Energetic Forum  
Facebook Twitter Google+ Pinterest LinkedIn Delicious Digg Reddit WordPress StumbleUpon Tumblr Translate Addthis Aaron Murakami YouTube 2020 ENERGY CONFERENCE - PRE-REGISTER NOW!!!!

2020 Energy Science & Technology Conference
PRE-REGISTER NOW!!!
http://energyscienceconference.com


Go Back   Energetic Forum >
   

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX

Showing results 1 to 25 of 171
Search took 0.01 seconds.
Search: Posts Made By: kEhYo77
Forum: Renewable Energy 06-08-2017, 08:23 AM
Replies: 411
Views: 95,576
Posted By kEhYo77
Yes, other coils I tried did slow down this...

Yes, other coils I tried did slow down this rotor.
I will make a video with proper measurements soon.
Forum: Renewable Energy 06-08-2017, 07:21 AM
Replies: 411
Views: 95,576
Posted By kEhYo77
I think you guys missed the point of my video...

I think you guys missed the point of my video above.

www.youtube.com/watch?v=Sx7HOUJl2Ro&feature=youtu.be&t=2m

Please look again at NEW 'infinity' generator coil design (2:00 mark) that does...
Forum: Renewable Energy 06-06-2017, 06:58 PM
Replies: 411
Views: 95,576
Posted By kEhYo77
GAP POWER Motor and NEW Low Lenz Generator Coil Test

Hi!

Here is my GAP POWER type motor as a test bed for testing different geometries of generator coils. The coil I am testing here is 100 turns 0,3mm wire, air core. WYSIWYG 06.06 sorry for no...
Forum: Renewable Energy 05-18-2017, 01:53 PM
Replies: 72
Views: 10,729
Posted By kEhYo77
Hard to tell, I have't done much testing on that....

Hard to tell, I have't done much testing on that. The goal is to have it spinning with minimal input at as high rpm as possible.
Forum: Renewable Energy 05-17-2017, 12:51 PM
Replies: 72
Views: 10,729
Posted By kEhYo77
Lightbulb Hi everyone! I am currently testing this...

Hi everyone!

I am currently testing this setup, schematic included.
I am not sure if the power draw is high enough (250mA RMS @ 12V @1500 RPM) to truly squeeze the magnetic field of the magnet...
Forum: Renewable Energy 10-26-2016, 01:46 PM
Replies: 2,843
Views: 517,994
Posted By kEhYo77
"How to send out power to the Y-coils whithout...

"How to send out power to the Y-coils whithout that fellow don't kick back to primary?"

By properly placing induced coils, where reflected flux from S with an induced S pole will find an...
Forum: Renewable Energy 10-06-2016, 01:46 PM
Replies: 9
Views: 5,658
Posted By kEhYo77
Coil shorting?

It looks like 'the magic' is happening at TDC. They short and charge the generator coil and power the load with a collapsing BEMF.
Forum: Renewable Energy 09-05-2016, 06:05 PM
Replies: 2,843
Views: 517,994
Posted By kEhYo77
Hanon, are you 101% sure that this is the case...

Hanon, are you 101% sure that this is the case with N and S poles being wrong? I know the patent says that it is a simplified drawing.
To me the whole drawing looks more and more like rectangular...
Forum: Renewable Energy 08-15-2016, 10:52 AM
Replies: 274
Views: 52,339
Posted By kEhYo77
Magrav generator Blueprint

Schematic and video demo of a working off grid unit (https://www.youtube.com/watch?v=q6h1V6WPAHQ&index=27&list=PL8_35_yWAFQl3ABTDKl0OPGD8VOO1HrQ_).
Forum: Renewable Energy 04-08-2015, 07:23 PM
Replies: 14
Views: 5,913
Posted By kEhYo77
I am working on Akula's free energy transformer...

I am working on Akula's free energy transformer setup from his video 00033 (https://www.youtube.com/watch?v=pYjREkw1v-A).
It is finished now and tomorrow I will start testing it, fingers crossed.
Forum: Renewable Energy 03-31-2015, 05:21 PM
Replies: 14
Views: 5,913
Posted By kEhYo77
Just a quick update guyz. I have burnt some...

Just a quick update guyz.

I have burnt some mosfets plus drivers ;) but the modular design of my output stage makes the replacement easy.
Nothing to report so far. I played a bit with JLN's...
Forum: Renewable Energy 03-22-2015, 12:23 AM
Replies: 240
Views: 61,423
Posted By kEhYo77
BiTT setup FINISHED!

Hi.

Finally I have just finished wiring my BiTT setup!
Testing soon so stay tuned...
Forum: Renewable Energy 02-09-2015, 03:15 PM
Replies: 2,843
Views: 517,994
Posted By kEhYo77
Hi Hanon. I think it is all about a delay in...

