Announcement

Collapse
No announcement yet.

HHO dry cell type water splitting DIY + Q&A + FAQ

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    HHO dry cell type water splitting DIY + Q&A + FAQ

    Hi,
    tons of posts, already, hate to hijack anyone's thread, really hard working people, great work much effort...

    my problem:
    how does one begin to end up with a properly sized HHO-e-lyzer?

    I made one 6 cell 5mm gap and was a bit dissapointed.

    then i currently explore a 10 cell 3mm gap one and I'm just not sure:

    Is the dry cell type seen as an inductive load to it's power supply?

    I have back-spikes here, oscillations, i had to put a diode to the PWM powerstage to mitigate and yet there are some left?

    Best regards,
    Stevan C.
    Tags: None
  • #2
    I guess I didn't point out I use a "dry cell" sort of electrolyzer, and not a "smack" type, if that matters.
    Are there any advantages in regards Smack vs Dry cell?

    Comment

    • #3
      Hi Steven ,most call this the hydroxy "bible" our community authored it.
      check the dry cell designs and FACULTY section of the document.
      Panacea University - Courses
      ->hydroxy course

      Also check Patrick's chapter 10
      Practical Guide to Free-Energy Devices - Chapter 10

      Also check this thread for the open source design
      http://www.energeticforum.com/renewa...-dry-cell.html

      Ash

      Comment

      Previous template Next
      Working...
      X