View Single Post
 
Old 11-25-2018, 11:47 AM
gyula gyula is offline
Silver Member
 
Join Date: Apr 2007
Posts: 820
Hi Paul,

Can you check the link to your above video? It says an error occured and cannot be watched.

It sounds good you test acetal for magnet holders. However, let me ask whether you increased the air gap by at least 0.5 mm on the side where you found the piece of paper did not go through straight? (I know there are huge attract forces involved and handling the nuts may not be easy.)

Sorry if you already increased that one gap to get rid of the earlier unwanted friction, if you did, then did you also find the free spinning still very problematic? (i.e. it stops in no time for a finger spin.)

Gyula
__________________
 
Reply With Quote