PDA

View Full Version : Anyone have a good window motor design?


carter
09-12-2012, 05:32 PM
I want to build a window motor. I need a list of parts and a picture of how to connect the circuit. Any info/links would be appreciated.

naxompax
03-26-2013, 08:47 AM
I followed this schematic closely, and had good results. I ordered the parts from ebay. I got the hall effect sensors from mouser electronics. The link below is the link I used....plus I read the entire site on Bedini at fight 4 truth. The stator frame and rotor were created on a 3D printer. My earlier ones had various Shoestring approaches....ZZ bearings, wood frames....be careful with neos, I had some I kept in a closet they were so dangerous (someone got hurt everytime they came out of the closet) They need to be properly and securely fastened.

http://www.fight-4-truth.com/Bedini-Cole%20window%20motor.doc

Nax

ET-Power
02-26-2017, 10:55 AM
Hello,

Is anyone located in California, or near Northern California?

I have two window motors both of which are not working as they were damaged in transportation. I attempted to repair them by replacing the opto isolator but it was not successful. Should be a simple fix, but I am no engineer/technician as I am new to the hands on aspects.

LOOKING FOR AN EXPERIENCED INDIVIDUAL FOR HELP, THIS WILL LEAD TO CONSISTENT WORK IF YOU DESIRE.

THANK YOU!
shamanichealing@nym.hush.com