Thread: Bedini SG
View Single Post
Old 12-29-2007, 07:49 PM
elias's Avatar
elias elias is offline
Gold Member
Join Date: Sep 2007
Posts: 1,129


Thanks for the input,
Jetijs, my wheel does not free wheel so much, but it is because of its small rotor, The bearings are fine.
I think that the impedance of my wire is low (about 1 ohm), because when I put two of it filers series, the RPM increased (about 300RPM), and the current draw dropped to about 175mA. I wonder if this is normal. Maybe it is wiser to use a larger wheel.

I am going to do exactly that, Ill' wind a separate coil for the trigger, thanks. My magnets are glued together, and cannot be removed unless I break them .

Thanks Again,

Last edited by elias; 12-29-2007 at 08:04 PM.
Reply With Quote