Hi Hanon.
I think it is all about a delay in the magnetic wave propagation
AND reflecting that wave with a certain type of a load.
I am in the process of replicating this...
Forum: Renewable Energy 02-01-2015, 11:00 AM
Replies: 240
Views: 61,423
Posted By kEhYo77
Low voltage bulbs are in use in some countries in...

Low voltage bulbs are in use in some countries in communal blocks of flats in the basements/staircases to make it hard for people to steal electricity or the bulbs :)
I think 12V car headlight bulbs...
Forum: Renewable Energy 02-01-2015, 09:33 AM
Replies: 240
Views: 61,423
Posted By kEhYo77
Those long elements are capacitors not resistors....

Those long elements are capacitors not resistors.
I understand a bit of Russian.
The power going in is DC around 22V @ 1A ~ 25Watts , he says.
Single transistor is giving a kick only using that...
Forum: Renewable Energy 02-01-2015, 08:04 AM
Replies: 240
Views: 61,423
Posted By kEhYo77
Hi. Have you seen THIS...

Hi.
Have you seen THIS (https://www.youtube.com/watch?v=pYjREkw1v-A) Akula video?

It can't get simpler than that.
Very easy configuration to try.
Primary - Separate secondaries - Separate,...
Forum: Renewable Energy 01-14-2015, 10:52 PM
Replies: 6
Views: 2,804
Posted By kEhYo77
I wonder how ionized water mist would dissociate...

I wonder how ionized water mist would dissociate in Murakami plasma spark ignition in comparison to plain tap water mist.
Hmm... a bigger bang maybe?

kEhYo
Forum: Renewable Energy 01-12-2015, 02:38 PM
Replies: 240
Views: 61,423
Posted By kEhYo77
Hi Dog-One. I have thought of that, it is...

Hi Dog-One.

I have thought of that, it is mentioned in the picture description. :)
Forum: Renewable Energy 01-12-2015, 04:49 AM
Replies: 240
Views: 61,423
Posted By kEhYo77
Maximum switching speed depends on the core...

Maximum switching speed depends on the core material and in case of a ferrite
core can be quite high. What needs to be done to determine the optimal frequency is to measure the time of Cout coil...
Forum: Renewable Energy 01-12-2015, 04:26 AM
Replies: 240
Views: 61,423
Posted By kEhYo77
@Mikey Thanks, yes the force of the magnet...

@Mikey

Thanks, yes the force of the magnet is the main EMF here. :)
The "Cout" coil can be decoupled from the load with a single mosfet
placed after the rectification diode bridge, before an...
Forum: Renewable Energy 01-11-2015, 08:56 PM
Replies: 240
Views: 61,423
Posted By kEhYo77
Hi guyz. Here is an idea I'm am currently...

Hi guyz.

Here is an idea I'm am currently working on.
I have got big ferrite U cores to try it out, two "I"
cores are coming within days.
The basics are in the picture. What is not included ...
Forum: Renewable Energy 12-30-2014, 05:53 PM
Replies: 887
Views: 205,296
Posted By kEhYo77
I think that he means resistance as in resistance...

I think that he means resistance as in resistance to turn the generator as in friction. Off course when under a load condition. And it goes away as the phase angle is increasing with high RPM.
Forum: Renewable Energy 12-30-2014, 03:59 PM
Replies: 887
Views: 205,296
Posted By kEhYo77
Hi. To me it looks like high inductance of his...

Hi. To me it looks like high inductance of his pole motor used as a generator here causes CEMF delay when on load, reducing load on a generator DC motor. And the same thing happens with those can...
Forum: Renewable Energy 12-30-2014, 03:13 PM
Replies: 189
Views: 45,372
Posted By kEhYo77
Hi. To me it looks like high inductance of his...

Hi. To me it looks like high inductance of his pump motor used as a generator here causes CEMF delay when on load, reducing load on a prime mover DC motor. And the same thing happens with those can...
Forum: Renewable Energy 12-04-2014, 07:13 PM
Replies: 388
Views: 102,114
Posted By kEhYo77
Low Lenz Generator

Hi, here is my take on this.
Showing results 1 to 25 of 171

 

Please consider supporting Energetic Forum with a voluntary monthly subscription.

Choose your voluntary subscription

For one-time donations, please use the below button.


All times are GMT. The time now is 07:56 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimisation provided by DragonByte SEO v1.4.0 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Shoutbox provided by vBShout v6.2.8 (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
2007-2015 Copyright - Energetic Forum - All Rights Reserved

Bedini RPX Sideband Generator

Tesla Chargers