Re-Inventing The Wheel-Part1-Clemente_Figuera

[Ufopolitics]

--> MM Thank you for your ansver.
""the secondary does not effect the primaries at all because the magnetic field from the primary resides in a space outside of it's core""
in a space outside: Where? G? We have to test and prove that.

NOPE, not in G, but in the Atmospheric Region, right between the Spatial separation between N-S, where the Secondary Cores and Coils ("y" Line) are located.

""After weeks of study i am leaning toward just a plain old inductor.""
I got 10% more efficiency (in sim.) when I split my G in two halves 5+5 coils w. magn. coupling (in my case two 1/4 donut) and grounded the mid point(s) from them. Half sinus up + Half sinus down in sec."y"!!
Watch out for the most middle G-points they produces kV spikes!! even w. brake before make! Take care of your FET:s!
Still no OU....

Do you really are so naive, as so narrow minded...that expect any Software Simulation will demonstrate OU to You?

Maybe you expect the software would answer:

<START>
to the World of Over Unity!!..., BRAVO!!
You have reached what no one else has been able to!!!

</END>

Marathonman is so right!!

The only difference between MM and Me...is that I rather stay here and make your life's miserable by demonstrating how non sense you and your comments could really be!!


Ufopolitics

[Matu]

[Ufopolitics]

[Ufopolitics]

Rectified Signal...

Marathonman,

You are overreacting because of your paranoia about how you are so sure this device works. Look again at the schematic posted by seaad. If the sine wave of the signal is less than the 8 volt offset then he is powering the coils with DC not AC. As long as the bottom of the sine wave never goes below the zero line the the signal is a varying DC signal not AC. And that is what your part G is supposed to be supplying, a varying DC signal just like seaad shows in his schematic. Why he is getting such poor results could be a whole other problem but his signal is a varying DC signal not AC.

Respectfully,
Carroll

That is what is called a "rectified AC Signal" and it could have been achieved -much simpler- by using just one (1) single diode which will cut the negative side of the AC sinewave.

Seaad did not "discover" nor "improve" absolutely nothing.

Figuera uses Plus and Minus Signs throughout his whole Patent, and knowing how to speak fluently that language is not required, to simply read a very easy to understand -just one- drawing with Universal Electric Symbols.

So Seaad Tests are completely NON RELATED to this Patent nor to this Thread.

However, since it obviously contradicts all that MM has been disclosing here....here you come "right away" to start all your criticism and insults.


Ufopolitics

[Ufopolitics]

I will keep going no matter what...

Hi All,

I would like to inform to all people working here, AND I MEAN REALLY WORKING PHYSICALLY AND SPENDING THEIR TIME AND MONEY...Like I am doing...on building this Figuera Device...

That IF MM leaves here or He is banned..

I WILL PROCEED MY WHOLE LINE OF WORK ON THIS FORUM IN SPANISH.

And that would Include ALL VIDEOS AND ALL EXPLANATIONS ABOUT MY DEVICE(S).

Without absolutely any translation into any other existing Language.

Figuera was Spanish, and so am I...so resolve your issues by using the "efficient" Google or Bing Translators...or any other "On Line Translator you please.

It is "My Way" , My decision as a response to all these people attacks while all of you stay simply quiet, calm...while watching THE REALITY about what's really going on here.


Ufopolitics

[Ufopolitics]

MM

MM,

Please, read my private mail to you.

Where I ask you not to leave...do not allow all these "critics" to get away with all their Agenda!!

Actually, like I wrote on the PM to You...:


You do not have to explain absolutely NADA at all.

Let them Skeptics, do that job, after you show a video of how wonderful it all works!!

Then let's see how really good they are...explaining the unexplainable...and see if their limited learned knowledge could make it possible...

In the meantime we will just ROFLMAOFF...or

Please cool off, relax and do as the Admin requires...don't let them win friend!!


Regards



Ufopolitics

[Ufopolitics]

These images and text in your signature line need to be changed or removed. Please disagree with others without name calling and insults - this applies to everyone. Will check back tomorrow to see if any posts need to be deleted or if anyone needs to be banned.

Admin,


Could You please review the whole line of posts in order to observe how this people, the always known skeptics in this forum...who just start their questions and defying and criticizing, and also insulting comments?

They always do exactly the same technique... and the final result is to upset the leader, the builders, in any Thread they attack...just because the material disclosed does not line up with their limited and taught knowledge.

All this attackers do, is nothing more than write here all their criticism, finding all errors in anything they could dig into, creating this kind of atmosphere, which always end up in the quitting of the leaders, the builders, the replications...etc,etc.

I have been attacked many times by them, as I have also notified the Administrators here about their constant attacks...many times, it should be on record.

You could search each one of this attackers here...like Citfta, Bistander, etc,etc...and would find out they have not moved even one finger to build absolutely nada, nothing on this whole forum...all in all is just words that they have done something always with negative results...plus all kind of lousy tests and bad, poor images, and terrible replications done with the least of interest to achieve nothing but negative results.


And so, I do believe You guys, in the Administration back end, should dedicate more time to prevent all this constant attacks from this people, who are not looking to build, nor to test nothing but to generate the instability on every thread they visit.

So, concluding, that IF these people are not replicating, Not Building absolutely nothing here, then they should Not participate -at All- on this debates about what we, the Real Builders are proving we are all working on>!!!

