View Single Post
 
Old 03-26-2017, 10:14 PM
ET-Power's Avatar
ET-Power ET-Power is offline
Senior Member
 
Join Date: Feb 2017
Location: Republic of California
Posts: 92
BroMikey,

Your video above with the two Reed Switches was very helpful, thank you!

=================================================

TRIGGER COILS & SWITCHING

Please excuse my ignorance...

I have been into this for over a decade but only recently getting into the electronics and building systems myself...

Am I CORRECT with the belief that the hall sensor, opto isolator, and/or reed switch ARE NOT NECESSARY as long as there are transistors for the energizer coils?

Is some additional switching (opto/hall/reed) beyond the transistor required, or does it only add greater efficiency with more accurate/faster timing/switching?

Hoping to start out with just transistors and no additional switching but will experiment with reeds.

PLEASE ADVISE, THANK YOU! ! !
__________________
 

Last edited by ET-Power; 03-26-2017 at 10:15 PM. Reason: clarity
Reply With Quote