Cosmic Induction Generator by John Polakowski

The Real History of the Ed Gray Motor by Mark McKay
Energetic Forum  

Go Back   Energetic Forum > Search Forums
Homepage Energetic Science Ministries Register FAQ Calendar Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 2000
Search took 0.54 seconds.
Search: Posts Made By: Matthew Jones
Forum: Renewable Energy 08-23-2014, 11:26 PM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
I still don't understand all your your...

I still don't understand all your your explanation of the measurements but sounds to me that the problems mostly are in the toroid transformer. So work on that if you can.

But keep posting when you...
Forum: Renewable Energy 08-23-2014, 06:32 PM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
As far as the transistors opening if you followed...

As far as the transistors opening if you followed the instructions for testing while assembling everything would work. With those instructions you should be able to isolate exactly whats wrong. If...
Forum: Renewable Energy 08-23-2014, 11:22 AM
Replies: 319
Views: 11,825
Posted By Matthew Jones
No after the second transistor. SO Positive...

No after the second transistor. SO Positive source, NPN, Coil, NPN, Resistor, Source ground.

Matt
Forum: Renewable Energy 08-23-2014, 11:18 AM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
Some toroid transformers are wound for 1 way use....

Some toroid transformers are wound for 1 way use. They almost act like a diode. You can only power one side. Trying to power the lower side is like adding a load and draws down the potential.

Try...
Forum: Renewable Energy 08-23-2014, 02:13 AM
Replies: 319
Views: 11,825
Posted By Matthew Jones
Better time that right. Make sure to turn the...

Better time that right. Make sure to turn the first NPN on First the second on second then shut the second one off then the first one. Or you'll get nothing. The resistor in the front will only cost...
Forum: Renewable Energy 08-20-2014, 09:50 AM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
Run the system for an hour. Watch the current...

Run the system for an hour. Watch the current going in the transformer and coming out. You can look at the voltage too with a scope.
You can use a bridge instead of the transformer and see if the...
Forum: Renewable Energy 08-15-2014, 10:14 PM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
Its no problem. Anything you need post and keep...

Its no problem.

Anything you need post and keep working. It will pay off I promise you. I wish the whole thing was more predictable. Seems alot of people have hap hazardly put these things together...
Forum: Renewable Energy 08-15-2014, 12:46 PM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
What kinda specs do you have on the transformer....

What kinda specs do you have on the transformer. Size and windings.

One thing at first you might be shooting for best output, later you might start looking at recovery. If you run the arduino off a...
Forum: Renewable Energy 08-13-2014, 12:14 AM
Replies: 34
Views: 886
Posted By Matthew Jones
@mbrownn Read the first post in this thread and...

@mbrownn Read the first post in this thread and watch the movie.

Now read my comment afterwards.



Now that you have read those I have a simple question for you.

Why do think anybody want to...
Forum: Renewable Energy 08-12-2014, 01:19 AM
Replies: 34
Views: 886
Posted By Matthew Jones
LOL :rofl: :rofl: :rofl:

LOL :rofl: :rofl: :rofl:
Forum: Renewable Energy 08-12-2014, 01:18 AM
Replies: 34
Views: 886
Posted By Matthew Jones
NO!! :thumbsup:

NO!! :thumbsup:
Forum: Renewable Energy 08-11-2014, 11:02 PM
Replies: 34
Views: 886
Posted By Matthew Jones
I'm not upset and I am perfectly calm about it....

I'm not upset and I am perfectly calm about it. Its just pointless sometime to be liberal about some things. People do not change course because they read something, they change because they are put...
Forum: Renewable Energy 08-11-2014, 12:11 PM
Replies: 34
Views: 886
Posted By Matthew Jones
These are the statements that you get you called...

These are the statements that you get you called out.

Why not produce excessive voltage and run it through the motor? Use High impedance windings to regulate the current as opposed to using all that...
Forum: Renewable Energy 08-11-2014, 06:22 AM
Replies: 34
Views: 886
Posted By Matthew Jones
Where do you get this? Can you show me a motor...

Where do you get this? Can you show me a motor that will run off 1 volt at 100 amp efficiently?
I can show you one that will run at 100 volt 1 amp and produce more torque or HP than 100 watts should...
Forum: Renewable Energy 08-09-2014, 02:05 AM
Replies: 34
Views: 886
Posted By Matthew Jones
That ends up working like an encapsulated window...

That ends up working like an encapsulated window motor. Its B field winding, or at least I think thats what it is called.

Now one reason he appears to get more power is most likely do to the lower...
Forum: Renewable Energy 08-02-2014, 04:33 AM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
Don't be discouraged. Thats not bad on the first...

Don't be discouraged. Thats not bad on the first few runs. You should use solid wire connections.
More runs will tune the batteries a bit. 1 ms seams kind fast but you have to be the judge. If the...
Forum: Renewable Energy 07-31-2014, 12:53 AM
Replies: 6
Views: 371
Posted By Matthew Jones
Not to say that the article you are presenting is...

Not to say that the article you are presenting is bad info but it has not panned well for most. For starters Nikola Tesla did not build that. John Bedini named it for its likeness to one of the...
Forum: Renewable Energy 07-20-2014, 11:18 AM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
When the bottom set hits 12.35 +-. Put them in a...

When the bottom set hits 12.35 +-. Put them in a top spot. Generally I keep them on the same side. But you can rotate them around the input power for switching if your not powering...
Forum: Renewable Energy 07-18-2014, 08:51 PM
Replies: 3,318
Views: 262,755
Posted By Matthew Jones
Last time I talked to Dave he was scared...

Last time I talked to Dave he was scared sh*tless. Fearless leader???

LOL

Just bustin balls LOL

Matt
Forum: Renewable Energy 07-18-2014, 02:47 AM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
I would stick with a resistive load under 10...

I would stick with a resistive load under 10 watt. Inductive loads beyond the transformer tend to heat that thing up a bit.

Matt
Forum: Renewable Energy 07-16-2014, 10:40 AM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
Gotta remember the goal of the setup is to get...

Gotta remember the goal of the setup is to get the output voltage up to the level of the batteries or bit higher so you can compare.
To compare you run the load on all 4 batteries from fully charged...
Forum: Renewable Energy 07-15-2014, 12:46 AM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
Not sure what opto's your using but you may try...

Not sure what opto's your using but you may try bypassing the optical part all together and use the base if its available. The H11d1 has a base pin at pin6. It can take 5 volt pretty easy. This would...
Forum: Renewable Energy 07-14-2014, 01:13 AM
Replies: 133
Views: 11,935
Posted By Matthew Jones
With summer and the bugs and weeds in my gardens...

With summer and the bugs and weeds in my gardens and all the different stuff I planted this year and all the people buying food now, I haven't touched a thing recently.

I am really looking for an...
Forum: Renewable Energy 07-11-2014, 10:41 PM
Replies: 492
Views: 32,978
Posted By Matthew Jones
I've done it both ways but I like the scale...

I've done it both ways but I like the scale better (Naudins Way)

Matt
Forum: Renewable Energy 07-11-2014, 10:38 PM
Replies: 4,164
Views: 501,931
Posted By Matthew Jones
Thanks. I'm terrible with acronyms. Matt

Thanks. I'm terrible with acronyms.

Matt
Showing results 1 to 25 of 2000

 


All times are GMT. The time now is 09:14 PM.


Powered by vBulletin® Version 3.6.4
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.0.0 RC8
2007 Copyright ? Energetic Forum? A Non Profit Corporation - All Rights Reserved