PDA

View Full Version : alternate uses for bedini mechanical output


CaptainScat
02-22-2008, 10:38 PM
ok, i lurk a lot and don't post much, my apologies.
i would like to use this thread to discuss other ways to harness the mechanical power of the bedini SG other than for a fan. i played with the flipflop magnets in a coil (bike lights) a few months ago. this was touched on in another thread and is what got me motivated to create this thread.
so here are a few ideas i have been kicking about but haven't had the time or $ to experiment with.

an SG with a fan and a shroud to collect as much of the air as possible and route it into a tesla turbine, perhaps made from an old hard disk drive?

an SG coupled to a wimshurst and route the stored energy from the leyden jars to? the batteries? the front end?

i look forward to anyones input or new ideas. 2 heads are better than one or so i'm told.

ashtweth
02-23-2008, 02:51 AM
I have no idea, all is i will do is show you my crazy ideas.

A Dual Fan vortex concept.
I know a guy at the gold coast in Queensland Aus, who uses industrial
fans and recoverer's 100% the energy by this system using a wind vortex.

Now obviously i did not create a vacuum here and the second fan being
powered by the first is not running full RPM, but does that mean we
cannot create a vortex and get it spinning one to one? :).
Dual Bedini Fan kit conept (http://video.google.com.au/videoplay?docid=1470631096244705068&hl=en-AU)

Plus the other crazy half XXXX's one is make a trifilla next to the fan (with magnet on the rotor) and try and make two kits form one.

told you they were crazy ideas:)