PDA

View Full Version : Healing lights.


Ewhaz
09-23-2007, 03:04 AM
This is concerning the page in the Energetic Science Ministry website.

Energetic Science Ministries | Healing with LED's | Aaron Murakami (http://www.esmhome.org/library/led.html)

I've actually built an oscillator that runs some LED's at close to the three frequencies and can switch between the three. However, There wasn't very much information on what each frequency effected, other than to say it was dependent on where the tissue originated (I'm assuming this is in embryo)

Does any one have any more information on how to determine what frequencies effect what tissues?

Aaron
09-23-2007, 04:39 AM
Hi Ewhaz,

The frequency set is the Nogier frequency set by Paul Nogier of France the Father of Ear Acupuncture Medicine who advanced the ear map. These are the main frequencies. They are doubles of each other.

292 = Ectoderm
584 = Mesoderm
1168 = Endoderm

Ewhaz
09-23-2007, 08:42 PM
Hi Aaron.

I'm aware of the three frequencies, I'm in the process of measuring the frequency output of my oscillator to verify that those are the frequencies I'm putting out.

However, ectoderm mesoderm and endoderm do not tell me if the frequency is best for skin, muscle or nerve tissue.. I looked on line and found Paul Nogier's information, but everything on him is concerning his acupuncture There is little or no information on what the three types of tissue refer to.

EDIT:

I wish I had done this first though, I looked the terms up and found this:

Ectodermal
Ectoderm - Wikipedia, the free encyclopedia (http://en.wikipedia.org/wiki/Ectoderm)

Endodermal
Endoderm - Wikipedia, the free encyclopedia (http://en.wikipedia.org/wiki/Endodermal)

Mesodermal
Mesoderm - Wikipedia, the free encyclopedia (http://en.wikipedia.org/wiki/Mesoderm)

The only other thing I don't know is how accurate this needs to be. The article mentions that even a simple red light speeds healing, so I don't think it needs to be exact. I have my circuit oscillating within 100 hz or so of the target frequencies. I can probably use a trimmer to dial it in if I wanted.