And so...if it would have being prevented...then the leaders would not have exploded with all kind of expected responses, like above, because they already achieved what they were all pursuing...To Upset Leaders as there is no tomorrow until they leave.


This is just their "Business as Usual" Agenda on this Forum!!


Respectfully


Ufopolitics

[Ufopolitics]

Figuera Non Related Testing 1

I used +8 volt to pull the input AC above the ground level.
And the performance was outstanding! About 0.1%

Seaad,


That test proves absolutely nothing, NADA, in the world of the Figuera Device.

Figuera uses DC throughout the whole Generator exciting system, and not one single AC input.

IT IS CLEARLY SHOWN ON HIS ORIGINAL SPANISH PATENT!!

By doing all this non related test, all you achieve is to piss off MM, allowing the stalkers like Citfta to walk in and start their known BS, based on your nonsense test!!

So, please may I ask you to MAINTAIN EXACTLY BY THE FIGUERA'S DEVICE CONFIGURATION, and Not trying to "IMPROVE" absolutely NADA??!!


Is that too much to ask from You?

EDIT: By the way, could you show Us all here...at least one picture of your real device tests?...And I am not relating to any "Simulation Testing BS" or poorly hand written diagrams...but the Real Mc Coy Build??


Ufopolitics

[marathonman]

Un worthy

I regret to inform everyone that not only am i offended by your rude comments but appalled by your stupidity toward the Figuera device. i am withdrawing my support from this day forward for the Figuera device as i refuse to support stupidity and ignorance of real science.
i have enjoyed trying to teach real science but the burden of opposition is to overwhelming and has risen beyond my level of comfort and thus i must say good by.

a few of you i will surely miss and others i will not thus the game of life continues.

to my 450 followers i do regret as i am deleting all my research and in the next few days will delete all my posts from this web site. i am sorry but i feel as of this time you are not worthy of this wonderful gift and have no understanding of it's nature or implications.

God bless you all just not this day.
to admin, go sell another BS book, i'm not the one and Eric knows that.

Your past friend,

MM

[admin]

warning

Go F your selves ignorant bastards. your not worthy of Figuera.
KISS MY BULLS EYE.

By

These images and text in your signature line need to be changed or removed. Please disagree with others without name calling and insults - this applies to everyone. Will check back tomorrow to see if any posts need to be deleted or if anyone needs to be banned.

[Ufopolitics]

UFOP;

I really don't know what you are doing wrong as this is simple induction.
speed of fluctuation, currant flow, type of timing, verification of flux field are many factors to consider.
if one simple magnet can make a galvanometer move then there is no reason for an electromagnet to not do the same
all you can do is go through the system and find the problem as i know your quite capable of.

MM

Thanks MM,

It is not quite simple induction as we are not moving physically the "Magnetic Field Carriers" (whether magnet or electromagnets) but just the virtual field...

The problem I had was the PSU I was using to feed primary...it was not rendering the constant Amps rate after certain run time. Plus they decay too fast.

Since we are all dealing here with a "Spatial Virtual Field" to induce on secondaries, we need a constant amp and volts rate to generate always the same High Field.

This Spatial Field requires to have specific strength derived from its input...generating it with lower values will render lower induced output at secondaries...I have tested 36V @ 2 Amps to reach Hi Field...not good!!

We need higher values in the range starting at 48V and 3-4 Amps minimum.

So I need to get a stronger PSU...so I am trying to get a 60V/10A delivered in a single output (not dual and connected in series) ...even though I would be using only like 50V and 4 Amps as High (Max) Field...I wanna have some extra room that way won't be driving PSU at Max at all time...which I consider is not good for the equipment.

Let's all keep the calm here...is the only way to do better work.


Regards to All


Ufopolitics

[seaad]

No one would be happier than me if the Figuera concept could work! But it seems like there are some small obstacles we must overcome first.

From patent:""To fix ideas is convenient to refer to the attached drawing which is no more
than a sketch to understand the operation of the machine built using the
principle outlined before. ""
Look at Hannon's collage of pictures above with so many different rectangles around the "y"-cores!! Y-core inserted, y-core with a gap...........
MM and all let's work as a team.
Arne

ps. when experimenting why are you (all) aiming for a contraption in the kW class?

[BroMikey]

Go F your selves ignorant bastards. your not worthy of Figuera.
KISS MY BULLS EYE.

By

That is all you got, anyone who attacks our leaders is dog pucky.
The rest of you kissing his butt are no better.Marmalade Muffet
Just a straight up low class, know nothing.

[citfta]

NO, i am not over reacting, you people are ignorant and foolish to the third degree. i'm done f-in with you ignorant fools, trying to convince a bunch of non intelligent people about the Figuera device is like trying to F a snake.

go f your selves in the ars. fools.
I LAUGH AND SPIT IN YOUR DUMB FACE.

MM

Instead of ranting and acting like a 2 year old tell us what about my post you disagreed with. I clearly explained that seaad's signal was DC and not AC. Why do you not agree with that?

[bistander]

NO, i am not over reacting, you people are ignorant and foolish to the third degree. i'm done f-in with you ignorant fools, trying to convince a bunch of non intelligent people about the Figuera device is like trying to F a snake.

go f your selves in the ars. fools.
I LAUGH AND SPIT IN YOUR DUMB FACE.

MM

Nice guy. NOT