alexelectric
Senior Member
Last Activity: Today, 04:13 AM
Joined: 08-05-2016
Location:
-
I shared the document, so that it will be studied and valued, by everyone, whether favorable or unfavorable, agree or disagree with Thane, their observations... -
Leave a comment:
-
What news, Se ,. May his brother recover soon, may he be in good health...Leave a comment:
-
It will, Mr. Dave, it will have less voltage and more amperage, the good thing is that it has more magnets, and it can compensate for more of the two...Last edited by alexelectric; 04-05-2021, 05:50 AM.Leave a comment:
-
Okay. pmgriphone
The connection that is made in this way in multiple wires in series and parallel, helps us with more capacitance in the...Last edited by alexelectric; 04-05-2021, 05:11 AM.Leave a comment:
-
Sure the inductance changes, core or no core, but the resistance in the ohm measurement, will be the resistance of the conductor, you commented 60 ohm...Last edited by alexelectric; 04-05-2021, 02:48 AM.Leave a comment:
-
The resistance readings are correct those of Mr. Dave and the one I measured, if wire # 23 were 3000 feet it would directly measure what you comment,...Leave a comment:
-
Ok Mikey, If you add more series connections, the resistance and voltage are increased, but the current decreases, and if you work at a slower speed,...Last edited by alexelectric; 04-04-2021, 10:09 PM.Leave a comment:
-
But everything is interesting what Mr. Dave and Mr. Mikey share, their coils, how many threads, the length, the magnets, the dimensions of the rotor,...Leave a comment:
-
If you run your current generator 2800 rpm, you will have a lot of induction, as you have more magnets, you can also operate it at minus 1400-1800 rpm,...Leave a comment:
-
Be careful not to have the acceleration at 2800 rpm, one tries to obtain it at more rpm 3000 rpm and more, that is already careful, that is what happened...Leave a comment:
-
The one I built was 256 feet per line, 12 lines, on the spool I showed, Mr. Dave built it according to the data he sent us...Leave a comment:
-
The diameter of the finished coil is 1 or 2 millimeters less than the diameter (F),
And it depends on the length you wind, in one I built it with...Leave a comment:
-
Here is the data Mr. Dave
Injection Molded Plastic Spools and Reels | Nortic Inc.
http://www.norticinc.com/plastic-spool/...Leave a comment:
-
Here are the spool measurements for the coil...Leave a comment:
-
ok thanks, I check itLeave a comment:
-
Mr. Dave's Coil Data
146.6 mh without magnet
126.5 mh with magnet
5.9 ohm coil ohm
You can see the difference in...Leave a comment:
-
I also estimate how generation can be maintained at a variable load, since every generator requires different consumption during its operation.
...Last edited by alexelectric; 04-02-2021, 04:21 AM.Leave a comment:
-
Mr dave
That's right, as you comment if you put the coils in series you increase the impedance and change the frequency at which it...Leave a comment:
-
Look what I wanted to ask about Mr. Morin
You no longer have new videos
When Mr. Morin popularized the washing machine motor...Last edited by alexelectric; 03-31-2021, 07:46 PM.Leave a comment:
No activity results to display
Leave a comment: