/VIDEO]

    Leave a comment:


  • nafanja
    replied
    Now I make the experiments with lift force for presentate my principe ( Trsla Gray Aviso)

    Leave a comment:


  • nafanja
    replied
    Ni I would like to show the driver for my thyristor on PC817 and n - p - n Transisor

    This scheme I was use with Arduino and 5V Power Block
    Attached Files

    Leave a comment:


  • nafanja
    replied
    [VIDEO]https://www.youtube.com/watch?v=EiSeuPHW0YA[/VIDEO]

    Leave a comment:


  • nafanja
    replied
    Some Tesla E V Gray Aviso and ILYA tests

    Some experiments with Aviso Gray Tesla and motor priogect is here
    Watch with a pleasure
    [VIDEO]https://www.youtube.com/watch?v=2FZRF3vpWEU[/VIDEO]

    Leave a comment:


  • nafanja
    replied
    Summer and my work

    Hello

    Today nice day and I back here

    very interesting to see what interesting here in forum...
    It's very interesting to show my work here

    Now i would like to show You my new driver for SCR (thiristor)
    [VIDEO]https://www.youtube.com/watch?v=Iu9c1BVfcoQ[/VIDEO]

    Leave a comment:


  • nafanja
    replied
    Here is my tried-and-true driver circuit for thyristor control. It can use ferrite cores of absolutely any size, since the upper timer is able to set the frequency. which is digestible for the operation of the transformer, the lower sensor generates a control signal with any frequency and duty cycle, from infra low frequencies to tens of kHz, etc.

    The signal for the drivers is a capacitor-smashed burst of high-frequency pulses, which ultimately represent a signal resembling a low-frequency meander

    Blue indicates the need to adjust the resistor and capacitor to your requirements. High Frequency - for the data of your core, Low Frequency - from the need for the tripping period of the thyristor driver signal
    Last edited by nafanja; 02-17-2018, 08:33 PM.

    Leave a comment:


  • nafanja
    replied
    Theremin wox

    Now the weekend, and at the moment I'm thinking about how to make some security system for a future heat heater, which will be built according to the principles of Tesla



    Theremin World - Schematics


    I found a very interesting site that is dedicated to the Termenvox
    Last edited by nafanja; 02-17-2018, 04:11 PM.

    Leave a comment:


  • nafanja
    replied
    This is already my mix of the once found videos about Izmael, which are very difficult to find, a lot of video clips of Izmail Styor, as this project was snatched from two thousand years ago

    [VIDEO]https://www.youtube.com/watch?v=dAqeZddCOkg[/VIDEO]

    Leave a comment:


  • nafanja
    replied
    After we noticed on the big engine, and then again measured on the pendulum, that with the increase in the number of revolutions the amount of Back EMF decreases relative to the energy input to the engine

    The calculation was made through the calculation of energy in the Joules ... Found an old video and uploaded to Youtube

    After we noticed on the big engine, and then again measured on the pendulum, that with the increase in the number of revolutions the amount of Back EMF decreases relative to the energy input to the engine

    The calculation was made through the calculation of energy in the Joules ... Found an old video and uploaded to Youtube

    [VIDEO]https://www.youtube.com/watch?v=yt-snHyvLeI&feature=youtu.be[/VIDEO]

    Leave a comment:


  • nafanja
    replied




    The mode of operation of the thyristor, for several days, switched to night mode in Moscow time to view the successes of the American colleagues)))
    Last edited by nafanja; 02-16-2018, 08:39 PM.

    Leave a comment:


  • nafanja
    replied
    Originally posted by boguslaw View Post
    I see that you are using PWM to create packets of pulses. What I need is to shape such packets in the form of triangle wave and filter out the HF part. I think it is doable using micro-controller but maybe there is simpler way ? Do you know any simpler ?

    Я вижу, что вы используете PWM для создания пакетов импульсов. Мне нужно сформировать такие пакеты в виде треугольной волны и отфильтровать HF-часть. Я думаю, что это выполнимо с помощью микроконтроллера, но, возможно, есть более простой способ? Знаете ли вы, что проще?
    It is difficult now to say what a simple solution you can give, you need to look into a specific situation ...

    Leave a comment:

Working...
X