Thread: Bedini SG
View Single Post
 
Old 11-08-2007, 10:59 PM
Aaron's Avatar
Aaron Aaron is offline
Co-Founder & Moderator
 
Join Date: Feb 2007
Location: Washington State
Posts: 11,005
tape motor schematic

Here is a schematic for the tape wheel motor.



The leads on the tape motor were already sticking out on really good pins.
For a muffin fan motor for example, you'd have to open it and free up the leads on each coil and route them out.

Schematic shows example of how to hook up either a battery on output or a cap...please don't confuse this that
I'm charging a battery one one output and a cap on the other.

This runs only clockwise as the induced current to trigger comes from the left side, which is connected to the base.

The bulb and pot I have are between the trigger wire and the resistor.
__________________
Sincerely,
Aaron Murakami


Last edited by Aaron; 11-08-2007 at 11:01 PM.
Reply With Quote