Energetic Forum  
Facebook Twitter Google+ Pinterest LinkedIn Delicious Digg Reddit WordPress StumbleUpon Tumblr Translate Addthis Aaron Murakami YouTube 2020 ENERGY CONFERENCE - PRE-REGISTER NOW!!!!

2020 Energy Science & Technology Conference
PRE-REGISTER NOW!!!
http://energyscienceconference.com


Go Back   Energetic Forum >
   

* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX

Showing results 1 to 25 of 92
Search took 0.00 seconds.
Search: Posts Made By: dR-Green
Forum: Eric Dollard Official Forum 07-06-2012, 07:20 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Sounds like a lot of work went into them. I don't...

Sounds like a lot of work went into them. I don't know how the loading coil is supposed to work, but I managed to get two spirals with a lot less work than you've put into them to work* without it....
Forum: Eric Dollard Official Forum 07-06-2012, 06:21 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Farmhand isn't a trouble maker, it's just a...

Farmhand isn't a trouble maker, it's just a misunderstanding/miscommunication that has obviously completely spiralled out of hand. I was also involved in the TMT "Replications" thread and if it...
Forum: Eric Dollard Official Forum 07-04-2012, 10:16 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
This might hint towards the answer:

This might hint towards the answer:
Forum: Eric Dollard Official Forum 07-04-2012, 08:07 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Further testing indicates that the secondary...

Further testing indicates that the secondary reading in the "second peak resonance" test appears to be the extra coil being picked up by the probe, not the secondary.

No resonant peaks were found...
Forum: Eric Dollard Official Forum 07-03-2012, 11:26 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
It's not clear what you're doing here. Are you...

It's not clear what you're doing here. Are you using a signal generator? And if so at what frequency? You should do a frequency sweep of the coil, and then take the 70.7% value of the peaks to find...
Forum: Eric Dollard Official Forum 07-03-2012, 09:19 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
I don't know, but there are certainly two modes...

I don't know, but there are certainly two modes of operation that seem to be very different. The easiest way to get the 3670 kc resonance is to set the condenser rings to maximum capacitance, with...
Forum: Eric Dollard Official Forum 07-03-2012, 08:57 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Hehe, thanks Sputins :thumbsup: Those spiral...

Hehe, thanks Sputins :thumbsup: Those spiral coils you posted before were looking nice too. How are they coming along?
Forum: Eric Dollard Official Forum 07-03-2012, 08:43 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
I don't know. But I suppose there's only one way...

I don't know. But I suppose there's only one way to find out for sure :thumbsup: Looking back it looks like one reason you need thicker wire is because your condenser rings are set 1mm apart just to...
Forum: Eric Dollard Official Forum 07-02-2012, 08:14 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Which comment was that? I used the same extra...

Which comment was that? I used the same extra coil frame as before. I don't know about the enamel vs insulated wire. Eric said before that the height to width ratio of the coil is more important than...
Forum: Eric Dollard Official Forum 07-02-2012, 06:55 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
New extra coil: Diameter = 8.28cm Height =...

New extra coil:

Diameter = 8.28cm
Height = 8.28cm
64.25 Turns
Wire length = 16.47 metres 20 SWG (0.9mm)
Luminal frequency = 4550.8 kc
Free space frequency = 8509.996 kc
Measured frequency =...
Forum: Eric Dollard Official Forum 07-02-2012, 01:52 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
So far with the new extra coil it has been found...

So far with the new extra coil it has been found that to get resonance at 3670 kc the condenser rings need to be set at maximum capacitance, and equally maximum relative terminal capacitance on the...
Forum: Eric Dollard Official Forum 07-01-2012, 11:49 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
"If not you, then who? If not now, then when?" ...

"If not you, then who? If not now, then when?"

:thumbsup:
Forum: Eric Dollard Official Forum 06-30-2012, 07:46 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Thanks again Eric. I think I know how you came up...

