Energetic Forum  
Facebook Twitter Google+ Pinterest LinkedIn Delicious Digg Reddit WordPress StumbleUpon Tumblr Translate Addthis Aaron Murakami YouTube ONLY 13% OF SEATS AVAILABLE!!!*** 2017 ENERGY CONFERENCE ***


* NEW * BEDINI RPX BOOK & DVD SET: BEDINI RPX


Go Back   Energetic Forum > >
   

Renewable Energy Discussion on various alternative energy, renewable energy, & free energy technologies. Also any discussion about the environment, global warming, and other related topics are welcome here.

Bedini RPX Sideband Generator
Reply
 
Thread Tools
  #31  
Old 06-12-2017, 01:10 PM
Ufopolitics's Avatar
Ufopolitics Ufopolitics is offline
Platinum Member
 
Join Date: Feb 2012
Location: US, Florida
Posts: 4,471
The Learning Curve...til it gets "straight"...

Hello to All,

I have been conducting several testings...and I mean several, as they involve all kind of different cores and coils sizes and gauges...different winding methods, etc,etc.

All along this development I have faced downward curves (disappointments) as going up curves which give me some hope...until I start riding a straight line going up and up...that is where I am now.

Like I mentioned on my latest video...Exciter Coils are wound in a very different way...than conventional means, all leading to improvement, where we use the MINIMAL ENERGY to excite STRONG CHANGING FIELDS.

And so, I finally refined the way the "Collecting Coils" or "Secondaries", or "Induced Coils" are wound AND CONNECTED.

Secondaries are wound also different than conventional, in order not to have amps losses (Decay) to gain higher voltages as pulsations increase (which translate to "FIELD CHANGES RATIO")

I built two secondaries with same number of turns, same gauge...same resistance, but one being "conventional" and the other one "improved"...In order to compare results, and the difference is outrageous.

When I write conventional related to Secondaries, I meant layers back and forth along core length, following same direction of winding...this conventional method tends to decrease amps as I split wires to read out at different layers. EVEN if all turns are wound same direction, the currents directions fluctuate from one extreme of core to the other in every layer, if we look at "translation along core axis vectors", which renders a constant opposition of vectors from identical spinning of currents flow directions.

Therefore, I made it in order that just one directional flow is wound through different layers acquiring induction...then all "return" conductors between layers, travel in a fashion which do not get induced by field changes since they are not "turned" around core, but straight.

I also refined the whole device as to make it as compact as possible...and of light weight as possible.


You will see the whole thing soon...


Regards


Ufopolitics
__________________
Principles for the Development of a Complete Mind: Study the science of art. Study the art of science. Develop your senses- especially learn how to see. Realize that everything connects to everything else.― Leonardo da Vinci

Last edited by Ufopolitics; 06-12-2017 at 01:16 PM.
Reply With Quote

Download SOLAR SECRETS by Peter Lindemann
Free - Get it now: Solar Secrets

  #32  
Old 06-12-2017, 10:32 PM
Bob Smith Bob Smith is offline
Silver Member
 
Join Date: Sep 2007
Posts: 763
Quote:
Originally Posted by Ufopolitics View Post
You will see the whole thing soon...
Looking forward to it, UFO!
Bob
__________________
 
Reply With Quote
  #33  
Old 06-12-2017, 11:33 PM
Cornboy 555's Avatar
Cornboy 555 Cornboy 555 is offline
Silver Member
 
Join Date: Aug 2011
Posts: 796
Quote:
Originally Posted by Bob Smith View Post
Looking forward to it, UFO!
Bob
Love to see exactly what you mean, also.

Warm Regards Cornboy.
__________________
 
Reply With Quote
  #34  
Old 06-13-2017, 03:33 AM
BroMikey's Avatar
BroMikey BroMikey is offline
Platinum Member
 
Join Date: Jan 2013
Posts: 4,418
Quote:
Originally Posted by Ufopolitics View Post
Hello to All,

I have been conducting several testings...and I mean several, as they involve all kind of different cores and coils sizes and gauges...different winding methods, etc,etc.

All along this development I have faced downward curves (disappointments) as going up curves which give me some hope...until I start riding a straight line going up and up...that is where I am now.

Like I mentioned on my latest video...Exciter Coils are wound in a very different way...than conventional means, all leading to improvement, where we use the MINIMAL ENERGY to excite STRONG CHANGING FIELDS.

And so, I finally refined the way the "Collecting Coils" or "Secondaries", or "Induced Coils" are wound AND CONNECTED.

Secondaries are wound also different than conventional, in order not to have amps losses (Decay) to gain higher voltages as pulsations increase (which translate to "FIELD CHANGES RATIO")

I built two secondaries with same number of turns, same gauge...same resistance, but one being "conventional" and the other one "improved"...In order to compare results, and the difference is outrageous.

When I write conventional related to Secondaries, I meant layers back and forth along core length, following same direction of winding...this conventional method tends to decrease amps as I split wires to read out at different layers. EVEN if all turns are wound same direction, the currents directions fluctuate from one extreme of core to the other in every layer, if we look at "translation along core axis vectors", which renders a constant opposition of vectors from identical spinning of currents flow directions.

Therefore, I made it in order that just one directional flow is wound through different layers acquiring induction...then all "return" conductors between layers, travel in a fashion which do not get induced by field changes since they are not "turned" around core, but straight.

