View Single Post
 
Old 03-26-2013, 08:47 AM
naxompax naxompax is offline
Junior Member
 
Join Date: Feb 2011
Posts: 3
I used these notes

I followed this schematic closely, and had good results. I ordered the parts from ebay. I got the hall effect sensors from mouser electronics. The link below is the link I used....plus I read the entire site on Bedini at fight 4 truth. The stator frame and rotor were created on a 3D printer. My earlier ones had various Shoestring approaches....ZZ bearings, wood frames....be careful with neos, I had some I kept in a closet they were so dangerous (someone got hurt everytime they came out of the closet) They need to be properly and securely fastened.

http://www.fight-4-truth.com/Bedini-...ow%20motor.doc

Nax
__________________
 
Reply With Quote