2019 Energy Conference

[BroMikey]

A 500 watt incandescent bulb was lit to full brightness

Wow that is plenty of power to warrant a replication. From Eric's past
vid's seems like I remember he had transmitted (or does it have to be)
at some other location like down at the lake and few miles away
collect energy? It can't work at one location? In other words my
question is how much earth does it require to go thru to pick up the extra
power? Or doesn't it need much ground to work.

And if I can get 500w in the kitchen can I also get another 500w in
the garage? Or does the power divide?

getting the plans seems like the best way to go.

[yaro1776]

Here are the things obviously demonstrated:
boost am reception
flame speaker
golden ratio impulse flame
field intensity
neutral spot
tentacle discharge
Tesla's rotating brush (in tip of plasma tube)
500 watt bulb

Stuff not obvious is:
The neutral spot is the gateway into counterspace
The transmission from transmitter to receiver is extralunimal - outside of the so-called light speed constraints erroneously tied to electricity.
Violation of Ampere's Law
Violation of Conservation of Energy
few other things...

I will hold off uploading the video of the last segment of the Dollard demo (the segment that demonstrated the one wire 500 watt light bulb) until the end of next week; a big thanks to you Aaron for filling in the details - much of that came back to me after I read the above a couple of times.

Anyway, I have attached 3 pics. Two pics depict the twin antenna arrangement (about 20 feet apart) and the third shows the spark emitted by the receiving antenna in the radio receiving mode.

I do hope that the Dollard video presentation has a clip in it of the/an actual demonstration. If not, we will work out a plan B - way too cool and important to neglect. In any case the ESTC video is on my list.

Yaro

[BroMikey]

the one wire 500 watt light bulb)

Yaro

http://www.energeticforum.com/attachments/renewable-energy/22016d1563986557-2019-energy-conference-ericd-tesla3-jpg

@yaro Very Cool. No dirt needed got it. Ground helps but works without.
How many watts does it take on the transmitter side (590watts??)

We will say an 85% conversion efficiency so 590w X .85 = 500w

But who cares you can put up as many as you want and get 500w out
again and again, right?

[Aaron]

Colorado Springs Tesla Transformer presentation available now

http://www.energeticforum.com/attachments/renewable-energy/22016d1563986557-2019-energy-conference-ericd-tesla3-jpg

@yaro Very Cool. No dirt needed got it. Ground helps but works without.
How many watts does it take on the transmitter side (590watts??)

We will say an 85% conversion efficiency so 590w X .85 = 500w

But who cares you can put up as many as you want and get 500w out
again and again, right?

You can get a copy of the presentation and learn all the details.

Eric Dollard's presentation is available here: Theory, Calculation & Operation of the Colorado Springs Tesla Transformer by Eric Dollard

[Aaron]

Theory, calculation & operation of the colorado springs tesla transformer by eric dol



NEW RELEASE * THEORY, CALCULATION & OPERATION OF THE COLORADO SPRINGS TESLA TRANSFORMER BY ERIC DOLLARD

We're very excited and honored to be a part of history where Eric Dollard shows a working 20:1 scale model replica of Nikola Tesla's Colorado Springs Magnifying Transformer!

If you ever wanted to know the truth down to the finest detail on what Tesla actually did, here is your opportunity. Not only will you learn the operating theory and more data than you will ever want to know, you'll get all details on how to replicate a 20:1 scale model along with an actual demonstration by Eric Dollard and Bruce Gavin. So, it's not just talk, you see the demonstration that blew everyone away!

Go here to get your copy now & learn more - see some pics!! Theory, Calculation & Operation of the Colorado Springs Tesla Transformer by Eric Dollard

When you check out of the shopping cart, make sure to click the GREEN button to access the download. Details are here: Download Help - A & P Electronic Media This is INSTANT ACCESS - you do not need to wait for an e-mail to come with download instructions - you're already there.

On the download page, you can get the 3 zip files that have everything in hi resolution format, but it's fairly large. If you have limited bandwidth, you can get the lower resolution ones that are quite a bit smaller (still a lot of megabytes). The point is that you do NOT need to download all 6 zip files, just hi-res or lower-res. Hi Res is 1920x1080 and the lower one, which is still high quality is 1280x720.

There are 5 things that come with this package.

