Announcement

Collapse
No announcement yet.

alternate uses for bedini mechanical output

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • alternate uses for bedini mechanical output

    ok, i lurk a lot and don't post much, my apologies.
    i would like to use this thread to discuss other ways to harness the mechanical power of the bedini SG other than for a fan. i played with the flipflop magnets in a coil (bike lights) a few months ago. this was touched on in another thread and is what got me motivated to create this thread.
    so here are a few ideas i have been kicking about but haven't had the time or $ to experiment with.

    an SG with a fan and a shroud to collect as much of the air as possible and route it into a tesla turbine, perhaps made from an old hard disk drive?

    an SG coupled to a wimshurst and route the stored energy from the leyden jars to? the batteries? the front end?

    i look forward to anyones input or new ideas. 2 heads are better than one or so i'm told.

  • #2
    I have no idea, all is i will do is show you my crazy ideas.

    A Dual Fan vortex concept.
    I know a guy at the gold coast in Queensland Aus, who uses industrial
    fans and recoverer's 100% the energy by this system using a wind vortex.

    Now obviously i did not create a vacuum here and the second fan being
    powered by the first is not running full RPM, but does that mean we
    cannot create a vortex and get it spinning one to one? .
    Dual Bedini Fan kit conept

    Plus the other crazy half XXXX's one is make a trifilla next to the fan (with magnet on the rotor) and try and make two kits form one.

    told you they were crazy ideas

    Comment

    Working...
    X