Thanks again Eric. I think I know how you came up with that now, basically making the extra coil wire length for 124% the velocity so divide the wavelength by 1.24? I was unwinding the coil ready to...
Forum: Eric Dollard Official Forum 06-29-2012, 10:06 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Extra coil wire length for 3700 = 32 metres ...

Extra coil wire length for 3700 = 32 metres
3670 = 32.27 metres

As it currently stands with 124 turns I have 31.75 metres, but the wire spacing is also changed and apparently that has no small...
Forum: Eric Dollard Official Forum 06-29-2012, 07:23 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
A quick note. I'm down to 124 turns from 126 and...

A quick note. I'm down to 124 turns from 126 and doing tests of each one. 125 turns got better than 126, but 124 is worse than both. Apparently with 124 turns I can make up for it a bit with tiny...
Forum: Eric Dollard Official Forum 06-29-2012, 05:52 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
A diagram would help because we don't have a clue...

A diagram would help because we don't have a clue what you're talking about with this connected to that etc.



It's shown on the previous page and can be seen in effect in the test data I...
Forum: Eric Dollard Official Forum 06-29-2012, 12:37 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
No what? 54 + 54 = 108. I don't understand what...

No what? 54 + 54 = 108. I don't understand what you're talking about without diagrams. What is "all metal", and with which setup? What does your setup do without any extra coil?
Forum: Eric Dollard Official Forum 06-28-2012, 07:57 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
That's about 108 metres total. Have you been able...

That's about 108 metres total. Have you been able to receive the radio using Eric's exact circuit? And are you able to receive the signal with only the secondary using the same circuit?
Forum: Eric Dollard Official Forum 06-28-2012, 06:12 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
In what respect? Some graphs and what not from...

In what respect? Some graphs and what not from tests of those would be nice :D
Forum: Eric Dollard Official Forum 06-28-2012, 06:04 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
The radio station is 882 kc. However the plan is...

The radio station is 882 kc. However the plan is to next remove turns from this extra coil and do more tests, and then apply whatever comes from that, either to a new extra coil for 3670 kc or a...
Forum: Eric Dollard Official Forum 06-28-2012, 02:15 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Within the limits of my 5 Mc signal generator: ...

Within the limits of my 5 Mc signal generator:

Nothing else found on the secondary with the rings tuned for 3670 kc.

Extra coil 10pF: There's a gradual rise as I approach the 5 Mc limit. Based...
Forum: Eric Dollard Official Forum 06-27-2012, 09:11 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
In my opinion it's pretty much confirmed, because...

In my opinion it's pretty much confirmed, because a flat spiral works as a Telluric receiver, consisting of only a primary and secondary coil. So it would seem that the frequency is set in the...
Forum: Eric Dollard Official Forum 06-27-2012, 07:32 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
Thank you Eric. I'm definitely a beginner, not...

Thank you Eric. I'm definitely a beginner, not even a HAM operator, but I'm up for the challenge :D I'm not up to date on all the theory which is why I don't participate in much discussion on that...
Forum: Eric Dollard Official Forum 06-27-2012, 03:59 AM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
So far I've borrowed the inductor (1 metre of...

So far I've borrowed the inductor (1 metre of wire) with ferrite rod from a basic crystal radio kit. I'm unable to get anything to happen with an incandescent or the fluorescents I have....
Forum: Eric Dollard Official Forum 06-26-2012, 09:35 PM
Replies: 915
Sticky: Eric P. Dollard
Views: 232,161
Posted By dR-Green
David/Smokey, I don't know about anyone else but...

David/Smokey, I don't know about anyone else but I'm always confused by your posts. Would it be possible to give INDIVIDUAL coil specs with results, one at a time? All being lumped together along...
Showing results 1 to 25 of 92

 

Please consider supporting Energetic Forum with a voluntary monthly subscription.

Choose your voluntary subscription

For one-time donations, please use the below button.


All times are GMT. The time now is 09:24 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimisation provided by DragonByte SEO v1.4.0 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
Shoutbox provided by vBShout v6.2.8 (Lite) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
2007-2015 Copyright - Energetic Forum - All Rights Reserved

Bedini RPX Sideband Generator

Tesla Chargers