Part 1 of the 4 hour presentation
Part 2 of the 4 hour presentation
20 minute demonstration video
35 minute white board overview of the demonstration setup
553 page PDF of the PowerPoint presentation

The introductory discounted price is only good for the next 24 hours then it goes up to the regular price.

Go here to get your copy now & learn more - see some pics!! Theory, Calculation & Operation of the Colorado Springs Tesla Transformer by Eric Dollard

A portion of the proceeds to go EPD Laboratories, Inc., a 501(c)3 non-profit organization dedicated to the work of Eric Dollard.

If you attended the 2019 ESTC, use the code given at the conference for your special ESTC discount. It was emailed to you yesterday, check your spam box if you can't find it.

[BroMikey]

Thx Aaron that is a lot of money

I want to buy the book soon so I can see what it takes to replicate.
I'de like to have that is my collection. Do you still produce hard copies
for more? My printer is good too.

Soon I am going to buy this set of plans.

[Aaron]

Cost of replication

Thx Aaron that is a lot of money

I want to buy the book soon so I can see what it takes to replicate.
I'de like to have that is my collection. Do you still produce hard copies
for more? My printer is good too.

Soon I am going to buy this set of plans.

What's a lot of money? The replication or presentation package?

All replication info is in the video presentation with every last spec.

The PowerPoint may become a paperback but not anytime soon.

[yaro1776]

2019 ESTC Tesla Tower Demo

Fear not the Tesla Demo was recorded and is included in the Dollard package. I watched it yesterday a number of times and it has all the different demo pieces - Radio, Plasma tubes, 6 ft. fluorescent tube and the 500 watt incandescent. Makes my short cell video irrelevant. BTW, it turns out that Eric D. is quite the showman with his light sabre.

The .PDF is an awesome and very useful addition - an excellent bonus to the video and the entire package.

All in all, this presentation package is one the best produced...

Yaro

[BroMikey]

What's a lot of money? The replication or presentation package?

All replication info is in the video presentation with every last spec.

The PowerPoint may become a paperback but not anytime soon.

You guys spent a ton of money, I hope you get some back. Got to take
a chance sometimes.

[Aaron]

Colorado Springs

Jedi Dollard with the light saber looks like he is about to sleigh the laws of physics and he did!

There is now a short excerpt of just a couple of the demonstrations on the website: Theory, Calculation & Operation of the Colorado Springs Tesla Transformer by Eric Dollard

[BroMikey]

Jedi Dollard with the light saber looks like he is about to sleigh the laws of physics and he did!

There is now a short excerpt of just a couple of the demonstrations on the website: Theory, Calculation & Operation of the Colorado Springs Tesla Transformer by Eric Dollard

Cool demo, did he say it wasn't even turned on? Or was it using
(I heard Eric say) 800watts? I know he was feeding in an AM signal.

I can't say I know what just took place, please explain.

Thanks Aaron PS Eric's mic did his justice but your mic made it almost
impossible to hear what you were saying. I turned my base off and treble
all the way up and your message (the key to the demo) was hard to
listen to. Not like all your other interviews at all.

[Aaron]

am radio

Cool demo, did he say it wasn't even turned on? Or was it using
(I heard Eric say) 800watts? I know he was feeding in an AM signal.

I can't say I know what just took place, please explain.

Thanks Aaron PS Eric's mic did his justice but your mic made it almost
impossible to hear what you were saying. I turned my base off and treble
all the way up and your message (the key to the demo) was hard to
listen to. Not like all your other interviews at all.

Can't do anything about it, we can't have wired mics around that equipment.

The Tesla Transformer is not powering the am radio obviously. The AM radio is simply being connected to a ground connection and being that the transformers are tuned to the same radio station, the signal is strengthened as if the AM station is right next door. That is because the strength of the signal under the ground does not conform to the inverse square law - there is plenty of power avail for strong signal.

[BroMikey]

Okay Aaron thank you for making this possible, without you I don't
think Eric could have done so well. It is a hard job but you can do it.
I know this that any extra task piles up and it ain't easy.

Only a stubborn mule can handle the load.

The other video of Eric tuning was cool also.

[Aaron]

Adrian

Check out Adrian's post and links in the Eric Dollard thread.

[BroMikey]

Check out Adrian's post and links in the Eric Dollard thread.

10-roger