I also refined the whole device as to make it as compact as possible...and of light weight as possible.


You will see the whole thing soon...


Regards


Ufopolitics
Only 1 wire is connected to source but the meter forms a dead short by
using the amp shunt.?? Too cool.
__________________
 
Reply With Quote
  #35  
Old 06-13-2017, 01:49 PM
Ufopolitics's Avatar
Ufopolitics Ufopolitics is offline
Platinum Member
 
Join Date: Feb 2012
Location: US, Florida
Posts: 4,471
A Module Configuration...

Quote:
Originally Posted by BroMikey View Post
Only 1 wire is connected to source but the meter forms a dead short by
using the amp shunt.?? Too cool.
Hello BroMikey,

Ok, the Exciter is made of Two Windings, Two strands of wire, but wound opposedly related to each others, as explained on the video, in order that both have their start point at each extreme of core.

Now, only ONE(1) Pulsed Signal is sent to just one of the starting points (Let's call it Start 1)and end connected to ground (-).

The other start and end are looped into an LC Tank which does a mirror from BOTH PULSES, one Pulse is the real signal sent to Start 1, and other as the mirror (opposed, offset)...So, this LC Tank amplifies BOTH Magnetic Field Fluctuations, while we only need to send, spend in one signal...

Secondaries are wound like I wrote before...one way layers which get their returns outside of Field Influence, simply because they are not wound in Turns around Core.

This is the simple set up...it will get more complicated after I add other secondaries to the same exciter...where all these returns will actually connect to other secondaries, ALL made of one way layers, so, secondary circuit is closed around exciter embodiment. Then returns serve as connectors between them.

1-One Secondary is set at Inner Center of Exciter.

2-Other is set at Outer Center of Exciter.

3-Then Two more Secondaries which are set on each side of exciter.

Meaning A MODULE will have One Exciter Assembly (1 Signaled (Directly Excited) Coil and the other as an LC Mirror) plus FOUR Secondaries wound around its Geometry.

Remember Magnetic Fields are 360 Spherically and Spatially surrounding Exciter Assy.

Having Secondaries added ALL AROUND Exciter System is an advantage that only can be done to Static Generators...can't do it with rotary ones...so they loose all these Spatial Influences.

I know it may sound complicated...but just one of my drawings will reveal the whole thing...


Regards


Ufopolitics
__________________
Principles for the Development of a Complete Mind: Study the science of art. Study the art of science. Develop your senses- especially learn how to see. Realize that everything connects to everything else.― Leonardo da Vinci

Last edited by Ufopolitics; 06-13-2017 at 04:51 PM.
Reply With Quote
  #36  
Old 06-14-2017, 04:29 AM
BroMikey's Avatar
BroMikey BroMikey is offline
Platinum Member
 
Join Date: Jan 2013
Posts: 4,418
Quote:
Originally Posted by Ufopolitics View Post
Hello BroMikey,
can't do it with rotary ones...so they loose all these Spatial Influences.

I know it may sound complicated...but just one of my drawings will reveal the whole thing...


Regards


Ufopolitics
goodness sakes, you have been busy. So i take it that unless the exciter
coil set is opposing winds it does not do well.

And to ground? Wow that is interesting. I take it you mean EARTH.
__________________
 
Reply With Quote
  #37  
Old 06-14-2017, 02:37 PM
Ufopolitics's Avatar
Ufopolitics Ufopolitics is offline
Platinum Member
 
Join Date: Feb 2012
Location: US, Florida
Posts: 4,471
Quote:
Originally Posted by BroMikey View Post
goodness sakes, you have been busy.

You have absolutely no idea how busy I have been over this development...

Quote:
Originally Posted by BroMikey View Post
So i take it that unless the exciter
coil set is opposing winds it does not do well.
All relates to generate IDENTICAL, BUT OPPOSED MAGNETIC FIELDS by each Coil wind along the Core Axis.

Quote:
Originally Posted by BroMikey View Post
And to ground? Wow that is interesting. I take it you mean EARTH.
My bad...I meant Negative, that is why I set a (-) next to the word "ground"

The main exciter receiving the signal which is a pulsating Positive while Negative from source is FIXED...that is what I meant Mikey.


Regards


Ufopolitics
__________________
Principles for the Development of a Complete Mind: Study the science of art. Study the art of science. Develop your senses- especially learn how to see. Realize that everything connects to everything else.― Leonardo da Vinci
Reply With Quote
Reply

Tags
pulses, flow, direction, field, alternated, coil, v+2, v+1, time, current, image, creating, boosters, weightless, principle, massless, magnetic, bifilar, coils, frequency, simplest, part, driven, times, reverses

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Please consider supporting Energetic Forum with a voluntary monthly subscription.

For One-Time Donations, use admin@ this domain > energeticforum.com

Choose your voluntary subscription

All times are GMT. The time now is 05:24 PM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2017, vBulletin Solutions, Inc.
Search Engine Optimisation provided by DragonByte SEO v1.4.0 (Pro) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
Shoutbox provided by vBShout v6.2.8 (Lite) - vBulletin Mods & Addons Copyright © 2017 DragonByte Technologies Ltd.
2007-2015 Copyright - Energetic Forum - All Rights Reserved

Bedini RPX Sideband Generator

Tesla Chargers